If the corona loss on a particular system at 50 Hz is 1 kW/phase/Km, then corona loss on the surface of the same system with supply frequency at 25 Hz will be-
Q: Verilen devrede L=35 mH C=60 microF, R1-60 ohm ve R2-48 ohm ise |f=110 Hz frekansında a-b…
A:
Q: Hˉ=3sin3xcos(10^9t−5z)aˉy, FindEˉ(t).Please explain all steps, thanks!(Need only handwritten…
A:
Q: R(s) V₁(s) Vo(s) G₁(s) H(s) V₂(3)+ Vy(x) Vy(x) G₂(s) H₂(x) Va(s): Vs(s) (8) A Gy(s) Hy(s) C(s)
A: Given Data: A block diagram representation of the system with, Reference input=Rs Controlled Output…
Q: Question 4: Determine the diode state and the values of I and VR for the circuit below, assuming…
A: Need to determine the diode state and the values of I and VR for the given circuit.
Q: 1. List the three categories of pollution that could occur as a result of your work activities:
A: Dear student, Since you have posted multiple questions, we will provide the solution only to the…
Q: Consider the active circuit with the schematic: a. Assuming it's an ideal op amp, derive the…
A: According to the question, for the circuit given below We need to find, a. Assuming it's an ideal…
Q: Why does offshore wind need a long transmission line? Why is HVAC used in offshore wind? What is…
A: Step-1-> Offshore wind farms are usually situated in deep oceans, far from the coast, where wind…
Q: 16.20 Find i(t) for t> 0 in the circuit of Fig. 16.43. 36 V (+ Figure 16.43 For Prob. 16.20. 10 92 M…
A:
Q: Problem seven Using Routh- Hurwitz array, to determine the range of K for a stable system. functions…
A:
Q: For the serial temperature sensor TC72. What are the corresponding temperature readings for the…
A: The TC72 is a digital temperature sensor that outputs temperature readings as 16-bit values. The…
Q: a. Assuming it's an ideal op amp, derive the circuit’s transfer function as a function of frequency,…
A: According to the question, for the circuit given below We need to find, a. Assuming it's an ideal…
Q: 3. Determine the output voltage (Vo) in each of the circuits below. Give reasons for your answer.
A: In the given questions, we need to analysis the diode based circuit. Also we need to check the…
Q: 6. A linear discrete-time system has transfer function H(z) = (Z+0.2)(z-0.8) a. Find the response of…
A: Given: A DT-LTI system transfer function, H(z)=zz+0.2z-0.8, To do: a) we have to find the response…
Q: The following problems refer to grounding requirements. 1. What is the minimum size copper grounding…
A: To find the minimum size copper grounding electrode conductor for a service with three sets of…
Q: Eight 10 AWG aluminum conductors with Type THWN insulation are installed in a single conduit. What…
A: To find the maximum current-carrying capacity of eight 10 AWG aluminum conductors with Type THWN…
Q: Draw the outputs Q1, Q2 AND X in the system given in the figure
A: For the given circuit the output of the D flipflop and the mux needs to be drawn based on the given…
Q: 2. The circuit shown below has been at rest with the switch open for a long time. At t = 0 the…
A:
Q: AC Grid Filter Bidirectional AC/DC Converter Bidirectional DC/DC Converter Unidirectional Power Flow…
A: The electrical architecture given above is for Electric Vehicle charging system, which consists of…
Q: - + 2(x²+z²)ay Let D = 4xyax + 4yza, nC/m² and evaluate surface integrals to find the total charge…
A:
Q: Sketch a low pass filter circuit
A:
Q: 10.a. Which of the following is a condition of the exception that allows the grounded conductor of…
A: identify correct option
Q: Section 5.7 Difference Amplifier 5.47 The circuit in Fig. 5.79 is for a difference amplifier. Find…
A: Given: V1 = 1 volt and V2 = 2 volt
Q: fin Vout W R₁ W R3 m R₂ Para el circuito mostrado determina la ganancia Vout/iin. Los valores de los…
A:
Q: Assuming k'n = 3k'p = 140μA/V², W/L =700, and VTh= 0.7 V Determine the current Ip in the following…
A:
Q: Q3/A shunt type ohmmeter uses a basic meter with a full scale current of 2mA and an internal…
A: Ohmmeter- An ohmmeter is an electrical device. It is used to measure resistance. its denoted by Ohm.…
Q: a) If a PI controller or Lag controller is added to a system, briefly explain what is intended in…
A: A PI controller is intended to reduce steady-state error in a control system. It achieves this by…
Q: Express the following expression in polar form 3√2/-45° 7-jl 5/+81.87° 4 - j3 + Not. Solve this…
A:
Q: Determine the rms value of the waveform in the given figure. v(t) 5 0 -5 1 2 3 4
A:
Q: 15.2 Find the exponential Fourier series for the signal shown in f(t) HUMA 10 8 6 4 2 +1 -
A: Given Data: A square wave with, Amplitude A=1 Time period T=4 s Range 0≤t≤4 To Find: Exponential…
Q: Determine the system apparent power
A: In this question, parallel connected load is given....We have to find out system apparent power
Q: Question 1 ig=12A(1 + Circuit-U #5 R₁=192 m A(3) R₂=292 + Vs=6V + V(4) A(5) A(7) + Vo + V8 A(9)
A: In this question, We need to determine the unknown parameters of the given circuit. We know As per…
Q: Find Va and ia for the circuit shown in Figure 2 A Va t=0 L = 2mH 0000 C 2 μF R= 25 92
A: Given: A network, To find: Va and ia.
