Homework 1: A 440V, 50HZ induction motor takes a line current of 45A at a power factor of 0.8 lagging. Three delta connected capacitor are installed to improve the power factor to 0.9 lagging. Calculate the KVA of the capacitor bank and the capacitance of each capacitor

Homework 1: A 440V, 50HZ induction motor takes a line current of 45A at a power factor of 0.8 lagging. Three delta connected capacitor are installed to improve the power factor to 0.9 lagging. Calculate the KVA of the capacitor bank and the capacitance of each capacitor

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: The combined inductance of two coils connected in series is 0.6 H or 0.1 H depending on the relative…

A: In tha question, The combined inductance of two coils connected in series is 0.6 H or 0.1 H…

Q: A resistance of 100ohms, an inductance of 75.0 mH, and a capacitor of 4.0 microF are connected in…

Q: A 274 V, 53 Hz single-phase system supplies power to a fully loaded 14 kW motor running at an…

Q: An installation consists of an induction motor and a heater load. The induction motor takes 25 KVA…

A: Given, Induction motor rating, S= 24 kVA. Power factor, cosϕ=0.8 lagging…

Q: 1. A relay coil is connected to a 210-V, 50-Hz supply. If it has a resistance of 30 2 and an…

Q: A choking coil having a resistance of 20 Ω and an inductance of 0.07 henry is connected with a…

Q: Example (5) Calculate the pitch factor for a winding having 24 stator slots when the coil spans 5…

Q: ALL FINAL ANSWER SHOULD BE ACCURATE TO 3 DECIMAL PLACES USE POSITIVE ANGLE EQUIVALENT, NOT GREATER…

Q: 3. If the capacitor of Question 2 is replaced with one drawing 8 kvar, calculate: a. The new value…

A: The solution is given below

Q: k: It is desired to increase the pf of a 1-ph motor from 0.75 lagging to 0.95 lagging by using a…

A: Given, V=0.5 kV I=25 A cosθ1=0.75 cosθ2=0.95 where, V is the voltage, I is the current, cosθ1 is the…

Q: A 15hp full load induction motor (1hp=745.7W) operates at 480V, 60Hz and a delayed 0.7 power factor.…

A: GivenRating of induction motor15hp ,480 v , 60Hz , 0.7 PfCapacitor value=75μF

Q: 8. A three-phase, three-wire 500 V, 60 Hz source supplies a three-phase induction motor, a wye…

Q: A coil is connected to a 230 volt source. If the voltage across the inductor is 125v, and the power…

A: The solution is given below

Q: A 0,64 H inductor is connected to the terminals of a generator that has a voltage of 240 volts and…

A: Impedance =voltage/current Impedance =angular frequency ×inductance.

Q: The "power cube" transformer for a portable CD player has an output of 5.7 V and 550 mA (both rms)…

A: Given, A power cube transformer has Secondary voltage, V2=5.7 V Secondary current, I2=550 mA Primary…

Q: For a system with total complex power of 10000 + 7500j VA, nominal voltage of 250 angle 30 deg. and…

A: Capacitor- Capacitor is a device which stores the electrical energy which passes through it.

Q: Three identical capacitors are connected in Delta to a 415V, 50Hz, 3-phase supply. If the line…

Q: Calculate the reactance of a coil of inductance 0.2H when it is connected to a 50Hz supply. A.…

A: The solution is given below

Q: Q20. A 230 V, 50 Hz AC supply is applied to a coil of 0.16 H inductance and 6.5 Q resistance…

A: To solve the above problem, one should have a basic idea about the working of AC circuits. The…

Q: What will be the value of coupling factor between two coils, when the self inductnce of each coil is…

A: Given two coils having, Self inductance of each coil, L1=L2=30 mH Mutual inductance, M=60 mH

Q: 2. An industrial plant consisting primarily of induction motor loads absorbs 1200KVA at 0.85 power…

A: This question belongs to power system . It is based on the concept of calculation of required shunt…

Q: (b) Three inductive coils each of inductance 26 mH are connected in delta to a 3 phase 425 V, 50 Hz…

A: The conversion of the inductance from the delta to star is similar as the resistance as shown below:…

Q: Q3 A three-phase induction motor has the following data: 50 hp and V440 and 50HZ operating at full…

A: first calculate total active and reactive power before and after compensation . reactive power…

Q: A 425V, 3-phase, delta-connected induction motor has an output of 12kW at a p.f. of 0.9and…

A: 1. Calculate the input power of the output by efficiency formula :- η = Pout×100PinPin =…

Q: Kindly answer A coil has an inductance of 40 mH and negligible resistance. Calculate its inductive…

A: Given:- A coil has Inductance (L)= 40mH Resistance (R)=0 ohm We have to determine inductive…

Q: H.W 1 A series AC circuit has a resistance of 15 2 and inductive reactance of 10 N. Calculate the…

Q: A three-phase induction motor runs delivering 9 kilowatts to its load at efficiency of 88 %. If the…

Q: A 440-V, 60-Hz,36.7 HP induction motor has power factor of 0.75 (lagging). Three Δ-connected…

Q: 1. A full-wave center -tapped C-filtered power supply has a transformer with 5:1 turns ratio, with a…

