H.W Q1) Assume we have 100 gram of cement within a closed tube, so that there is no water movement occur. Calculate the volumes of the hydration products with 1-100% hydration of cement will achieved. 2- 60% hydration of cement.

H.W Q1) Assume we have 100 gram of cement within a closed tube, so that there is no water movement occur. Calculate the volumes of the hydration products with 1-100% hydration of cement will achieved. 2- 60% hydration of cement.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Practical Part Q4). 1- State the meaning of normal consistency of cement. 2- Which method is widely…

A: Cement A dry, powdery material known as cement is created by calcining lime and clay. It can be…

Q: Q1) Assume we have 100 gram of cement within a closed tube, so that there is no water movement…

Q: The composition of a certain brand of cement is given (C3S = 53.0%, C2S = 18.0%, C3A=12.0% and C4AF…

A: Given data, C3S = 53% C2S = 18 % C3A = 12 % C4AF = 8 % To determine the type of the cement.

Q: Please discuss the Determination of Time of Setting of Hydraulic Cement by Vicat Aparatus

A: Initial setting time should be less than 30 minutes. Initial setting is the time in which cement…

Q: 1-Cement that not only hardens by reacting with water but also form a water resistant product is....…

A: 1. Option B - Hydraulic CementHydraulic cement is a cement which when reacts with water, hardens…

Q: 8- Fine cement bleeds. .thân coarser cement. 9- 10- the water of capillary pores in large voids of…

A: Questions belong to the construction material and cement topic.

Q: choose the correct answer The water/cement ratio needed to obtain zero porosity (Vcp=0) in a fully…

A: Basic concept introduction- Cement requires approximately 23% of the water by weight for its…

Q: Just after casting, a cement paste had a porosity of 60%. After 3 months, the porosity was reduced…

A: The cement hydrates in the presence of water. On hydrating the cement begins to harden. It uses up…

Q: The testing of concrete for compression will require the preparation of 12 standard concrete…

Q: If the degree of hydration=D55% and the weight of cement 100gm, the volume of gel water equal to *

Q: Practical Part Q4). 1- State the meaning of normal consistency of cement. 2- Which method is widely…

Q: The setting of cement is a complicated chemical phenomenon, what are the stages that took place?

A: This question has been taken from Building materials of civil engineering

Q: q3 A sample of concrete is prepared by using 500 g of cement with water cement rat of 0.55 and 240…

Q: For 100g cement with w/c=0.5 and the volume of the capillary pores (Vcp ) equal to 40 ml, the degree…

Q: Which cement is used for mainly building construction where strength .required with age Low Heat…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Use the British method to design an air-entrained concrete trial mix with a volume of (0.04) m?, if…

A: Air-entrained concrete contains billions of microscopic air cells per cubic foot. It is for…

Q: Basically, there are four types of Portland cements. Which one of the followings is more suitable…

A: Option-a:Type C: Low heat cementLow heat cement, also known as Type C cement, is designed to…

Q: the soundness test a specimen of hardened cement paste isfor a fixed time. a) Freeze p) Dry C)…

A: Soundness test is used to check the concrete does not show much change in volume after setting . In…

Q: Match List-l with List-Il (3 P) List-l (Type of cement) List-Il (Characteristics) A. Air entraining…

A: A. Air entraini Portland cement-->3. Greater resistance to frost attack

Q: Two types of cements A and B have fineness of 350 m²/kg and 550 m²/kg, respectively. i. Describe the…

Q: For the given amount of (weight of cement=120g, degree of hydration=100% and w/c ratio=D0.40), the…

A: Brief Concept- There is a requirement for a certain fixed volume of water for the cement paste. This…

Q: Coarse aggregate is not part of standard mortar mixture True O False

A: Mortar is a combination of a binding material and a supporting material. The binding material could…

Q: Second Section The composition of a certain brand of cement is given (C3S = 53.0%, C2S = 18.0%,…

A: First answer is rapid hardening cement because of more c3s content. So first answer is rapid…

Q: The testing of concrete for compression will require the preparation of 12 standard concrete…

A: Given data, Diameter of concrete d = 150 mm Height of concrete h = 300 mm Concrete mix ratio = 1:2:4…

Q: Calculate the chemical shrinkage (cm3/g) for one gram of completely hydrated Portland cement with…

A: Given, C3S = 65% C2S = 19% C3A = 4% C4AF = 9%

Q: The testing of concrete for compression will require the preparation of 12 standard concrete…

Q: Q4. ,Portland cement is a hydraulic cement that is produced by pulverizing clinkers removed from…

