he water system consists of a reservoir with a the pipe entrance is sharp-edged pipe entrance, a turbine and a globe valve. If the flowrate is 0.004 m3/s, what power, in W, is extracted by the turbine? Use the following: v = 1 x 10-6 m2/s Kentrance = 0.5 Kexit = 1 Kvalve = 6.9 f = 0.0316 γ = 9810 N/m3

he water system consists of a reservoir with a the pipe entrance is sharp-edged pipe entrance, a turbine and a globe valve. If the flowrate is 0.004 m3/s, what power, in W, is extracted by the turbine? Use the following: v = 1 x 10-6 m2/s Kentrance = 0.5 Kexit = 1 Kvalve = 6.9 f = 0.0316 γ = 9810 N/m3

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

shows a pump employed for lifting water from a sump. If its required to pump 60 liters/sec of water through a 0.1 m diameter pipe from the sump to point 10m above, determine the power required. Also determine pressure intensities at L and M. Assume efficiency of 70%. Pu-(YGYLD)
in a pelton wheel, the bucket peripheral speed is 8m/s, the water jet velocity is 20m/s and volumetric flow rate of the jet is 0.1m^3/s. Is the jet deflection angle is 120 degree and the flow is ideal. Determine the power developed ?
Please answer asap and show all of your work
5): For the system shown below: 1-Find the water power of the turbine (PT) if the required power output is PE (take PE between 5-25 kN) and the turbine efficiency is n (take n between 75 to 98%) 2- Find the flow rate in the pipe AB. 3-Find the value of Z1 for operating this system (take Z2 between O to 20 m). * Pitot tube Piezometer. 0.3m 1.0m z1 22 T. Id= 200mm d= 100mm
(b) A water turbine model is constructed at ratio of 1:8 with power system of 10 kW at speed of 555 rpm under a head of 2.5 m. Overall efficiency for both model and prototype is assumed at 0.93. (i) Detemine the specifie speed. mine t); (ii) If the prototype is run under a head of 25 m, calculate its rotational speed, power and discharge.
Please include complete solution
Give me all answers otherwise leave it. I I don't want partial answers. I remember please give me a, B, c, d and e... Please thank you
For the setup shown in the figure :
The 600 mm pipe shown conducts water from reservoir A to a pressure turbine, which discharges through another 600 mm o pipe into tail race B. The head lost from A to 1 is 5 times the velocity head in the pipe and the head lost from 2 to B is 0.2 times the velocity head in in the pipe. If the discharge is 700 L/s A) Compute for the total head lost 1. 05: Compute for the extracted energy cause by the turbine Compute for the hp given up by the turbine. V Answer A) EL 60m 600 mm 1.63 m 58.37 m 537.3 hp 600 mm o B ▷ EL 0 m
Be fast and quick and correct.