Answered: Given the current rating of each…

Given the current rating of each winding is increased, can the open-delta configuration work as well as the delta-delta configuration? Explain in details. Provide diagrams if necessary.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter33: Single-phase Motors

Section: Chapter Questions

Problem 32RQ

See similar textbooks

Related questions

Q: = 7) Determine the current through a 4-0 resistor connected to a voltage source vs 24sin45t V.

A: In this question, We need to determine the current in the resistance R= 4ohm We know Current I=…

Q: ) At t<0, the circuit in Fig.5 is steady state. The switch is change as sho Vs1-35V Vs2-130V R1=17ΚΩ…

A: In this question we will find current through capacitor just after switch closed...

Q: Find the inverse Laplace Transform of the following functions: F(s)=(s+3)/((s+1)(s+2)) the answer…

A: We need to find out inverse Laplace transform of given function

Q: 7. Convolve a signal with values x = [3,5,-2] with a system that has the following impulse response…

Q: Determine the phasor currents I, and Iy in the circuit of Fig. 13.13. 5Ω j2 Ω 100/60° V j6 Ω 12 -j4Ω…

Q: A series RL with R = 15-02 and L = 73-H connected across a 24 VDC source for a LONG TIME, what is…

Q: Calculate the input voltage when V. = 11 V. 100 kn 10 kn V V₁

A: Given data, V0=11 V

Q: 1: Choose appropriate letter a, b, c or 1. In a two-port network, the output short-circuit current…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Subject : Electronics Identify this: it is used to clean surfaces and pins of the components.

A: The Electronic circuit boards are also called PCB. PCB is abbreviation of Printed circuit Boards .…

Q: The error for an ammeter is found as ±2%, the true range of the current it can give for 10 mA is

A: Given: The error for an ammeter, error=±2% Current, I=10 mA

Q: A coil of resistance R and inductance L is connected in series with a 50 μF capacitor, figure If the…

A: Given data, I=3∠30°AC=50μFf=50Hz

Q: QUESTION 7 An industrial heater has a nameplate that reads: 166 Vrms 50 Hz 106 KVA 0.88 lagging What…

Q: Unless given, use the: POLAR FORM for voltage and current, RECTANGULAR FORM for impedance. Consider…

Q: 1. A point charge Q=200 [pC] is located at the origin. (a) Find the potential difference between…

A: Given data, Q=200 pC=200×10-12 C (a) rA=18 m, rB=36 m Potential difference between point A and B is…

Q: The transfer function T(s) of a negative feedback control system is 2s/(s² + s + 2). If the…

A: Given: Closed loop transfer function, Ts=2ss2+s+2 Open loop transfer function, Gs=2s+1

Q: A 4-pole, lap-connected d.c. motor has 576 conductors and draws an armature current of 10 A. If the…

Q: Answer the following questions briefly. Use illustrations, drawings or pictures to justify your…

A: Use illustrations, drawings to justify your answer. Using Ohm’s Law, what is the relationship of…

Q: Two point charges exert force of 0.291 grams on each other. If the charges are 8.5 cm apart and with…

Q: Unless given, use the: POLAR FORM for voltage and current, RECTANGULAR FORM for impedance. (30pts)…

Q: Let r1 = 2 in region 1, defined by 2x + in region 2 where 2x + 3y - 4z 1, while fr2 - 30ay +

A: Solution- a) aN =∆f∆f =2ax+3ay-4az22+32+42 = 0.37ax+0.56ay-0.74azHN1 = H1.aNaN =…

Q: e response of a servomechanism is c(t) = 1 + 0.2e60 - 1.2e 10t when subject to a unit step. Obtain…

Q: An averaging amplifier have five inputs with RF = 30 kohms, what should be the value of each input…

A: When all of the input resistors are equivalent, the summing amplifier is termed an averaging…

Q: The capacitor has been added to the load in the circuit shown in figure below to maximize the power…

A: In this question we need to find a value of capacitance so that maximum power transfer to load.

Q: A capacitor with a capacitance of 3.6360426666667E-10 pF is a parallel plate capacitor. Each plate…

Q: +5 V VA D₁ www : R = 5 kΩ D₂ = D2 IDI R₂ = 5 kQ2 ID2 ID3 D3 VB R3 = 5 kQ -10 V -5 V Determine VÀ in…

A: In this multistage circuit Va is determined as-

Q: Of what is the type of synch Gen according to excitation & Compore excitation & Compore between…

A: Synchronous generators are classical in the two types depending on the excitation provided to the…

Q: Two metallic plates separated by 6.9 cm. If a plastic material is inserted between the plates of the…

A: Capacitor: This is an energy storage device that store the energy in the form of the electric field.…

Q: Length of Director , LD Length of Reflector,LR Spacing from Director to Driven Element, SR-DE

A: Since there are multiple sub-parts, as per the guidelines, in the following section, only the first…

Q: 4- The axial ration of a vertical antenna is AR=1. 5- The elevation plane of Omani-directional…

Q: For the given network below find the a - VD , b-VC , C-VG , D-VGSQ , e-IDQ , f-IE , j-IB

A: The given circuit diagram is shown below:

Q: What is the capacitance of a capacitor with 8.5 m² plates cross-sectional area and 0.02 m apart in…

Q: Calculate the input voltage if the final output is 10.08 V. 10 kn 5 ΚΩ 5 ΚΩ 5 ΚΩ 100 ΚΩ V₂ O 0.168 V…

Q: Derive the formula for the energy stored in a capacitor.

