Given the hook-up drawing, list all the equipment, tools and materials that are needed in installation.

What are two advantages of using a shrink-fit toolholder ?

What are the three most common grips for drawing? Explain each type of grip, along with their advantages and shortcomings in different drawings. Provide some examples.

A NC lathe cuts two passes across a cylindrical workpiece under automatic cycle. The operator loads and unloads the machine. The starting diameter of the work is 3.00 in and its length = 10 in. The work cycle consists of the following steps (with element times given in parentheses where applicable): 1 - Operator loads part into machine, starts cycle (1.00 min); 2 - NC lathe positions tool for first pass (0.10 min); 3 - NC lathe turns first pass (time depends on cutting speed); 4 - NC lathe repositions tool for second pass (0.4 min); 5 - NC lathe turns second pass (time depends on cutting speed); and 6 - Operator unloads part and places in tote pan (1.00 min).   In addition, the cutting tool must be periodically changed. This tool change time takes 1.00 min. The feed rate = 0.007 in/rev and the depth of cut for each pass = 0.100 in. The cost of the operator and machine = $39/hr and the tool cost = $2.00/cutting edge. The applicable Taylor tool life equation has parameters: n = 0.26 and…

A circular shape blank will be cut of 100 mm diameter from a strip of 2.8 mm with a clearance value of 0.25 mm. Take the shear strength as 400 MPa. Determine a) The appropriate punch diameter. b) Blanking force. c) Blanking force when the blade angle is (5)°.

what types of work that will be carried out on the scrap machine?

What are the different categories of work as distinguished by equipment requirements?