Given the system in figure Realize using state space. 0.5 -1.16 2-1 rl(n) Z-1 r2(n) -1.25

The example problem is attched below,Solve 4th ques by using the equations in other image

Reference  7 segment display: Solve for the segments: "d, e, and f." Show your work 1. KMAPs 2. Reduced equation to lite up the segment 3. Describe the operation of Lab 12 4. If you were to add a 4th seven-segment, Describe your design process.

Redesign the W/L ratio for M2 as shown to achieve a voltage gain of 0.75.

(i) For the circuit below, draw the output waveforms for both the given input wave- forms. (ii) How can you convert this circuit into a half-bridge by removing any two compo- nents? Please draw a circuit diagram. Also, draw the current flow through the modified circuit. This can be done by annotating the modified circuit diagram. M (i) (ii)

The answers are already given, how were they solved?

0.02 (e) The responses in the figure below are for a unit step change in the disturbance with just P-control. One of the responses used a controller gain of Ke = 5 and the other used a controller gain of Ke = 8. Match the controller gains with the responses. Response to a Unit Step Change in Disturbance With P-Control 0.07 Response 1 --- Response 2 0.06 0.05 H 2 0.04H S 0.03 0.01 5 10 15 20 Time (min) (f) The responses in the figure below are for a unit step change in set point with a PI controller. The gain is the same for both responses but one response uses an integral time of ti = 1 min and the other uses an integral time of t = 2 min. Match the integral times for the PI controllers with the responses. r Response to a Unit Step Change in Set Point With Pl-Control 1. Respanse 1 --- Respanse 2 1.4 1.2 0.8 O 0.6- 0.4 0.2H 10 15 20 Time (min) (h) Determine the missing information for the sensor system in the following table. The output for the sensor system is a mA signal. Range Zero…

9. Convert the following Decimal numbers to Binary and then from binary to Gray code: DECIMAL BINARY GRAY CODE 17 33 40 63

Can you help me solve this and explain clearly I saw some answers on chegg but I don’t understand it .

Repeat the design using TFF by making the state diagram of the circuit given below.