If an electric motor is using 50 kW of power and operating at 1500 rpm, what is the output torque? Assume the motor is 100% efficient. If this same motor is attached to a 20:1 reducer, what will be the output torque from the reducer? Assume the reducer is 100% efficient.

If an electric motor is using 50 kW of power and operating at 1500 rpm, what is the output torque? Assume the motor is 100% efficient. If this same motor is attached to a 20:1 reducer, what will be the output torque from the reducer? Assume the reducer is 100% efficient.

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter23: Faraday’s Law And Inductance

Section23.2: Motional Emf

Problem 23.4QQ

See similar textbooks

Related questions

Q: Calculate the rotational inertia of a wheel that has a kinetic energy of 18.5 kJ when rotating at…

A: Answer

Q: A car is designed to get its energy from a rotating flywheel with a radius of 1.50 m and a mass of…

A: Write the given values of the problem- Radius(r)=1.50 m Mass(m)=445 kg f=5750 rev/min

Q: The figure below shows, at left, a solid wheel of radius R = 0.600 m and mass 75.0 kg. Mounted…

Q: An electric motor turns a flywheel through a drive belt that joins a pulley on the motor and a…

A: Given: The mass of flywheel is m=79 kg. The radius of flywheel is r=0.625 m. The radius of pulley…

Q: A small disk of radius R is mounted coaxially with a larger disk of radius R2. The disks are…

A: Given: Radius of small disk = R1Radius of large disk = R2Total rotational inertia of disks = IMass…

Q: An electric motor turns a flywheel through a drive belt that joins a pulley on the motor and a…

Q: Convert 220 rad into revolutions (rev). Give the result in the nearest whole number.

Q: idly attached to the flywheel as shown in the figure below. The flywheel is a solid disk with a mass…

A: GivenMass of solid disk, M = 80 kgRadius of solid disk, R=0.625 mRadius of smaller disk, r = 0.230 m…

Q: R mo m The figure shows a pulley of mass mo that is modelled as a disk of radius R. It is fixed in…

Q: As shown in the figure, a disk of mass m = 200 grams is placed on a rotating turntable so that the…

A: According to question--- Given data -- Mass of disk (m)= 200 g. Radius of disk = 70 cm. Hanging…

Q: The power of a bus engine is transmitted using the belt-and-pulley arrangement shown. The engine…

A: Relation between linear speed and angular velocity is given by v=rw

Q: An automobile crankshaft transfers energy from the engine to the axle at the rate of 128 kW when…

A: The power transfers from the engine to the axle,

Q: Find the tension in the lower (slack) segment of the belt.

A: The equation for torque can be given as The moment of inertia of the flywheel can be given as The…

Q: An electric motor is used to drive the shaft of a small water pumpm. During a performance test, the…

Q: A cylindrical wheel of uniform density with mass M=11kg and radius R= 2m rolls without slipping on…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: A person bends forward to lift a load with his back. To see that this is not a good way to lift, we…

A: We need to calculate the magnitude of force R at the base of the spine.

Q: A wheel had a radius of .51m and a inter ya of 14.8kg•m^2 rotating around 56 rev/min. The wheel…

A: radius r= .51m inertia= 14.8kg•m^2 angular velocity, w= 56 revminute=2π×5660=5.86 rad/s time taken…

Q: An electric motor turns a flywheel through a drive belt that joins a pulley on the motor and a…

A: The given values are, M=81.0 kgR=0.625 mr=0.230 mTu=142 Nα=1.67 rad/s2I=12MR2=1281.0 kg0.625…

Q: When a carpenter shuts off his circular saw, the 10.0-inch-diameter blade slows from 4148 rpm to…

Q: A bicycle racer is going downhill at 12.0 m/s when, to his horror, one of his 2.45-kg wheels comes…

A: Mass of the wheel =2.45 kg Diameter of the wheel = 85.0 cm =0.85 m Initial speed of the wheel = 12…

Q: The spin cycle of a clothes washer extracts the water in clothing by greatly increasing the water's…

A: angular speed of water is ω=2π601250 rpmrad/s=130.89nrad/s

Q: Save 18NF 16NF Carriage Frame NOTE: THREADS ARE RIGHT HAND HELIX If the handle of the linear…

A: Number of rotations of handle = 15 (clockwise) Threads per inch in screw 1, TPI1=16 Threads per inch…

Q: An electric motor is used to drive the shaft of a small water pump During a performance test, the…

Q: 117. One wheel has a diameter of 30 inches and a second wheel has a diameter of 20 inches. The first…

A: Given data: Diameter of first wheel, d1=30 in Diameter of second wheel, d2=20 in Number of…

Q: How much mechanical energy is there in a 90.0 kg footballer whose center of gravity is 90.0 cm high…

A: Given Mass of football is m=90.0 kg Acceleration due to gravity is g=9.80 m/s2. Height is h=0.90 m…

Q: The motor of a table saw is rotating at 3450 rev/min. A pulley attached to the motor shaft drives a…

Q: The figure below shows, at left, a solid disk of radius R = 0.600 m and mass 75.0 kg. Mounted…

Q: While exploring the wooded areas by York University, a student found a mysterious hatch with a…

Q: A ceiling fan with 89-cmcm-diameter blades is turning at 70 rpmrpm . Suppose the fan coasts to a…

Q: When turning on a motor, it reaches a nominal speed of 2,500 rpm in a time of 12 s; when the motor…

A: Apply the first angular kinematic equation. Apply the second kinematic equation.

