How: Determine the response for the following system.and find ess and Isystem.V(t)=2464)| K=lo1+65CA)idea

Answered: Image /qna-images/answer/1d97fdfb-fa22-4863-90a0-1e72bfdc04e4.jpg

Answered: H.W: Determine the response for the…

Engineering

Electrical Engineering

H.W: Determine the response for the following system. and find ess and Tsystem. VL)=2464) | K=10₂ 1465 CA) idea

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.22P

See similar textbooks

Related questions

Q: A varying phase shift produces a(n)_

A: The term phase shift means changing the phase. It may be time point of view or it may be magnitude…

Q: Transfer the point P (6.32, 108.43°, 3) into spherical coordinate a) (5, 65.62°, 106.43°) b)…

Q: 6 kohm 18 V Si 4 kohm 2 kohm

Q: )A 4-pole, 220 V, wave connected shunt motor gives 11 kW when running at 1000 rp.m and drawing…

A: In this question we will find dc motor torque , flux per pole ... Note :- as per our guideline , I…

Q: A PMMC instrument has a three resistor connected across it to design multi- ranges indirect method…

A: In this question we need to find the range of the ammeter and it circuit.

Q: 21) Determine the input and output impedances for the amplifier circuit below. Assume that…

A: Amplifier: Amplifier increases the current, power or voltage of a signal. this is a electronic…

Q: B-Given the Fourier transform X(f) of x(1), How would you obtain Fourier transform of x² (1) ?

A: In this question we need to find a Fourier transform of the signal x2(t)

Q: Load Shape Load Outside Diameter Length of Load to Heat Solid or Hollow Wall thickness Heating Goal…

A: Given current: 31 A voltage 42V Induction coil measurement: It has 1/8” OD and 0.03” wall…

Q: Q3) Draw the output waveform for the circuit in figure below. Assume that +Vout(max) = +10 V and -…

A: By knowing the property of zener diode and operation amplifier we need to plot output waveform of…

Q: For the Circut shown: WL₁=652 V(t): 50+ 40 SinW+ + 20 Sin 2w+[ I Find the active Power Quct Puct)…

Q: Draw a diagram for astable multivibrator using 555 timer. Find the oscillation frequency of the…

Q: Q1: Answer two of the following questions: a) For the circuit shown in fig.(1), R v = 10e V and i =…

Q: A 6- MVA, 6.6- kV, Y-connected, 2-pole, 50 Hz non-sallent synchronous generator has an armature…

Q: in series connected DC motor, the equation of electromagnetic torque is O Te = Laf * If * la O Te =…

A: Types of DC Motor DC series motor DC Shunt Motor Sepereted excited Motor Compound Motor…

Q: Write the short answers of the following:

Q: 1.45 Determine the equivalent stiffness of the system of Fig. 1-46.

Q: B. Use open collector inverters to implement the following logic expression: X = ABCD

A: Open collector: Open collector is a defined as a current sink on a BJT transistor output. These…

Q: Sketch the Output waveform for the following

A: Sketch the Output waveform for the following circuit : We know:For Si diode:VDon=0.7 Volt…

Q: 2. "A periodic function" (a) Has a period T = 2x period T == 3. The Fourier Transform of the…

A: We need to select correct option for periodic signal and Fourier transform of given signal

Q: If H=0.2 z² ax, V x H is 0.4z ay O 0.4z ax O None of the above 0.4z az O

Q: The electric field at the origin due to electric potential V=(x-2)+(y+2)+(2-1)³ is (4ax-4ay+ 3az) O…

A: We need to find out the electric field for given potential at given point

Q: (B) Solve the differential equation:- enouoil ov y"-3y' +2= 0, y(0) = 1, y'(0) = 1, y" (0) = 0

Q: Three distribution of charges are present in free space with: A uniform line charge of PL = 3 HC/m…

A: Electric flux density: It is the strength of the electric field E. this strength is created by the…

Q: A- A binary polar signal with ±5 volts is received in the presence of an AWGN with zero mean and two…

Q: A three phase Y/Y transformer delivers a load of 66 MW at 0.8 p.f. lagging and 138 KV (line to…

Q: Computed Values Compute the expected power factor of the circuit given the different capacitance. R1…

A: Here it is not clearly visible so I am taking capacitance in micro farad. When capacitance is…

Q: Q2 i) Find DTFT of a) X[n]= δ[n+5] -αn δ[n-5] b) X[n]=(n-1) (1/3)n u[n] please solve step by step…

Q: B- Two 1-phase furnaces a and b are supplied at 80V by means of a Scott-connected transforme…

A: A Scott connected transformer is used for producing a two phase electrical circuit from a three…

Q: A circular ring of radius (a) carries a uniform charge pL C/m and is placed on the zy-plane .the…

A: We need to find out the electric field due to ring at its axis

Q: Q4-(b) Find the state diagram of the set equation as follow :- X1(t) = ax1(t) + bX2(t) + cu(t) X2(t)…

A: In this questions, we need to draw the state space diagram of the given system.

