If reflection coefficient = 0.15 and Intrinsic impedance n₁=20.5, then n₂=? (n=3.14154 and take the decimal part at least 3 digits in the operations) Answer: Ω
Q: Question 4 The magnitude of the vector A=4+8+62 is:
A: Given data, The vector, A→=4x^+8y^+6z^
Q: series type ohmmeter,
A:
Q: 23. For the voltage-divider configuration of Fig. 7.95, determine a. Ipo and VGS b. VD and Vs. 9 24…
A: We need to find out current and voltage for given circuit
Q: EXAMPLE 2.9 Find the transfer function for the network given in Figure 2.4(a). R₁ R₂ ņ 3 R₁ V₁ V,(s)…
A:
Q: CLK K Fig. 2. Master-Slave JK Flip Flop Q Q
A: The given logic diagram of master-slave JK flip flop is shown below:
Q: 10. A capacitor of 50 µF shunted across a non-inductive resistance of 100 Q is connected in series…
A: given here discription of a circcuit and asked to find the current through the shunted resistor.
Q: At room temperature (T= 300 K), the typical value of thermal voltage VT is: O a. 25 MV O b. 25 V O…
A: Thermal voltage VT=KTqK=1.38×10-23 m2 kg /s2 °kT= °kq=1.6×10-19
Q: Determine the phasor currents I, and 12 in the circuit of Fig 13.B. 50 129
A:
Q: Find the power rating of the heater and the current taken from the supply.
A: The energy is defined as the product of power and time. The power in electrical supply is obtained…
Q: Example: Convolution in the Laplace Domain Find y(t) given: h(t)=e, t20 0, t<0. f(t)=1, 0≤t≤2 0, 2<t…
A:
Q: 6. You have a complicated wire structure with an area of 1 cm², and an average interior magnetic…
A: Given data, Area, A=1 cm2 Magnetic field, B=10-9 T
Q: = cos¹0-707=45° Q/4! An inductive load of 1300 kw at 0.707 pif. is supplied by two alternators…
A: Inductive load absorbs reactive power Capacitive load delivers reactive power Alternator operating…
Q: Q-1. A 3 phase, 0.8 MVA, 3.3 kV, star - connected synchronous generator has 5 2/phase synchronous…
A:
Q: 14. 1+1=0 is an example of a logical — A. OR B. NAND C. NOT D. NOR statement.e 8 form is
A:
Q: 5. The ODE d²y dy dx² dx + - 2y = 0 has a general solution y(x) = C₁еx + С₂e−2x Determine the…
A:
Q: a) Correct any five of the following sentences using suitable scientific phrases. In series…
A: 5. a. 1. In series RLC circuit, at resonance Maximum Voltage obtained across resistor. At…
Q: Find the impedances between points B and D.
A: In this question, We need to calculate the equivalent impedance across the terminal B and D. We…
Q: 1- Determine the values of x, and y (5x+j10)(2-jy) = 90-170 2- At steady state, what is the current…
A:
Q: 9. Balanced A-load supply power is Y-load supply power. ******* 10. The PGen is always the maximum…
A: Delta connected system Line voltage=phase voltage Line current= 3 phase current star connected…
Q: P2 For the following circuit, calculate: a) The supply voltage, ET. b) The current in 202 resistor,…
A:
Q: Discuss in detail about recent technology used in tidal energy systems. List down at least three…
A: Tidal energy is a renewable source of energy that is derived from the natural rise and fall of ocean…
Q: ja A resistance R₁ of 5kr is shunted by conductance G of 50 μS. The combination draws a current of…
A: We need to find out resistance and conductance and current and voltage for given circuit
Q: Using voltage divider rule, find the unknown voltages across each element for the circuit shown.…
A:
Q: Q.3) The input voltage to a Full-wave rectifier employing a center tapped step-down transformer and…
A: For the above given circuit question we need to draw the full wave rectifier circuit with having…
Q: Determine the resistance and conductance of 20m of copper wire 2mm in diameter. P= 1-72 x10 S
A:
Q: 4. What are the advantages of FM? 15. What are the drawbacks of slope detector? 8. How FM wave can…
A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: Consider two amplifiers A, and A₂. The rise time for first stage is 0.3 ms and for the second stage…
A: Given data, To amplifiers A1 and A2 are cascaded. Rise time of first stage is tr1=0.3 ms Rise time…
Q: (1) Percentage voltage regulation at 0.8 lagging power factor. (2)Load angle at unity power factor.…
A: The synchronous generator converts mechanical energy into electrical energy. The induced emf is…
Q: K(s+1+j)(s+1-j). The root-locus is which of the 4) Consider the feedback system G(s) = - s(s +2j)(s…
A: 4) To find the Root locus of the given feedback system
Q: Q3) A single phase half bridge inverter has R=1002 and the de input voltage is Vdc =75v determine…
A:
Q: Find the current through 50 resistor using superposition theorem
A:
Q: >24v 57 E- - D 12 Sensor 0 Sensor 2 K2 8 08 If you're only allowed to pick one, from which column…
