If the current through a 500 mF capacitor is given as i(t) = 2t +3, the voltage across the capacitor will be:O A. 1 VO B. t+ 1.5 VO C. 212 + 6t VO D. None of the choices are correctO E. 1000 V

Answered: Image /qna-images/answer/21bf8b41-5bbf-43cb-a4d2-196d9612a919.jpg

Answered: If the current through a 500 mF…

If the current through a 500 mF capacitor is given as i(t) = 2t +3, the voltage across the capacitor will be: %3D O A. 1 V B. t+ 1.5 V O C. 212 + 6t V D. None of the choices are correct O E. 1000 V

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: A two stage amplifier has an overall current gain of -100. If one of the stage has a voltage gain of…

A: As per company guidelines we can solve only first question kindly post another question separately

Q: 20. Determine the current I. а. 4.10A b. 2.14 A 3 kΩ C. 2.10 A 5A 2 kn 3 kΩ d. 1.14 A 3 kn 3 kN

Q: emperature coetticient of resistance of the conductor at 0°C? 0.00750 c. 0.00936 . 0.00625 d. 0.0208

A: Temperature coefficient of any resistive material is defined as the change of the value of…

Q: Q1. For the circuit given below, find IC and VCE. Given the values of R1, R2, RC, RE and B = 140 and…

Q: Sketch the DC load line for the voltage-divider bias circuit and place the Q-point on it. Q - pcint…

A: Brief description : BJT is known as bipolar junction transistor because of flow of current due to…

Q: The 110 W light bulb in Fig. 2.122 is rated at 110 volts. Calculate the value of V, to make the…

A: We need to find out voltage for given circuit

Q: 2- Discuss the advantages and disadvantages of the delta modulation compared to PCM. 3- What are the…

A: Answer 2) Advantages:- The circuit of DM is simpler compared to PCM. Bandwidth requirement will be…

Q: A cold junction of a themocouple is at room temperature of 83°C. A votmeter connected to the…

Q: The current in a 20 mH inductor has the waveform shown in Figure Q1(c). Draw the waveform for the…

A: We need to find out voltage across inductor

Q: A perfecty cenducting plane in locatl in free space at X=4 and aunitorm infiaite bire chapge ef 40…

A: Please refer the attached images for the complete answer..

Q: O a. Light-emitting diode • b. none of these c. Zener diode • d. Back diode

A: Given statement A blown-fuse visual indicator uses

Q: Problem 3. Consider a continuous time system H with input-output relation: y(t) = H{r(t)} =| r(T)dr.…

Q: Numerate the step-by-step procedure to obtain maximum equivalent resistance for the three resistors…

Q: Transfer function of a system is shown below. 16 3- G(s) 16s? + 8s + 16 a) Find natural frequency…

Q: the receiver side through the channel. In fact any multiplication process between any two signals…

A: Modulation of signal refer to the process off merging two signals of amplitudes or frequency with…

Q: 200U, looo rpm, 1o A Separately- excited de motor is fod from a single -phase full Converter with ac…

A: The solution is given below

Q: HW2: A solid cylindrical conductor of radius 5m carrying a current 10 A. The current is uniformly…

A: It is given that: r=5mI=10 A

Q: 4. What is the relationship between gain, feedback and Deviation?

Q: How many NAND gates are required for implementing the function C O a. None of the above O b. 6 Oc. 4

A: Given:

Q: 2.11. The normalized radiation intensity of a given antenna is given by (e)U=sin²0sin20 The…

A: The antenna problem can be solved by

Q: During the transient analysis of an RL circuit, if the current through an inductor is 1.5 A at t =…

A: The current through the inductor cannot change instantaneously. So the current at t =0 sec will be…

Q: Plot the magnitude and phase plot for the following transfer function, use the templates from the…

A: Given,The transfer function is,Hjω=10jω0.01jω+10.1jω+1Here,WE have to draw magnitude and phase…

Q: Q1. Given the fixed bias circuit with VCC = 12V, RB = 240 kN, RC = 2.2 kS and B = 75. Determine the…

Q: How many parallel paths does the armature of the generator have?