Q: The figure below shows, at left, a solid disk of radius R = 0.700 m and mass 75.0 kg. Tu Mounted…

Q: Suppose that a motor can deliver 50 in-lb of torque at a speed of 750 rpm. The motor is outfitted…

A: The given values are, τm=50 in·lbωm=750 rpmdm=3"dp=8"ωp=?τp=?

Q: A copper disk with moment of inertia I is mounted on a fixed, frictionless axle. The angular speed…

A: Rotational Power is equal to the net torque multiplied by the moment of inertia of the system.…

Q: Two identical balls, A and B, are each attached to very lightstring, and each string is wrapped…

A: Suppose two identical balls (A) and (B) are each attached to a very light string & each string…

Q: An electric motor turns a flywheel through a drive belt that joins a pulley on the motor and a…

A: Given data mass of flywheel m = 80.0kg radius of flywheel R = 0.625m radius of pulley n = 0.230m…

Q: The ring gear is fixed and the center gear rotates at 120 rpm in the counterclockwise direction.…

A: For a gear the Mechanical advantage is given by MA =ω1ω2=r2r1=N2N1 where ω1, r1, N1are the angular…

Q: An electric motor is used to drive the shaft of a small water pump. During a performance test, the…

Q: A torque of 170 N.m does 4602 J of work on a rotating flywheel. If the flywheels initial kinetic…

A: Given Work done W=4602J Initial kinetic energy Ki=1289J

Q: Calculate the angular speed, in rads of a flywheel turning at 750.0rpm

A: Flywheel is rotating at 750 RPM

Q: Calculate the rotational inertia of a wheel that has a kinetic energy of 33.2 kJ when rotating at…

A: The given values are,

Q: he turntable in a microwave oven has a moment of inertia of 0.040 kg⋅m2 and is rotating once every…

A: Given, Moment of inertia of turntable in a microwave oven , I = 0.040 kgm2 Angular speed ,ω= 2π…

Q: Discuss why the differences in peak torque and average power between the two speeds 60 and 180°/sec…

A: The relation between power and torque is that P=τ ω , where P is the power , τ is the torque acting…

Q: An electric motor is used to drive the shaft of a small water pump. During a performance test, the…

A: Given, Torque on the motor shaft, τ = 5.408 N.m Electric power, P = 519.74 W

Question

100%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A power plant serves a factory having two 22-Kw motors and ten 3.7-Kw motors. Assume the efficiency of motors 80%, of transmission line 95%, of generator 92%. What should the rated capacity of the generator be if it is assumed that all motors might be delivering their rated power simultaneously? What should be the rated capacity of the engine? 106.579 Kw 115.848KW 200.11 Kw, 251.2 Kw 106.579 Kw, 115.848Kw
Problem 8 : 8kW is found by the Two-Wattmeter Method to be the power input to a 3-phase Motor. Determine the reading of each wattmeter if the Power Factor of the system is 0.85.
e. Calculate the total energy dissipated in the loop during the first 6 seconds.
What is the ratio of the revolutions per minute for the motor to the revolutionsper minute for the compressor?
A person in good physical condition can put out 100 W of useful power for several hours at a stretch, perhaps by pedaling a mechanism that drives an electric generator. Neglecting any problems of generator efficiency and practical considerations such as resting time: (a) How many people would it take to run a 4.00-kW electric clothes dryer? (b) How many people would it take to replace a large electric power plant that generates 800 MW?
A student claims when they use their space heater and hairdryer at the same time, the power for the entire house goes out. A second student says that it is not possible for the use of those two items to affect the power to the entire house. why it is beneficial for power to go off in some situations. how power could be restored.
Why is the answer not approx 0.58 kWh as P = (0.2)(120) = 24 W = 0.024 kW and if E = P*t then E = 0.024 kW * 24 h = 0.58 kWh? Is this not the correct answer? The solution above multiples 24 by 60? Why?
Calculate the power in SI unit.
5. (a) Calculate the torque exerted on the square loop shown below, due to the circular loop (assume r is much larger than a or b). Also determine the net force on the square loop. (b) The square loop now points in the direction that minimizes its potential energy. (This is its equilibrium orientation.) What are the torque and net force on the square loop now?
A water jet consumes 3150 W for 126 hours a week. what is the energy consumed (kWh) for one-year period? what is the utility energy charge for this period at rate of ₱750?kWh? what is the energy cost savings for this period if the water jet is switched off 5 hours a day?1 year=365.25 days
1 kw = (1000 joules / sec) and 1 kwh = 3.6 x 10^6 joules %3D %3D True O False
The generator of a car idling at 1.582E+3 rpm produces 15.3 V. What will the output be at a rotation speed of 2.886E+3 rpm, assuming nothing else changes? Answer in units of V.