If a 17.0k resistor, a 7.3k2 resistor and a 27.2k2 resistor are all connected in parallel, then what is the total resistance of this parallel combination in kilohms? Answer: Check

Q: Determine if the following circuit is overdamped, critically damped, or and then determine the…

A: Given data Supply voltage; V=2 V L=5 H C=80 μF R=100 Ω To find out We have to determine the nature…

Q: For the circuit below, the Thevenin impedance at terminals a-b is: 1Ω 5 cost V Μ Ο 1 Ω Ο 0.5 – j0.5…

A:

Q: K2 K13 ele K4 M K3

A: Given Data: A mechanical Translational system with, Spring and Mass To Find:  A new graphical…

Q: Please show all steps clearly, thank you.

A:

Q: Problem 8. A coil of copper wire has a resistance of 100 2 when its temperature is 0°C. Determine…

A: Resistance of copper wire at 0°C is R0=100 Ω. Temperature coefficient of resistance of copper at 0°C…

Q: For the system given in the figure on the right-hand side, where the input is four-unit step, r(t) =…

A:

Q: Please help me make these two circuits on TinkerCAD. Not understanding how to do it

A: Need to explain how the circuit can be designed in the tinker CAD software.

Q: 1. Vs ∞ 452 + = 1/80F Чл ½80F The Circuit above has no peaks between 0+ ({> Y√z). Solve for the…

A: VS - input voltage  VO - output voltage

Q: Find the complex power for the following:    Vrms= 200 ∠ 30∘   V, Z= 40+ j60   Ω in addition form

A: voltage  Vrms = 200 ∠30°  V impedance Z = 40+j60 Ω

Q: R(s) G6 G₁ G₂ H₁ H₂ G3 G5 G4 C(=

A: Given Data: A block diagram model of a system having, Input =Rs Output =Cs To Find: Block diagram…

Q: 3. Explain why a TE incident wave on a material does not have a Brewster angle.

A: We need to explain why a TE incident wave on a material does not have a Brewster angle.

Q: Problem 6 Consider the following system. xn] → ~*~* →y[n] Give the real expression of its impulse…

A:

Q: 4V 5V Determine the current i 1V 47 Ω www www ΖΩ 3V

A:

Q: 4. Fill in the missing parameter values for the BJT in the table below: Ic 10 μα 100 μα 50 μα 10 mA…

A:

Q: Find and Graph 12V + Graph Vc (t) t=0 ww 322 0.5F 42 252

A: We need to plot Vc(t) using Laplace transform for the given Circuit

Q: Sketch a typical displacement versus time response for an under-damped oscillator that is driven by…

A: According to the question, we need to sketch a typical displacement versus time response for an…

Q: In a mesh network, each individual node has its own configuration of Multipoint connections.

A: Yes, correct. The given statement is True. In a mesh network, each individual node has its own…

Q: Prove the CFL condition is the stability required when the Lax-Wendroff method is applied to solve…

A: Prove that the CFL condition is the stability requirement when the Lax-Wendorff method is applied to…

Q: Pt = Pt = P+ = Pt Pr G+ x Gr > (4nd)² 1x106 (00X100 x/0.112 1x 10-6 4X3.14 X 600² 10000 x 0.1…

A:

Q: Find the Fourier representation of 31 2 콘

A:

Q: You are requested to design an automotive suspension or shock absorber system. In order to simplify…

A: The value of the system components are M1=2500kg,M2=320kg,K1=80000 Nm,K2=500000 Nm,B=350 N-sm.

Q: (9) If the main objective is to improve the BER performance, which of the following two modulation…

A: Binary coherent FSK with Ebη=12 dB. Binary non-coherent FSK with Ebη=14 dB.

Q: 12V 52 mig t-os + Vc 10mF 40mF W 251

A: Given Circuit:     To determine: Capacitor voltage VC after switch is opened at t=0

Q: IMPORTANCE OF POWER FACTOR j0.50 0.05Ω + 250Z0°V Load 1 P = 8 kW @ 0.8 lead Compute for the…

A: total load is  S = 20000+j10000 VA  = 20 + j 10 KVA       ( active power (P) + j (reactive power…

Q: The circuit shown in (Figure 1) has been in operation for a long time. At t = 0, the source voltage…

A: Given Data: A Transient RLC series circuit with, DC voltage source, Vdc=200 V at t<0 Vdc=100 V…

Q: 35 V Το 2.5 Ω Req 12 Ω 6Ω 15 Ω 60 Ω 20Ω 80 Ω

A: The circuit diagram,

Q: Assume the passive sign convention. Consider the current waveform. i(0) (A) 2 10 1 2 3 -r(s)…

A: We need to find out Voltage across capacitor for given current through capacitor.

