If 60MHz of total spectrum is allocated for a duplex wireless cellular system and each simplex channel has 15kHz RF bandwidth, find: (a) The number of duplex channels (5) (5) (10) 4 (b) The total of channels per cell site, if i=3 and j = 3 cell reuse is used. Repeat the above using TDD. Find the system capacity (C) for the reuse cell, if N is replicated (M) is 5.

Q: 20) If 60MHZ of total spectrum is allocated for a duplex wireless cellular system and each simplex…

A: The Answer is in Below Steps

Q: Assume that in a gNB there will be 100 subscribers at 5Mbps 200 subscribers at 1Mbps…

A: ANSWER: Aggregated Downlink Throughput:

Q: Q1) A city has an area of 1300 square miles and is covered by cellular system using a 7 cell reuse…

A: cell radius is =4 a)formula to calculate the area of cell is=2.5981 x radius x radius…

Q: In the communication in the figure For Link 1; Bandwidth 150 Mbps                   Line Length 5 km…

A: propagation delay = packet size/ bandwidth LINK 1 propagation delay  for link 1=  4000 bit / 150*…

Q: Question #4: Consider the following circuit-switched network, and answer the questions below 14…

A: Introduction: Circuit Switched Network: The process of moving the data packets towards their…

Q: If 60MHz of total spectrum is allocated for a duplex wireless cellular system and each simplex…

A: Actually, given information If 60MHz of total spectrum is allocated for a duplex wireless cellular…

Q: Assume that the bandwidth of the telephone line for data transmission can be up to 56,000 bps, Thus…

A: The question is on calculating capacity of data that can be sent through the telephone line with the…

Q: (a)  Uplink frequencies are higher than downlink frequencies in satellite communication, whereas…

A: a). Satellite communication (satcomm) and Mobile communication (mobcomm). In satcomm: downlink is a…

Q: Given the same 4-link network, OD flow rate of 9, and link travel time functions, use incremental…

A:

Q: You have the RNN defined by the following equations and weight matrices hi = tanh(Whhhy-1+ Wzht) %3D…

A: Answer: I have given answer in the handwritten format

Q: Consider a 2 user CDMA wireless communication system with P, (dB) = P, (dB) jn = 15 dB. Given noise…

A: Answer 1) SNR(signal to noise ratio)= signal power/ noise power SNR(in dB)= 10 log10 (signal power/…

Q: Consider the network shown below. Using Bellman-Ford algorithm, and showing your work using a table…

A: Bellman ford algorithm :-                              take the routers in a…

Q: a) show all cell that are co-channel cells with cell x if GSM technology is used with a reuse factor…

A:

Q: Using Dijkstra’s algorithm, and showing your work using a table similar to Table 4.3, do the…

A:

Q: Consider the throughput example. Now suppose that there are 4 client-server pairs. Denote Rs1, Rs2,…

A:

Q: Find the average buffer occupancy, in messages, at the outgoing link of a concentrator for the…

A: Answer :-

Q: 5. Consider the network shown below, and assume that each node initially knows the costs to each of…

A: Distance-Vector Routing algorithm: • Distance-Vector algorithm is iterative, asynchronous and…

Q: Two computers A and B are connected through an Ethernet link having a bit-rate of 10 Mbit/s. The…

A: Bit rate 10 mbps 1024 *1024 bits per second RTT is 4 milli seconds 300 octets meas 300*8=2400bits of…

Q: A Telecom operator has been assigned the bandwidth from 2100MHZ to 2105MHz, this can support 100…

A: Given information: - Bandwidth range-2100MHz to 2105MHzUtilized Bandwidth=2105-2100=5MHzInterchannel…

Q: 36. For n devices in a network, ____ , number of duplex-mode links are required, for a mesh…

A: given :            mesh topology            duplex mode            n devices    In mesh topology ,…

Q: Assume a system of 32 cells with a cell radius of 1.6 km, a total of 32 cells, a total frequency…

A: A handoff refers to the process of transferring an active call or data session from one cell in a…

Q: Based on the following graph, describe the four-way handshake in IEEE 802.1X. 802.11 AP MAC…

A: The 4-way handshake is the process of exchanging 4 messages between an access point (authenticator)…

Q: A Telecom operator has been assigned the bandwidth from 2100MHZ to 2105MHZ, this can support 100…

A: The given data is below:  bandwidth range = 2100MHZ to 2105MHz So, we can find the utilized…