A: Ans :(B) (2) Column 2 must be removed to ensure for better protection scheme
Q: If the current running in the secondary winding of a transformer is 6 A, and the transformer has a…
A: Given, Current running in the secondary winding, Isecondary=6 A Transformer turns ration,…
Q: B) State the main points that should be taken in to account in selection of number and sizes of the…
A: B) The main points that should be taken into consideration while selecting the number and the sizes…
Q: 2. For the circuit shown in the figure below find the following a. Write the name of the…
A: We need to find out the current and voltage for given circuit and load line of given circuit
Q: Given the following open-loop transfer function: K(s + 0.2) G(s): s² (s +3.6) Find the number of…
A: Given data, Open loop transfer function, Gs=Ks+0.2s2s+3.6
Q: 12. List down activities in which you can conserve energy. 12. Which among the different types of…
A: Turn Off Lights and Electronics When You Aren't Using Them. Replace Traditional Light Bulbs with…
Q: *75 (II) (a) Calculate the bit-rate that would be required to address all of the 6 million subpixels…
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: 10. A capacitor of 50 µF shunted across a non-inductive resistance of 100 Q is connected in series…
A: When two impedance X and Y are connected in parallel then current through X and Y is given as'…
Q: Q3) Find the value of a signal at time of 1s, if the frequency is 1GHz, the amplitude is 2V, and the…
A:
Q: en * .Find the values of R and Vs in fig R ww gr 322 LA In R=2.1Q Vs = 12v R=2Q Vs 12v R=2.202 Vs…
A:
Q: HW: (a) Design a CMOS logic circuit that implements the logic function. f(A,B,C) = A + BC
A: Since you have posted multiple questions, we will solve the first question for you. If you require…
Q: Choose the suitable choice for the following sentences. ........ 6. LPF can pass frequencies 7. The…
A: In this question we will answers questions related to filter circuit and star connection current....…
Q: A 1202 resistor has a specified maximum Power dissipation of 1 w. Calculate the maximum current…
A:
Q: ) Obtain Fourier transform of signal e-lalt u(t).
A: By using the standard definition of the fourier transform we need to compute fourier transform of…
Q: Fig (2) B-Determine the resistance if 4-10¹6 electrons pass through the imaginary surface, the time…
A: B. The charge due to the given number of elections is, Q=nee=1.6×10-19 n=4×1016Q=4×1016×1.6×10-19…
Q: PAN is abbreviation of: O Private Area Network. O Personal Area Network. OPublic Area Network. O No…
A: We need to select correct option
Q: Computer with your help it can be taught to make decisions based on values contained in controls and…
A: Control variables in the control system Set point of control system Measured value Intermediate…
Q: For all problems, solve for the following a. Vgs b. Id C. Zin d. Zout e. Av H 0.05 µF IMO m 16V 3.9…
A: We need to find out current ,. Voltage, input and output impedance and voltage gain for given…
Q: 4) Consider the feedback system G(s) = K(s+1+j)(s+1-j). The root-locus is which of the s(s+2j)(s-2j)…
A:
Step by step
Solved in 2 steps
- Let's say you measure t1/2 to be 0.037 seconds and the resistance in the circuit is 68 Ohms. Then what is the capacitance in micro Farads? Answer in micro Farads.The current through a 15kohm resistor is given below, using Ohm’s Law to find the voltage, convert to polar form, complete the math, then convert back to the waveform at i1 = 3.5sin(2500t) mA and i2 = 2.3sin(200t – 60°) mAso then how is Rth 0.8695 kOhms in the original explanation?
- Solve thisthe topic is about : DELTA – WYE AND WYE –DELTA TRANSFORMATIONExplain the following 1. Diffrence between DC and AC Electricity. 2. how to convert rectangular form to polar form and polar form to rectangular form. 3. why need to improve a power factorFind loss tangent and dielectric constant
- How do I find the phase of this sinc function?Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…please help with this circuits problem
- L The thermoelectric effect is the direct conversion of tomperature differences to electric voitage and vice versa oloctric voltage to temperature differenc ii. The Seebeck offect is the build up of an electric potential across a temperature grodient. L. Tho Poltior offoct is tha prosonco of temmperaturo difforoncos at an oloctrifiod junction of two difforont conductors. Which of the definitions given abovo are correct about thermal properties of matorials?please answer asapp tyWhat's the rise time for this system with its closed-loop poles as shown? 14 -6 -4 12 -j6 Select one: a. 0.607 sec b. 3.14 sec C. 1.80 sec d. 0.254 seC e. 0.554 sec