A: Given question, 1. What are the main types of cement? 2. Four main mineral compounds of Portland…

Q: The testing of concrete for compression will require the preparation of 12 standard concrete…

Q: Q.1) Use the British method to design an air-entrained concrete trial mix with a wolume of (0.07)…

A: Given that :

Q: DATA: Amount of Cement = 650 grams Amount of Water = 195 grams Calculate the amount of water…

A: Given data: Amount of Cement = 650 grams Amount of Water = 195 grams It is asked to Calculate…

Q: The testing of concrete for compression will require the preparation of 12 standard concrete…

A: Given data, Diameter of concrete d = 150 mm Height of concrete h = 300 mm Mix proportion = 1:2:4…

Q: Design of a concrete mix showed that 1 m3 of the mix contains 320 kg cement, 540 kg sand. A trial…

A: The below calculation is done considering the BSI method Standard cube volume = 15cm × 15cm ×15cm=…

Q: 1. Select the most appropriate answer Chemical reaction between water and cement in which cement…

A: Multiple choice questions have been given and it has been asked to select appropriate answers.…

Q: Q.1. A concrete mix of (1: 2:5) by weight, The yield (Y) of mix is (1.26 m/ 7 sack), and the volume…

A: Dear student, Please find the answer in the below attachments Thank you

Q: Q1) Assume we have 100 gram of cement within a closed tube, so that there no water movement occur.…

A: A. 100% hydration of cement: 1. Weight of dry cement actually hydrated: Wcah=100 g 2. Volume of…

Concept explainers

Reactions with Materials

Limestone

Question

1O"ll zain IQ
H.W 1.pdf >
H.W
Q1) Assume we have 100 gram of cement within a closed tube, so that there is
no water movement occur. Calculate the volumes of the hydration products
with 1-100% hydration of cement will achieved. 2- 60% hydration of cement.
Q2) Calculate the volumes of the hydration products for 150 gm of cement
with 0.5 w/e ratio, assume there is no external water can penetrate.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q- A sample of concrete is prepared by using 500 g of cement with water cement ratio of 0.55 and 240 N/mm² intrinsic strength of gel. The theoretical strength of concrete on full hydration will be nearly
Q3:(a) what are the most important types of Cement? (b) If weight of Cement (350) kg/m3 and water to cement ratio (W/C) = 0.5 The mixing ratio (1:2:3). Find the weight of material need to cast (5m3) ? (Note: Density of cement, Sand and Gravel are (1400, 1600, 1700) kg/M3 respectively
The testing of concrete for compression will require the preparation of 12 standard concrete cylinders with 150 mm diameter and height of 300 mm. The concrete mix proportion is 1:2:4 by weight and water cement ratio is 6 gallons per bag of cement. One(1) bag cement is 40 kgs, one (1) gal is 3.785 liters. The specific gravity of cement is 3.15, sand 2.60 and gravel is 2.70. Determine the volume of concrete for 12 cylinders in m3: O 0.068 O 0.064 O 0.052 O 0.046
What is the initial and final setting time of ordinary Portland cement according to British and American standards
Civil.
A: Find theforiginal quantities of cement and water for the following situation of a hydrated cement paste. (Assume that the reaction occurred in a sailed container): V= 30.8ml, We= 12 ml, unhydrated cement 20 ml , total voids= 37.5ml and the degree of hydration = 50%.
Q3 :: Know (five) of the following 1. Intended air 2. Alkali reaction 3 Slurry 4 Modified cement 6 - Aggregate smoothness coefficient 5. The absolute specific weight of aggregates پ: Answer the following: Use a table to compare) - Compare the capillary pores and the gel pores in the scientific cement paste 2- Compare between freezing and unreal freezing of the cement
Please show all works
The testing of concrete for compression will require the preparation of 12 standard concrete cylinders with 150 mm diameter and height of 300 mm. The concrete mix proportion is 1:2:4 by weight and water cement ratio is 6 gallons per bag of cement. One(1) bag cement is 40 kgs, one (1) gal is 3.785 liters. The specific gravity of cement is 3.15, sand 2.60 and gravel is 2.70. Determine the mass of water in kg needed for the 12 cylinders: 28 32 30 23
For 100g cement with -1 w/c=0.5 and the volume of the capillary pores (Vcp ) equal to 40 ml, the degree of hydration (h%) is equal to: (note: Vcp= * Vec+Vcw)
For 100g cement with w/c=0.5 and the volume of the capillary pores (Vcp) equal to 40 ml, the degree of hydration (h%) is equal to: (note: Vcp= Vec+Vcw)