Q: Using the below network architecture, find and write the following   a. Shortest Path and its cost…

A: Note - it is not given that all vertex needs to be visited to reach from source node to destination…

Q: Choose the correct statment(s) from the following. A. It is possible to design a broadcast…

A: The statements given to choose which is correct:- If it is possible to design a broadcast algorithm…

Q: Question 4 In a wireless access gateway, measurements have shown that the packets arrive at a mean…

A: The expected rate or less or the expected number of packets that are lost per million=0.0112/ wery…

Q: A Telecom operator ha

A:

Q: Assume a system of 32 cells with a cell radius of 1.6 km, a total of 32 cells, a total frequency…

A: Here, I have to provide a solution to the above question.

Q: P7. Consider the network fragment shown below. x has only two attached neighbors, w and y. w has a…

A:

Q: A Telecom operator has been assigned the bandwidth from 2100MHZ to 2105MHz, this can support 100…

A: The given bandwidth range: 2100MHZ to 2105MHz so the utilised bandwidth = 2105 - 2100 = 5MHz . Let…

Q: 2.2 Consider a wireless network. For each of the following cases, state whether the packet…

A: Explanation is provided  below  for transmission would successful or not in give. Conditions

Q: b. A GSM system uses 124 channels and each channel is divided into 8 time slots. What is the maximum…

A: Multiple access systems: This system is used to allow multiple mobile users to share a finite…

Q: P17. In Figure 5.13 , consider the path information that reaches stub networks W, X, and Y. Based on…

A: Given: The path information that reaches stub networks W, X, and Y. It is done by based on the…

Q: 5 points  Find the latency of Token Ring (in bits) where data rate of link is 20 Mbps and 40…

A:

Q: Messages are sent over a communications channel using two different signals. One signal requires 1…

A: Problem Statement: Messages are sent over a communications channel using two different signals. One…

Q: 2.2 Consider a wireless network. For each of the following cases, state whether the packet…

A: We are given wireless network problem where A and C terminals are not in range with each other and…

Q: Apply Dijkstra's algorithm to the graph below in order to calculate shortest paths from the node one…

A: find the below work to find out the shortest path using dijkstra's algorithm.

Q: A Telecom operator has been assigned the bandwidth from 2100MHZ to 2105MHz, this can support 100…

A: SOLUTION:

Q: Q1\ Consider a cellular system with clusters of size 7 cells. Suppose that the path loss for this…

A: I will explain it in details,

Q: A Telecom operator has been assigned the bandwidth from 2100MHZ to 2105MHz, this can support 100…

A: Actually this question belonging to Computer Network. Computer networking is a network of computers…

Q: True or False 1. A streaming video (UDP) from video server to a subscriber's PC at 300 Kb/s capacity…

A: Note: - As per the guidelines, we can only respond to a maximum of three subparts. Please give the…

Q: Question 4: Find the length cities in the communications network shown in Figure below. between…

A: Given cities= New York, Boston, Los Angels, Denver, Dallas, San Fransisco, Chicago And here we have…

Q: Consider N users are connected to a wireless network that offers a maximum data rate of 400 Mbit/s…

A: a) Maximum Data Rate or Bandwidth =400 Mbits/s Maximum Data Rate or Bandwidth is viewed as the most…

Q: The practical network shown below is a WAN consisting of seven routers A through G interconnecting…

A: Dijkstra's algorithm is a single source shortest path algorithm. In which initially select a source…

Q: A six-story office building has 10 adjacent offices per floor. Each office contains a wall socket…

A: As Given, Number of terminal = 10 Length of single wire between two sockets = 3m We have to find the…

Q: 1. Consider an OFDM implementation in the LTE cellular standard. LTE uses 15 kHz subcarriers and can…

A: Answer: I have given answered in the handwritten format in brief explanation.

Q: Assume a system of 32 cells with a cell radius of 1.6 km, a total of 32 cells, a total frequency…

A: Assume a system of 32 cells with a cell radius of 1.6 km, a total of 32 cells, a total frequency…

Q: Consider a cellular network with the following specifications: total number of carriers duplex…

A: The answer has given below:

Network transmission cabling

A network is a collection of devices connected by communication links. A device can be a computer or any instrument capable of sending and receiving data or information formed by other nodes toward the network. A channel that connects people or things is known as a network. It sends the data from one place to another. It is the basic concept of a computer, network, and data communications.