If R1= 1 Ohm R2= 2 Ohm. Suppose R1 and R2 are connected SERIES. Then what is Equivalent (a)10 Ohms (b)1 Ohms (c)1/2 Ohms Resistance_____. (d) 3 Ohms

Q: Q2: For a (3-0) medium transmission line model (T cct) as shown in next figure, find the admittance,…

A: Given data are: The constants of the transmission line: A=D=0.861∠1° B=156.57∠78.35°…

Q: A buck-boost converter has an input voltage of 12 V and the duty ratio is adjusted to 0.5. What is…

A: Given: A buck-boost converter has, Input voltage, Vin=12 V. Duty ratio, D=0.5.

Q: 3) In the following circuit, find: 12 V 4 ΚΩ 6 ΚΩ 6V 6 mA a) I, using nodal analysis b) The voltage…

A: Given circuit, Marking all the nodes,

Q: 14. A 110-V household circuit that contains an 1800-W microwave, a 1000-W toaster, and an 800-W…

A: Given: Voltage = 110vload = 1800W and 1000W and 800W Fuse Current Rating = 20amp. Find: Will fuse…

Q: Q4) An LTI system is characterized by the differential equation below: d² z y(t)+5 = y(t)+6y(t) =…

A: NOTE: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts…

Q: Calculate the output voltage for the circuit of the circuit given for an input of Vi=3.5 mV rms. 180…

A: We need to find out the output voltage for given inverting amplifier . We know formula for output…

Q: A wire measuring 1.5 m3 has a resistance of 0.955 mW at 20°C; its length is 1.5 m and an area of 1.5…

A:

Q: The figure shows a 4 to 1 MUX to be used to implement the sum S of a 1-bit full adder with input…

A: Solution !!

Q: If V₁ = 17 V₁ V₂ = 5 V and V3 = -7 V, the voltage Vo (in volts) is + V/₁- Vo O-29 015 O-15 O-19 029…

A:

Q: 03: For class AB amplifier the R.M.S. input voltage is IIV and the supply voltage is +20V and the…

A:

Q: You are given an RC coupled amplifier having low frequency. The internal voltage gain is -120.…

A: Gain is the scientific name for an amplifier's output-to input magnitude ratio. Gain is a unitless…

Q: Solve the question: An FSK system is transmitting signal at 4000 bps using half duplex transmission…

A: Given: Rb=4000 bps and fc1-fc2=6000 Hz. Required: Bandwidth and Deviation

Q: What is the number of overall systems?

A: SOLUTION If we talk in reference of ELECTRICAL CONTROL SYSTEM there…

Q: Calculate the equivalent admittance Y, for the network in Fig. the current I if Vs = 60/45° V.…

A:

Q: A generator develops 200 V and has an internal resistance of 100 a Find the power delivered to a…

A: According to question, Generated Voltage, E=200V Internal voltage, Ri=100 ohm RL=100 ohm

Q: 1. Use Wye to Delta Transformation to solve for I. 50Ω www 5Ω 55V Milt V = 21 V Μ 30Ω · 4Ω 20Ω 2.…

A:

Q: 15. Calculate V, in the circuit of Fig. 10.74 +25 mV -20 mV 15 km2 ww 30 102 m 600 k FIG. 10.74…

A:

Q: AIM: To write a program to arrange an array of data in ascending order ALGORITHM: 1. Initialize HI.…

A: Solution !!

Q: An electric motor with a maximum output of 75 hp (horse power, English: hp, horse power) on the axle…

A: Given data, Motor:-1 Power P1=45 HP Efficiency,  η1=91%=0.91 Motor:-2 Power  P2=75 HP Efficiency,…

Q: Divide the following two FP numbers using IEEE 754 BFP division algori A = (45) 10 B= (30) 10

A:

Q: parte A • Develop and explain the electrical schematic for the excitation coil in series. • Develop…

A: It is asked to develop and explain the electrical schematic for the excitation coil in series and in…

Q: Design the phase shift oscillator to oscillate at f=22.5kHz. the minimum resistance to be used is…

A: We need to design the given circuit , we need to find out the value of unknown resistor and…

Q: If V₁ = 17 V₁ V₂ = 5 V and V3 = -7 V, the voltage Vo (in volts) is V₁ - Vo + V3- V₂

A: Given, The circuit is, The voltages V1=17 V, V2=5 V, V3=-7 V.

