Hall measurement is conducted on a silicon sample of unknown doping with W= 100cm, A = 2.5 × 10-3cm2, I = 2 mA and the magnetic field is 500 Gauss. If the Hall voltage of +150mV is measured, find the Hall coefficient, conductivity type, majority carrier concentration, resistivity and mobility of the semiconductor sample.

Hall measurement is conducted on a silicon sample of unknown doping with W= 100cm, A = 2.5 × 10-3cm2, I = 2 mA and the magnetic field is 500 Gauss. If the Hall voltage of +150mV is measured, find the Hall coefficient, conductivity type, majority carrier concentration, resistivity and mobility of the semiconductor sample.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Similar questions

Problem 2 In a P-type semiconductor. the Fermi level is 0.3 cV above the valance band at a room temperature of 30O °K. Determine the new position of the Fermi level for termperatures of (a) 350 K and (b) 400 K. The Fermi level in a P-type material is given by
When a pentavalent impurity is added to a pure semiconductor, it becomes ......... 1. An insulator 2. An intrinsic semiconductor 3. p-type semiconductor 4. n-type semiconductor
A p-type semiconductor joined to an n-type semiconductor ... Pick those that apply. Will not allow current to flow in either direction. Has electron current flowing from the n-type to the p-type material Makes a diode Allows positive current flow from the p-type to the n-type material
(I) Determine the average ac resistance for the diode of the Figure below for the region between 0.6 V and 0.9 V. (II) Then determine the ac resistance for the diode of the Figure below at 0.75 V and compare it to the average ac resistance obtained in (I).
Take a diode formed by the junction of two type n and p semiconductors. In the figure below is the diagram of the energy bands of these semiconductors, (remember the concept of fermi energy, and knowing that for a pure semiconductor it is in the middle). Based on the figures below, answer a) What is the possible current direction in the direction from p to n or from n to p? b) Explain why the current flow occurs only in one direction.
Consider an extrinsic semiconductor. Given: /n = 6550 cm² /V sec Mp = 400 cm²/V sec ni = 5.6 x 1012/cm³ Find out the hole and electron concentration in the semiconductor when conductivity is minimum (in cm-³).
Determine the current I in the circuit (i). Assume the diodes to be of silicon and forward resistance of diodes to be zero.
For the diodes used , at what Voltage (VD) does condection stars .
1- Explain briefly with figure if exist, the Degenerate semiconductors. 2- When a diode is connected in a Reverse Bias condition, the overall result is a small ne current. Why?
For a silicon pn junction with T = 300 K, determine the diode current. The Is (reverse saturation current) is 10 raise to -14 or (10^-14) A. Determine the forward-bias diode current at VD = 0.5V, 0.6 V and 0.7V.
Which statement(s) is (are) true about a P-N junction: A. P-N junction consists of n-type and p-type semiconductor materials.B. Free electrons in n-type diffuse across junction to p-type.C. A depletion region formation happens due to electrons and holes moving away from each other due to the electric field.
True or False. Please explain. thank you As the temperature increases, the forward voltage decreases in a silicon diode. Then, the graph of the forward bias region will shift to the left.