Q: The starting current of a 15-hp, 440 volt, and three-phase induction motor is 32 amperes when rated…

A: Three phase induction motor is convert the electrical input to mechanical output. Three phase…

Q: Q. A straight binary sequence is applied to a 4-bit DAC, and the output in figure below is observed.…

A: The step binary sequence applies to the 4-bit DAC. The DAC is used to convert a digital signal to an…

Q: A single-phase 230V, 1kW heater is connected across I-phase 230V, 50Hz supply through an SCR. For…

Q: A common emitter class A transistor power amplifier uses a transistor with B=100. The load has a…

Q: Q2: (A) Find tan-¹ (1-5i) -1

A: Let the complex number 1-5i be represented by z, 1-5i=ztan-1z=xtanx=z Using the Euler's formula,…

Q: Describe how a complex wave is produced from sinusoidal waveforms. Give an example to demonstrate…

A: Harmonics are unwanted high frequencies that interfere with the fundamental and create a distorted…

Q: A video amplifier has a 250 mV input and a 6.5 V output. What is the voltage gain in dB? 6.5

A: Given, A video amplifier has Input voltage, Vin=250 mV Output voltage, V0=6.5 V

Q: Find V R3 using superposition method, and mesh current analysis method

A: The solution is provided in the following section.

Q: If A = ax + 3az and B = 5ax + 2ay - 6az, find the angle between A & B 123.65 O 121.65 O 122.65 O…

A: By using concepts of vectors in electromagnetic theory we need to calculate angle between the given…

Q: Three 74LS122 one-shots will be connected as a sequential timer. This particular circuit should…

A: Features of one shot circuit It is also called as Monostable multivibrator Only one stable state…

Q: Planes x = 2 and y=-3, respectively, carry charges 10 nC/m^2 and 15 C/m^2. If the line x = 0, z = 2…

A: Charge density determine the how much charge stored in a field. Charge density measure in term of…

Q: Q3 Define Environmental errors? A PMMC with coil resistance of 300052 number of coil 300 turns with…

A: In this question we will find deflection angle for PMMC...

Q: 2. Find the resonant frequency for the circuit shown below. 9 μF Zin 20 mH ell ww 192 ww 0.1 Ω

A: In this question, We need to determine the resonance frequency of the given RLC circuit. At…

Q: Draw symbols 1.Electric cell 2.key 3.Ammeter 4.volmeter

A: Draw symbols

Q: Q3) a Find laplace transform of X (t)= et sin 2t for t ≤ 0 also indicate R.O.C please solve step by…

Q: Transfer the point P (6.32, 108.43°, 3) into spherical coordinate a) (5, 65.62°, 106.43°) b) (6,…

Q: 5. A 240-V rms 60-Hz source supplies a parallel combination of a 5-kW heater and a 30-kVA induction…

A: In this question , parallel connected load is given....We have to find out system apparent power ,…

Q: 10 Given the potential V== sin cos , (a) Find the electric flux density D at (2, π/2, 0). b)…

A: In this question we will find electric flux density and work done to move the charge with given…

Q: Q2/ A separately excited DC motor with an armature resistance of 2 2 is powered by a chopper from a…

A: In this question we have given separately excited dc motor supplied by chopper....We have to find…

Q: (b) The output voltage of an amplifier is 2 V at signal frequency of 3 kHz, and reduced to 0.5 V at…

A: We need to find out the output voltage for given change and we will find out change in voltage for…

Question

How: Determine the response for the following system.
and find ess and Isystem.
V(t)=2464)
| K=lo
1+65
CA)
idea

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A) Plot the following function on a Karnaugh map. (Do not expand to minterm form before plotting.) b) Find the minimum sum of products. c) Find the minimum product of sums.
Quantize a sequence {-1.2,0.89,-0.5,-0.3,1.2), using a uniform quantize in the range of (-1.5,1.5) with 8 levels write the quantized sequence
Most simplest SOP form. Please fast...
An asynchronous circuit has two SR latches (not edge-triggered FF) denoted SR1 and SR2, and two external inputs x1 and x2. It also has a single output z. The excitation expressions for the inputs and output equations are (see image). Using the characteristic equation for an SR latch, draw the excitation table. Then draw the state table, flow table, and flow diagram.
What is the input to the system with specification given, Kp = 10, 500? A. Step function B. Ramp Function C. Parabolic Function
please solve proper step by step subject signal and systems
Need this answered in Canonical POS form (using the highlighted 0's) in the attached screen shot table first, then to covert to minimized SOP form. I don't understand how to convert from Canonical POS form below listed as from the screen shot chart... to minimized SOP form. a.) Y = (A'+B'+C)(A'+B+C)(A+B'+C')(A+B+C') b.) W = (A+B'+C')(A+B'+C)(A+B+C')+(A+B+C)
Hello. I am confused which route to take for this problem. I could break it into parts, but do I put it into its odd and even functions for symmetry? Could you guide me through this problem? Thank you for your help.
Please answer all subpart for like this please Asap for like this please...
10 (Even Numbers will solve). Defined as is (t) = 3--3u (t-1) a) Draw the graph of is (t). b) Determine the general expression for the output voltage vo (t). c) Draw the graph of vo (t).
4. Set up the LP formulation for state estimation (Do not solve LP). Bus 1 is the slack bus with V₁ =1.02/0. Find V₂28₂. 2 Measurements are: P₂ = 1.7, Q₁ = 0.5, V₂ = 1.03 Start with V₂ = 1, 82=0 G Q₁ Z-j0.1 V₂Z 82 T₁₂ P₂
Expand the following expression to a standard SOP form? Also Use K-Map to minimize above Expression?