Hot oil at 150°C is used to preheat a cold fluid at 30°C in a I:I shell and tube heat exchanger. The exit temperature of the hot oil is 110°C. Heat capacities (product of mass flow rate and specific heat capacity) of both the streams are equal. The heat duly is 2 kW. Under co-current flow conditions, the overall heat transfer resistance (I/UA) is A. 0.4°C/W B. 0.04°C/W C. 0.36°C/W D. 0.036°C/W

Q: An aluminium pan whose thermal conductivity is 237 W/m/°C has a flat bottom whose diameter is 20 cm…

A:

Q: Water is to be heated by solar heated hot air (Cp= 1010 J/kg.°C) in a double pipe counter flow heat…

A: Given:   Double pipe counter flows heat exchanger. Overall heat transfer coefficient for the inner…

Q: In a thin-walled double pipe heat exchanger, city water flows through a stainless steel tube having…

A: Given data: Diameter of the stainless steel tube=2.54cm Rate of city water=0.2kg/s Water is heated…

Q: I at 351 v.v42L i) Calculate the temperature distribution at the middle and rate of heat floe at the…

A: Given,

Q: 1-85 A transistor with a height of 0.4 cm and a diameter of 0.6 cm is mounted on a circuit board.…

A: given = H = 0.4 cm d = 0.6 cm avg heat transfer coefficient = 30 W/m2K air temp Tair = 55^c…

Q: Air at 300 kPa and an average of 450 K is being heated as it flows through a rectangular conduit of…

A: The rate of heat transfer for unit area is called as heat flux normal to the direction heat flowing.…

Q: Hot oil at a flow rate of 7.2 kg/s (average c, = 1.92 kJ/kgK) enters an existing counter-flow one to…

A: Given:  Inlet hot oil Temperature = T1 = 385 K  Inlet water Temperature = T3 = 295 K  Outlet water…

Q: 1. Oil is flowing inside % inch, 16 BWG, 20 foot long tube. The bulk oil temperature is 212 °F and…

A: Given tube diameter,d=3/4 in or 0.062 ft tube length, L= 20 ft bulk temperature of oil, Tb=212 oF…

Q: A 20-cm diameter cylindrical enclosed pan is placed on top of a heating unit for vaporizing propane…

A: Given : The diameter of the cylinder, The vapor pressure of propane  The heat flux, The bottom pan…

Q: Determine the average convection heat transfer coefficient in a pipe (diameter d = 8 cm, length L =…

A:

Q: Benzene vapor is being condensed at 340 K on the outside of pipes of a 1-2 shell-and-tube heat…

A: density of water(rwater)=1000kg/m3Cpwater=4180J/kg.Klatent heat of…

Q: (3.4) The gas heater shown below in cross-section consists of a square sheet-metal duct insulated on…

A: a) given = Heat transfer fluid data T1 = 500 K T2 = 450 Kh1 = 200 W/m2K f1 = 0.00035 m2K/w Process…

Q: (b) An electric kettle with a 3kW heater element is used to boil water. The kettle has a stainless…

A: To determine the temperature at the center of the wire (T_max) and the convective heat transfer…

Q: An engine cylinder of height H = 0.15 m and outside diameter D = 50 mm. Under typical operating…

A: known: operating condition of a finned motorcycle cylinder   Find: Increase in heat transfer…

Q: A stream of ammonia is cooled from 100oC to 20oC at a rate of 180 kg/hr in the tube side of a…

A: Given,

Q: Calculate the overall heat transfer coefficient of steel pipes based on the inner surface. The…

A: Given that, Given that, The inner diameter of the pipe Di = 12.7 cm = 0.127 m The thickness of the…

Q: The energy transfer between the hot fluid and cold fluids is brought about by their complete…

A: We have to answer which type of heat exchanger is used where the hold and cold fluid is direct…

Q: A vessel with a paddle agitator and no baffles is used to heat a liquid at 37.8degC in this vessel.…

A: Given Inside diameter of the vessel, Di=1.22 m Diameter of the agitator, Da=0.406 m Speed of the…

Q: A double pipe heat exchanger consists of a 2" Sch 40 steel pipe inside a 3inch Sch 40 steel pipe, 10…

A: It is given that double pipe heat exchanger is used to condense steam in the annulus bu help of…

Q: The compression ratio of an air-standard dual cycle is 12, and the pressure at the beginning of…

A:

Q: Q3) After a long time in service, a counterflow oil cooler is checked to ascertain if its…

A: To Find  The heat reduced due to fouling

Q: Water available at 24 C is heated by a heating element having 30 mm outside diameter and 0.4 m…

A: Cp=4180J/kg.∘C k=0.64W/m∘C density(r)=988kg/m3 μ=0.55×10-3N-S/m2 Ts=80∘C length=0.4m do=30mm=0.03m…

Q: Problem 1 A pipe containing steam with an inner diameter of 200 mm is surrounded by an insulating…

A:

Q: length of the crystallizer

A:

Q: A concentric tube heat exchanger operates under the inlet and outlet conditions set out in Table…

A: Given, The mass flow rate of hot fluid, mh = 7 kg/s The initial temperature of hot fluid, Thi =…

Q: Q5) A cube of aluminum 10 cm on each side is initially at a temperature of 300 °C and is immersed in…

A:

Q: Q2/ Air at atmospheric pressure and 27 °C is blown across a long 4.0 cm diameter tube at a velocity…

A:

Q: In a chemical processing plant, you are tasked with designing a cylindrical pipe system for…

A: One-dimensional heat transfer is a fundamental concept in chemical engineering, focusing on the…