Q: Calculate the input bias currents at the non-inverting and inverting terminal respectively of an…

A: It is given that: IIO=5 nAIIB=30 nA

Q: 2. A unity gain feedback system has the open loop transfer function given by K G(s) = (s+3)(s+6)…

A:

Q: Please help me with this. I am not understanding it 1) Mkae the circuit shown in the image below on…

A: Need to design the circuit in tinker CAD and obtain the truth table. The logic function needs to be…

Q: Compute the capacitance of (i) parallel plates with plate width w = 2.0 (m), length 1 unit and…

A:

Q: For the network below. R3 R1 ww 129 VRIF VR2= VR3 Find the voltage across and the current through…

A:

Q: 1. Assume that the source voltage for the D-MOSFET in the following figure is measured and found to…

A: Given data Source voltage; VS=1.6 V gm=200 μmho VDD=24 V To find out We have to determine the ID…

Q: A three phase 50MVA, 10kV cylindrical rotor generator has armature resistance of 0.1pu  and…

A: The rated MVA of the generator, Srated=50 MVA The terminal voltage of the generator, VT=10 kV The…

Q: (S-1)(s+3) 1- The transfer function of the system given as T(s) = (s+1)(s²+3s+2) a. Draw the…

A: In this question we need to find the following Draw pole-zero plot and determine system stability…

Q: 1. Find the Fourier transform for the following waveform (please show your work). w(t) = 211(²4) +…

A:

Q: An inductive load connected to 120V, 60Hz ac source draws 1kW at a power factor of 0.8. Calculate…

A: Preal= 1 KW     cosϕ1=0.8ϕ1=cos-10.8ϕ1'=36.86°cosϕ2=0.87ϕ2=cos-10.87ϕ2=29.84°

Q: Determine the capacitor required to be connected in parallel with the motor so that the power factor…

A:

Q: 1-12 Find the voltages V₁ and V₂ in Fig. 1-4d:

A: Circuit diagram is given as,

Q: 2. In picture below, the sine wave has a period of T=5ms and the voltage peak value is 25V. a.…

A: As per the company guidelines answer to the first three subparts can be given, please post the next…

Q: 10 кл 16 V 12 кл B=120 15 кл 12 V Determine: Ic b. Vce C. Vec el. Iccat e. Vo

A:

Q: Determine the output waveform from the given circuit and input waveform. a) b) -10 10 c) 8 d) ひ。 -6…

A: We need to find out the output waveform for the given circuit.

Q: For the given circuit and input waveform determine the output waveform. a. b. C. V₁ 15 20 -10 d. -5…

A: As per Bartleby guidelines we are supposed to answer only one question at a time, so please post…

Q: ADD, SUBTRACT, MULTIPLY, DIVIDE THE SIGNALS AND GRAPH THE RESULT

A: According to the question, for the given signals as shown below, we need to perform addition,…

Q: A voltage divider like that in the figure is to be designed so that v, = kv, at no load (R₁ = ∞) and…

A:

Q: Q2. What is the voltage drop across R1 at t = 5 seconds? +1 V1 20cos(50t + TT/6) D3 700 mV D1 OV D2…

A: We need to determine the voltage drop across the resistor R1 at t= 5 seconds.

Q: What would be the minimum radar cross-section detectable for a millimetre wave radar system, where:…

A: According to the question, we need to find be the minimum radar cross-section detectable for a…

Q: The block diagram of the speed control of an HEV is shown in figure 2. Assume Gsc(s) =Kpsc, find the…

A:

Q: FIGURE 7-74 6. Determine the output of a gated D latch for the inputs in Figure 7-75. FIGURE 7-75 EN

A:

Q: R Vc p-p (Calculated) = VR p-p (Calculated) = www 680 Ω + Uc Figure 1. Series AC R-C Circuit. 0.22…

A: In this question,  We need to determine the voltage across the capacitor and resistance.  We know…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.