Q: A 230-V, 50-Hz,40 HP induction motor has power factor of 0.8 (lagging). Three A-connected capacitors…

Q: Each phase of a three-phase, delta-connected motor has a resistance of 15  and an inductance of…

A: First calculate input active and reactive power to the motor. Now a capacitor is placed in parallel…

Q: A 230V, 50HZ single-phase alternator supplies a fully-loaded 15kW induction motor. The full-load…

A: (i) The real power is the input power. The efficiency and the output power of the alternator are…

Q: Example 1: a) Calculate the reactance of a coil of inductance 0.32 H when it is connected to a 50 Hz…

A: It is given that: L=0.32 HF=50 Hz

Q: nts A 100 mH coil of negligible resistance is connected to an AC circuit in which an effective…

Q: primary and secondary coils of a transformer have 50 and 1500 turns respectively. IF the magnetic…

Q: A 3-phase, 50 Hz, 400 V motor input power is 80400 W, the power factor being 0.82 lagging. A bank of…

A: power P = 80400 W original pf = 0.82 lagging final pf = 0.85 lagging

Q: 1. A single phase motor connected to 400 V 50Hzsupplytakes 31.7A at a power factor of 0.7 tagging.…

A: From the basic concepts of Phasor diagram

Q: An alternating voltage is given by v = 278.6 sin 324t volts. Find the instantaneous value of voltage…

Q: A 132 kV System, the inductance and capacitance of circuit breaker location is 1 mH and 0.1…

A: Given: Line VoltageV=132 kVLine inductanceL=1 mHLine CapacitanceC=0.1 μF

Q: Given the circuit below, calculate the instantaneous power supplied to the inductor when is(t) = 1…

A: we need to find out power supplied to the inductor.

Q: A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of 158…

Q: Which element (capacitor or inductor) should be placed in parallel with the circuit to achieve unity…

A: In this question we need to find which element should place in parallel to make the overall power…

Q: An industrial plant uses two 3-phase induction motors rated at 460 V. At full load one draws 232 A…

A: The solution is given below

Q: coil connected to a 300V ,50Hz sinusoidal supply takes a current of a 12A at a phase angle 40°…

A: The solution can be achieved as follows.

Q: 2) The addition of a 20 – kvar capacitor bank improved the power factor of a certain load to 0.90…

A: In this question, Final apparent power S= 185kVA after capacitor bank = 20kVAr. It's used to power…

Q: The combined inductance of two coils connected in series is 1.9H or 0.7H depending on the relative…

A: Given: LSeires=1.9H or 0.7H

Q: A 3-phase, 50 Hz, 3300 V star connected induction motor develops 250 H.P. (186-5 kW), the power…

Q: Calculate the capacitance

Q: A 5000 hp 3-phase, induction motor operates at 80% efficiency and 0.85 power factor lag. The…

A: Given values are -

Q: A 440-V, 60-Hz,36.7 HP induction motor has power factor of 0.75 (lagging). Three Δ-connected…

Concept explainers

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.

Question

please help me in my homework please

Homework 1:
A 440V, 50HZ induction motor takes a line current of 45A
at a power factor of 0.8 lagging. Three delta connected
capacitor are installed to improve the power factor to 0.9
lagging. Calculate the KVA of the capacitor bank and the
capacitance of each capacitor

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
An inductor and a 470 ohm resistor are connected in series with a function generator. The current is 53.7mA RMS 8kHz. The reactive power is 2.32 var. Find the value of the inductance.
Determine the value of the capacitor to raise the power factor to unity when two induction motor must be connected to a capacitor . The first motor is twenty-four kilo watts and power factor 0.8, while the other is forty kilo watts and power factor 0.95.
A Star 3Phase source with phase voltage of 400V at 50HZ is connected to a delta connected 3Phase AC Motor. The transmisson line resistance from source to load terminal is 1 Ohm. The internal resistance of each winding of motor is 9 Ohm and the inductance of each coil is 38.2 mH. What is the true power delivered to load? O A) 15999 B) 14999 C) 13999 O D) None
An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is the rmscurrent in this circuit? (b) By what factor does the current changeif the frequency of the voltage is doubled? (c) Calculate the current for a frequency of 2.00 kHz
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?
Measure the voltage and current across the capacitor.Measure the average power delivered by the source.Observe the phase angle in the condenser
A triangle waveform with following specifications in Table B1. Table B1 RMS Voltage 50mV Number of cycles/second 100 i) Sketch the approximate triangular waveform with all specifications. ii) A transformer has primary coil with 100 turns and secondary coil with 120 turns. Estimate the current in the secondary coil, If the current in the primary coil is 4 Ampere
A 3-phase, 50 Hz, 1100 V motor has a total load output of 100 hp and a power factor of 0.78 learning and an efficiency of 85 %. This power factor is corrected to 0.92 by a capacitor bank connected in delta. A capacitance unit is made up of 4 identical 275 V capacitors. So find the capacitance of each capacitor.
When a capacitor is discharged through a resistor, the discharge curve is exponential Sinusoidal Step Square
Determine the value of the capacitor to raise the power factor to unity when two induction motor must be connected to a capacitor . The first motor is twenty-four kilo watts and power factor 0.8, while the other is forty kilo watts and power factor 0.95. Answer: 1.562 mF