I Review | Constants re 1) shows two rectangular tanks, A and B, full of r. They have equal depths and equal thicknesses (the nsion into the page) but different widths. Compare the forces the water exerts on the sides indicated in the figure. Is F, larger than, smaller than, or equal to Fв? Explain. Match the words in the left column to the appropriate blanks in the sentences on the right. < 1 of 1 > is greater in tank A because the mass of water is greater in this tank The pressure at any given depth The area of the sides indicated in the same for each tank, so is the same in both tanks because the water depth is the same A Sides FA = FB

Q: QUESTION 7 A U-shaped tube is open to air on both ends and filled with water (blue) and an unknown…

A: Given: The density of the water is 1x103 kg/m3. d=6 cm=0.06 mh=20 cm=0.2 m

Q: Find the mass and weight of the air in your bedroom. Assume an air density of 1.2 Kg/m³. Show ALL…

A:

Q: The maximum gauge pressure in a hydraulic lift is 17 atm. What is the largest size vehicle (kg) it…

A:

Q: Constants | Period A cylinder has a diameter of 15 cm (Figure 1). The water level in the cylinder is…

A:

Q: Water is flowing in a horizontal pipe of diameter d. If you want to change the diameter of this pipe…

A: According to Bernoulli's principle, if the pressure at a point in a flowing fluid is increased, then…

Q: Tank B is inside Tank A. Given the information below, find Patm- Please don't write the unit. Only…

A: Given :Tank B is inside tank A Pgauge A  = 50 units Pgauge B = 50 units Pabs B = 250 units

Q: True of false. (Write True if the statement is true or otherwise if false) 1, The density of air is…

A: 1. The density of air is around 1.2 g/liter =&gt; This statement is true.    2. The Specific Gravity…

Q: a) If the speed of the fluid at the bottom of this canister is 10 m/s, what is the speed of the…

A:

Q: A simple water tank with a cross-sectional area of 1.0 m² is known. The liquid in the tank is pumped…

A: Discharge is defined as the ratio of volume of the flow per unit time. It is denoted by Q. Discharge…

Q: 1. When the diameter (d 1 ) is double (refer to the figure above), what happened to the…

A: 1. In a given figure we can see that value of d1 is equal to 10 cm v1=4 m/s v2=1 m/s d2=20 cm If the…

Q: 1. Find the pressure increase in the fluid of a syringe when a nurse applies a force of 42N to the…

A: The applied force,

Q: luid fills the container shown in the figure. At which of the indicated points is the pressure…

A: Write the given parameter of the problem- Four points is given A,B,C,D Depth(h)

Q: contains water to a di orce of 16 kN parallel acceleration of the tan C. 43.6 m/s? d. 1.71 m/s?

A: Weight of tankwt =3.6KN Weight of water Ww =Vw ×spesifiveGr Weight of waterWw =(3×3×1)×1Weight of…

Q: At 20 °C, the surface tension of water is 0.073 N/m. A soap film is holding up the entire weight of…

A: Wire length = 2.2 cm = 0.022 m Wire Diameter = 0.1 cm = 0.001 m Wire radius = 0.001 / 2 Surface…

Q: For known boundary conditions and fluid properties, a general compressible flow problem has five…

A: The unknowns for a compressible flow problem are pressure, the three components of velocity, and the…

Q: 5. The radius of the blood vessel is 0.9 cm with a viscosity and density of 0.004 kg/(m-sec) and…

A:

Q: A circular plate is placed inside the liquid that has a density of 980 kg/m3. Write down an integral…

A: Draw the schematic diagram as below. Equation of circle whose center use on origin having radius,…

Q: Is the graph linear? Should it be? Why? Calculate what the value of the slope should be using your…

A: From the given data table, if we subtract, the (third column- second column), then we will get the…

Q: A tube with variable diameter has one extremity at the ground level with diameter d₁=15 cm and the…

A:

Q: 1. A vacuum gage connected to a tank reads 30 kPa at a location where the barometric reading is 755…

A: Given: Vacuum gauge pressure= 30 KPa Barometer reading =755 mm Hg     To determine absolute pressure…

Q: A 4.5-kg plastic tank that has a volume of 0.38 m³ is filled with liquid water. What is the weight…

A:

Q: 4. An object has a weight of 8.10 N when in air. However, it submerged in water. What is the density…

A:

Q: I Review | Constants A piece of wood is 0.550 m long, 0.240 m wide, and 0.078 m thick. Its density…

A:

Q: Using the data below, determine the maximum amount of blood that can pass through the aorta in 1…

A:

Q: 2. Refer to figure 2. Blood flows through a 2.50 cm long artery with a 10.0 mm diameter at 12.0…

A: Given

Q: PROBLEM 1. Compute the capillary effect of immersion in mercury of a glass tube of ómm internal…

A: H = 2Tcos(theta)/DgR T is surface tension Theta is contact angle  D is density of mercury g is…

Q: Problem 5 Machine oil with density Poil = 800 kg/m³ flows through a pipe, with dimensions as shown…

A: Suppose the area of CS at the mouth by A1and the end be A2 The formula for obtaining the flow rate…

Q: barber raises his customer’s chair by applying a force of 100 N to a hydraulic piston of area 1.39…

A:

Q: Please Answer the following question step-wise with detailed explanations. Thanks in advance A pipe…

A: Given that:

Q: A triangular water trough is "a" metres wide and "a" metres deep, as shown in Figure 3. If the…

A: Given: The density of water is 1000 kg/m3. To determine: The magnitude and location of resultant…

Q: Review | Constants A nuclear power plant draws 3.3x106 L/min of cooling water from the ocean. Part A…

A: According to equation of continuity Rate of flow = A v A = cross sectional area v = liquid velocity

Q: . Water at a pressure of 3.8 atm at street level flows in to an office building at a speed of 0.06…

A:

Q: A rectangular object weighs 300 N. It displaces a volume of water that weighs 200 N. a. Draw the…

A: Given, Weight of an object, W = 300  N weight of the water displaced, Wd = 200 N density of the…

Q: A syringe has a fine needle with an inside diameter of 97.9 µm. The barrel has a diameter of 2.76 cm…

A: Barrel diameter=2.76cm Force=4.08N

Q: Question 1 Derive the expression for the fluid pressure of p(rho) density containing in the steel…

A:

Q: The net force needed to hold up a block of aluminum immersed in fresh water is 10 N. What is its…

A:

Q: A hydraulic lift consists of a circular input piston of diameter 20 cm coupled to a circular output…

A: Given:input piston diameter, di = 20 cm = 0.2 moutput piston diameter, do = 5.0 mfluid used is…

Q: 2.5 A particle of equivalent volume diameter 0.3 mm, density 2000 kg/m² and sphericity 0.6 falls…

A: The diameter of the particle is given as, x=0.3 mm. The density of the particle is given as, ρp=2000…

Fluid Pressure

The term fluid pressure is coined as, the measurement of the force per unit area of a given surface of a closed container. It is a branch of physics that helps to study the properties of fluid under various conditions of force.

Gauge Pressure

Pressure is the physical force acting per unit area on a body; the applied force is perpendicular to the surface of the object per unit area. The air around us at sea level exerts a pressure (atmospheric pressure) of about 14.7 psi but this doesn’t seem to bother anyone as the bodily fluids are constantly pushing outwards with the same force but if one swims down into the ocean a few feet below the surface one can notice the difference, there is increased pressure on the eardrum, this is due to an increase in hydrostatic pressure.