Q: 1. Given a waveguide with a guiding axis, how do you identify the TEM, TE and TM modes of…
A: It is mentioned that if a waveguide with a guiding axis is provided, then how the TEM, TE and TM…
Q: Q1. Use the differential equation approach to find i(t) for t> 0 in the network in Fig. Q1. 12 V 1=0…
A: Given Circuit: To determine: i(t) for t>0
Q: 6. Determine the size of the C, for the following gas flow application. Q₂ = 960C₂ (P₁-P₂) (P₁+P₂)…
A:
Q: 3 Determine the Norton equivalent for this circuit: 4 cos(2001+30°) A 10 H 5 μF 3 ΚΩ a b
A: In this question we need to find the Norton equivalent circuit
Q: A. For the circuit below, determine the I³, Ic, Vc, VCÊ, VẼ and VB B = 120 +Vcc=1BV 39 K Ohms 8.2K…
A: BJT is three terminal active device. The biasing is done to obtain proper operating point. There…
Q: Let F(s) = [cs/ (s +a) (s + b) , where a=9.5, b= 3, c= 3.3 The inverse Laplace transform of…
A:
Q: Sketch the I-V characteristic curve for a real diode and label the main parameters and regions.
A: Sketch the I-V characteristic curve for a real diode and label the main parameters and regions.
Q: Clock CLR T
A:
Q: One can assemble a “virtual” solar cell array by using playing cards, or business or index cards, to…
A: Rating of one card is given as Voltage (V) equals to 0.5 V and current (I) equals to 2 A To produce…
Q: E I₁ R UL Left circuit: Right circuit: M R₂ L₂ 1₂ Z Give the voltage equations for the circuits.…
A: The voltage equations for mutually coupled circuits can be obtained by applying kirchhoff's voltage…
Q: For the power system below, find the average power for each of the loads, the average power for the…
A:
Q: Consider the active circuit: a. Assuming it's an ideal op amp, derive the circuit’s transfer…
A: The question is based on filter circuits.
Q: Using only the data given in Figure QB1c and showing all necessary steps, calculate the maximum…
A: As user has mentioned in the question, we will solve only part C of the question. According to the…
Q: What is the voltage across R4? (Answer in Volts) Answer in Volts. 1 33 3 55 R1 16 Ohms R8 28 Ohms…
A:
Q: (15 Points) Thévenin Equivalent: Obtain the Thévenin equivalent seen by the (2 − j) impedance of…
A:
Q: 8.4-4 For the oscillatur circuit shown (a) Find the frequency of oscillation. (b) What is the ratio…
A: In simple words, we can say that an electronic circuit that can generate the sinusoidal wave is said…
Q: such 7. In the circuit immediately below, if R₂ = 100 ohms, 14 W, what is the largest value of V…
A:
Q: 16.32 A periodic voltage having a period of 10 μs is given by the following Fourier series: 1 nπ Vg…
A:
Step by step
Solved in 3 steps
- What is the capacitance per kilometer per phase of a single circuit, two bundle conductor line with horizontal configuration? The distance between the bundled conductors is 30 cm and the diameter of each conductor is 5cm. The distance between the centers of the bundle is 5mChoices: 0.0132uF/km 0.0126 uF/km 0.0143uf/km 0.0116uF/km Please in typing format pleaseThe corona loss on a particular ac system of frequency 60 Hz is 2 kW/phase per km. The corona loss on the same system in case of DC transmission will be.The corona loss on a particular system at 50 Hz is 1 kW/km per phase. What is the corona loss at 60 Hz in kW/km per phase ?
- Determine the inductance per km per phase of a single circuit 460 KV line using two bundle conductors per phase as shown in the figure. The diameter of each conductor is 5 cm. 40cm 6.5m 6.5m 13mThe ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 42 feet. The per kilo feet inductive reactance will be: O A. 0.1537 B. 0.8117 O C. 0.1475 O D. 0.1148 O E. None of choices are correcti see thes answer, also graph for phase i think wrong, please can you check
- In the figure, a traveling voltage wave of 500 kV proceeds towards point A. Calculate the voltages and currents in the branches after the first reflection and transmission at point A.A three phase system with Dab Dbc one conductor per phase as shown in the figure. The conductors are stranded and spaced as shown, (Dab=Dbc=4m). The outside diameter of the phase conductor is 2cm. The GMR of the phase conductor is 0.7788 cm. The value of inductance per phase is: Select one: O a. (1.2445 * 10A-3) mH/km O b. (1.1559 * 10^-6) H/m O c. (1.4562 * 10A-6) H/m O d. (1.2945 * 10A-6) H/m O e. (1.2445 * 10A-6) H/mQuiz 1. Course 2nd QI. An equilateral transmission line has a total corona loss of 53 kW at 106 kV and a loss of 98 kW at 111 kV. What is the disruptive critical voltage? What is the corona loss at 115 kV?
- Calculate the inductance of the single-phase double circuit line shown in the figure, the diameter of each conductor is .2 cm d=2 cm 100 cm 100 cm-1- A single phase line has two parallel conductors 3m apart. The radius of each conductor is 1.2 cm. calculate the loop inductance per km of the line. 2- A single phase line has two parallel conductors 4m apart. The radius of each conductor is 2m. Calculate the capacitance per km of the line.3-phase double circuit line has its conductors at the vertices of a regular hexagon with side3.5 m. The diameter of each conductor is 2 cm. Find the inductance per phase per km.[0.596 mh]