Q: Suppose R2 is a sensor whose resistance varies from SkQ to 10k0. Ve SV and R1 10KO. The maximum…

A: Given data, R1=10 kΩR2=5 kΩ to 10 kΩVs=5 V

Q: Determine the magnitude and angle of the voltages EAB , EBC, and ECA .

A: It is given that: Vab=16kV∠0°Vbc=16kV∠-120°Vca=16kV∠+120°

Q: A parallel RLC circuit has the following component values: R = 10 ohms, L = 2 H, and C= 5 mF, the…

A: The solution is given below

Q: What is the main objective of Tariff?

A: Since you have asked multiple question, we will solve the first question for you. If youwant any…

Q: voltage across the capacitor

Q: Y 2.

A: Here AND,OR gates are used. Properties of these gates are used to find out the output or the values…

Q: The device associated with voltage-controlled capacitance is a a. none of these b. Light-emitting…

A: Given, We have two mcqs. We have to find the answers for the those two. Please see below for the…

Q: If the current through a 100 mH inductor is given as i(t) = 2t +3, the voltage across the inductor…

Q: Question 1 Find the current, I which pass through 52 resistor by using Thevenin's equivalent…

A: In this question we have to find the value of current using thevenin theorem

Q: What are the values of Ib and Vc from the circuit shown below ? 20 22 kn 330 ka V-4 Vo B (1.2 k O a.…

Q: What would the resonant frequency of a Wien bridge circuit be if the resistors are 400 KN and…

Q: Q2) Find z transform for 1- X(n) = n? cosn©

A: It is given that: Xn=n2cosnθ

Q: Create Karnaugh Map

Q: a) What do you mean by adaptive protection? What functions are expected to be performed by an…

A: Adaptive protection The given protection utilizes settings for adjustable protective relay(ex-…

Q: Q2 A- Mention and explain 4 Electrical Hazards. B-Mention the steps in treating an Unconscious…

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a…

Q: Question 1 Find the current, I which pass through 52 resistor by using Thevenin's equivalent…

A: The solution is given below

Q: Find the differential equation that will represent the dynamic behaviour of the circuits given in…

Q: EXAMPLE 2 For the network in Fig. 6, determine the sinusoidal expression for the voltage v3 (using…

A: For the given network calculation of sinusoidal expression for Voltage V3 using superposition…

Q: HW1: let us determine H at P (4,0,5) in the field of an 6-A filamentary current directed inward from…

Q: 1. The engineering calculations for an 800-ampere service-entrance call for two 500 kcmil copper…

A: Given the two Copper conductors per phase connected in parallel Rating of service conductors = 800 A…

Q: If in an RL circuit, if the inductance, L, is increased by 20% and the resistance, R, is increased…

A: The solution is given below

Q: in www www

Q: In a 3-phase, 4-wire system, two phases have currents of 10A and 6 A in lagging power factors of 0.8…

A: In this question we need to find a current through neutral.

Q: Solve for i(t) for t > 0. The initial conditions are i (0) = 0 and V. (0) = 0.1V. t=0 1000 mH i(t)…

Q: In the circuit shown in Fig. 2.87, determine V, and the power absorbed by the 40-2 resistor. 62 20 Ω…

Q: What are the different media for wave propagation? Discuss the wave propagation in each media with…

A: Three types of the electromagnetic wave propagation mode, Ground wave propagation Space wave…

Question

If the current through a 500 mF capacitor is given as i(t) = 2t +3, the voltage across the capacitor will be:
O A. 1 V
O B. t+ 1.5 V
O C. 212 + 6t V
O D. None of the choices are correct
O E. 1000 V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
Which of the following is the capacitance of two 20-microfarad running capacitors connected in parallel? 10 microfarad 20 microfarad 30 microfarad 40 microfarad
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?