Household 120-V outlets are made to accept three-pronged plugs. One of the prongs attaches to the "live" wire at 120 V, andanother attaches to the "neutral" wire that is connected to ground. What is the round third prong for?It lets the appliance run if the neutral wire breaks.O It connects the case of the appliance directly to ground for safety purposes.It serves as a backup to the hot wire.O Nothing electrical, it is for mechanical sturdiness.

it connects the case of the appliance directly to the ground for safety purposes its the correct…

Household 120-V outlets are made to accept three-pronged plugs. One of the prongs attaches to the "live" wire at 120 V, and another attaches to the "neutral" wire that is connected to ground. What is the round third prong for? O It lets the appliance run if the neutral wire breaks. O It connects the case of the appliance directly to ground for safety purposes. It serves as a backup to the hot wire. O Nothing electrical, it is for mechanical sturdiness.

Household 120-V outlets are made to accept three-pronged plugs. One of the prongs attaches to the "live" wire at 120 V, and another attaches to the "neutral" wire that is connected to ground. What is the round third prong for? O It lets the appliance run if the neutral wire breaks. O It connects the case of the appliance directly to ground for safety purposes. It serves as a backup to the hot wire. O Nothing electrical, it is for mechanical sturdiness.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A cook plugs a 400 W crockpot and a 1000 W kettle into a 240 V power supply, all operating on directc When we compare the two, we find that Select one: a. I crockpot > I kettle and Rcrockpot = R kettle. b. I Crockpot = I Kettle and R Crockpot = R %3D %3D Kettle. c. I crockpot R kettle. d. I Crockpot > I Kettle and R Crockpot < R kettle.
An electrical circuit is shown in Figure B1 with the load resistor as 15K Q. 5ΚΩ 30KΩ 15 ΚΩ 12V 25KN Figure B1 By using Thevenin's Theorem calculate the following: i. Current flowing through the load resistor15K 2. ii. Power dissipated across the load resistor15K Q.
Ei
A capacitor C, initially charged, discharges through a resistor R. The circuithas a time constant of 1.5s. a) how long does it take for the capacitor to discharge up to 75%of its initial charge ?, b) If R = 250k⌦, what is the value of C? Clearly explain your answer.
The largest operating wind La generator in the world has a rotor diameter of almost 100m. This nits generator can deliver 3 3.1 MW of power. Suppose you connect adl 3.0 K resistor, a 4.0K resistor, and a 5.ok resistor in parallel- klhat potential difference must be applied across these resistors) in order to dissipate power w 1.00 percent of the Jock equal to power provided by the generator? Show all working step-by-step gat2 word stz
a. Write your understanding about the time constant for RC circuit. A capacitor is discharging through a resistor. If it takes a time T for the charge on a capacitor to drop to half its initial value, how long (in terms of T) does it take for the stored energy to drop to half its initial value? -e b. A 10-m-long wire has a resistance equal to 0.20 Q and carries a current equal to 5.0 A. (a) What is the potential difference across the entire length of the wire? (b) What is the electric-field strength in the wire?
A physics student has a single-occupancy dorm room. The student has a small refrigerator that runs with a current 4 A, a lamp that contains a 100-W bulb, an overhead light with a 60-W bulb, and various other small devices adding up to 8 w. All the appliances run on a voltage of 110 V. Overall Hint a. What is the total power used by the dorm room (while the refrigerator runs)? Total power used by the dorm room is W. b. Assuming that the power plant for the electricity is 10 km away and uses 00-gauge copper wire (diameter 9.266 mm), how much power is dissipated in transmission (remember to count the return wire), if the power plant is directly providing the 110-V? (To be more precise, the power plant is providing the voltage it needs to provide, so that the voltage at the dorm room is 110 V.) Hint for part (b) Power of W is dissipated in transmission at 110 V. c. The most common way to increase the efficiency of power transmission is by using higher voltage for long-distance transmission…
can u explane
In the circuit below, it is known that R1 = 10 kΩ, R2 = 15 kΩ, and C = 0.4 μF, and a battery with an Emf of 20 Volts. Initially, the connector (switch) is connected for a long time until it reaches a steady state. Then the switch is disconnected/opened at t = 0. What is the current flowing in resistor 2 at t = 4 ms?
Mehull
When a material has a negative temperature coefficient of resistance, O It has a negative resistance value at any temperature. An increase in temperature results in a decrease in resistance. It must be a conductor. O All of these
Please give thorough explanation. Thank you!