Q: 3. Determine the current i, through the 20-f resistor. 3A 1292 ww 4592 2012: www 3692

A: Given data, Circuit diagram is given as,

Q: Could you please tell me the meaning of Y and how you used it to find the impedance?

A: In this question we need to find the impedance of the complete circuit. In this circuit elements are…

Q: 3. The open loop transfer function of a unity feedback system is given by G(s) = k (s+2)(s+3)…

A: Q.3 : The open loop transfer function of a unity feedback system is given by : Gs=ks+2s+3…

Q: 4. Determine V₁ and V₂ using nodal analysis. Show complete solution using either elimination…

A: The question is about finding node voltages V1 and V2 using nodal analysis.

Q: Problem A parallel-plate capacitor has an area A = 2.15 x 10-4 m² and a plate separation d = 1.95…

A: Given, In a parallel plate capacitor, Area of plates, A=2.15×10-4 m2. Plate separation, d=1.95 mm.

Q: Consider the system below: Load X ZKX Y Capacity [MW] 51 248 201 B Generator X1-3 = 0.4 p.u. PMAX…

A:

Q:

A: It is given that:

Q: Q- A single-phase half-controlled rectifier is driving a separately excited dc motor. The dc motor…

A: Given- Back emf constant = 0.5 V/rpm , Armature current (I) = 5A , firing angle α =30°.   To find -…

Q: 4. 8 16 ritr ·16 22 15 7 Find V2352 ≥23

A: Since you had asked to solve q4 only so we will solve that question only.Solution 4: The network is…

Q: ● After the SCR had been triggered, what is the minimum resistance R to keep the SCR in conduction…

A:

Q: Solve for the current through the load with FBD.

A: In this question,  We need to determine the current in the load.  We know, capacitive Reactance Xc =…

Q: • If the DIAC conduct at 35 degree on the positive cycle, What will be the starting angle of its…

A: DIAC: DIAC stands diode for the alternating current. It is used to provide the triggering pulse to…

Q: Use an ideal plus voltage drop model. +10 V Vin OV -10 V 3V 1.0 ΚΩ Vout

A:

Q: 1. Consider the circuit below. Using operator notation for derivatives, write down a matrix equation…

A: The circuit is given as Apply KCL at node a,is-i1-i2=0    ...1Apply KCL at node b,i2+i4-i5=0…

Q: Q2) a) Determine the differential equation that relates the input current x(t) with the output…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Determine the approximate value of IDss of the given circuit below. 1ΜΩ 9.82 mA 7.18 MA 8.33 mA 10…

A:

Q: B: A three phase transmission line with 65 km long, 50 Hz. Each phase has a conductor of 0.83 cm as…

A:

Q: B- Find the minimum sampling rate required to multiplexing two signal waveforms if the time spacing…

A: Given Time specing between adjacent sample in the time multiplexed signal TS = 0.0625 msec

Q: An 6-pole 230 V d.c. shunt generator with 1,264 armature conductors and running at 1200 r.p.m.…

A: In this question,  We need to determine the flux in Maxwell.  We know  1wb = 108  Maxwell We are…

Q: A 3 Bus network is shown. Consider generators as ideal voltage sources. If rows 1, 2 and 3 of the…

A:

Q: A buck regulator has an input voltage of 12 V and the required output voltage is 5 V. What is the…

A: Given, A buck converter has, Input voltage, Vin=12 V. Required output, V0=5 V.

Q: The voltage gain (Av,dB) of an amplifier is -26 dB, what is the voltage gain (Av) in V/V? The power…

A: SOLUTION GIVEN-->                   (Av)dB = -26                  (…

Q: Write 8086 Assembly language program to sort in descending order of the elements in a given array,…

A: Flow chart

Q: A 12 V battery is connected across a load having a resistance of 40 Ω.Determine the current flowing…

A:

Q: 5 kN 7 kN 30° 70° 1. Assuming the resultant force is zero, if F₂= 6 kN, determine the magnitude of…

A:

Q: 4 22:48 O 4G 4G n Vol 1 LTE 2 100 X Solve your answers in 4 decimal places. Kindly send in PDF form.…

A:

Q: A 3 Bus network is shown. Consider generators as ideal voltage sources. If rows 1, 2 and 3 of the…

A: Solution !!

Current Division Method

The generalized current divider formula is given by the following relation below,