A: Note : According to guidelines of the company if the questions are of different then we supposed…

Q: Vc = @ positive half cycle Vo = @ negative half cycle Vo =

Q: What is the voltage when current is 5 A and resistance is 88 ? Do NOT include units Round your…

A: for determine voltage we use ohm's law it is given as when pressure and temprature is constant then…

Q: (A+BC) (ABC) reduce the expression to most significant form and write Truth table before and after…

Q: b) The maximum mean output voltage of a three-phase controlled full-wave rectifier is 540.2 V whilst…

A: Given Parameters of a full wave rectifier we need to find the ripple factor of full wave and half…

Q: Q5. A resistor (R) is connected with a capacitor (C) in series to a voltage source of v(1).…

A: It is given that: Resistor R is connected in with a capacitor C in series to a voltage source of…

Q: 2. Find v1 and v2 in the following circuit. (note: the arrows are signifying the positive position…

Q: Question 3 Consider the magnetic circuit of the following figure, Let the cross-section Area Ac…

Q: QUESTION 1 jΒΩ m - Τ 2/0° A RΩ -jΛΩ For the circuit shown above, what is the magnitude of the phasor…

A: given here a electrical network and asked to find the magnitude of V0 .

Q: A balanced negative sequence 3-phase system consist of Y-connected load supplied by a balanced…

Q: Two point charges of 318 statcoulomb and 414 statcoulomb are 6.8 cm apart. A point between the…

Q: A signal was represented using Bipolar RZ with a bandwidth of 40 kHz, then the bandwidth will be…

A: The given bandwidth is 40 Hz.

Q: TI systems has the block diagram as shown in Figure 1. Signal Flow Graph for the system. G4(S) Y(S…

Q: V1 10mVrm ~1kHz 0.⁰ H 10m 5÷4/20 C1 1μF R1 Σ91kΩ : U1. AC 10MOhm Combinational Network VCC 20V RB…

A: Given: Consider the given combinational network: Here, the input and output voltage is measured for…

Q: Calculate the DC voltage across a 608 Ω load for an RC filter section whose R = 210 Ω and C = 0.46…

A: The RC filter is a electrical circuit consisting of two different passive circuit elements.…

Q: W R₁

A: The given differential op-amp is shown below: Since the op-amp is ideal, the voltage at the…

Q: In MCB's what is the difference between type B, C, D. Which is better to use if you have an arc…

A: Type B MCB'S-- A type B trips when current is 3 to 5 times of rated current with an operating time…

Q: Q3. A 120V, 60Hz, 6-poles, V-connected three-phase induction motor has the following parameters per…

Concept explainers

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.

Question

100%

Given the current rating of each winding is increased, can the open-delta configuration work as well as the delta-delta configuration? Explain in details. Provide diagrams if necessary.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Winding and Construction of the Rotor and Stator

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In the circuit in Figure 2, the capacitor connected to the a-b terminals of the transformer anda circuit consisting of resistance is defined as a load circuit. a)Find the average power spent by the load circuit? b) How much of the average power calculated in a) by the resistance in the load circuit and how muchspent by the capacitor? Comment on the results obtained?
In a 2 pole lap winding dc machine , the resistance of one conductor is 2Ω and total number of conductors is 100. Find the total resistance.
Figure Ql shows a two-legged iron core with air gap on the middle leg. Primary winding and secondary winding are placed around the left and right legs respectively. Nı and N2 are the number of turns of the primary and secondary windings, respectively. The primary current (In) is supplied to the primary winding with the direction indicated in the diagram. Primary Winding Secondary Winding Figure Ql: Two-legged iron core The fringing effect of the air gap plays a role in the flow of the magnetic flux through the secondary winding. Explain how the fringing effect of the air gap can affect the voltage induced across the secondary winding. The explanation should be supported with a relevant equation. |
Fill in the following blanks:1. Lap winding is suitable for ……. Voltage, …… current d.c. generators.2. The critical resistance of the d.c. generator is the resistance of ……. .
What is transformer in electrical engineering?
1.Two identical shunt generators running in parallel, each with armature resistance of 0.02 ohms and field resistance of 50 ohms. The combined load current is 5000A. The field are so excited that the generated voltages of one machine is 610V and the other is 600V. The terminal voltage of this parallel combination will be. www Ish1 Rh1 a.350-360 V b.450-460 V c. 550-560V Rat www az G₂ Raz 5000 A Ish2
Discuss the relationship between the operating frequency and the transformer size? Through your engineering studies
Is there a difference between the phase windings resistances, if so, what does it mean? Please explain.
Explain the breakdown in liquid? Discuss the different methods of measuring high dc voltages. What are the limitations in each method?
The circuit for a 20-kVA, 220/3960 V, 50-Hz transformer is shown in Figure (1). The open- circuit test and the short-circuit test was performed on this transformer and the following data were taken: Open-Circuit test: Voc=240 V, Ioc=2.8 A, Poc=260 W Short-Circuit test: Vsc = 350 V, Isc=7.6 A, Psc = 420 W 1) Find the values of Rc, XM, Rp and Xs for this transformer. 2) Find the equivalent circuit of this transformer referred to the high-voltage side and draw the circuit. j 0.163 Q jXM 0.02 02 jXs
A three-winding transformer is connected to an AC voltage source as shown in the figure. The number of turns is as follows: N₁ = 100, N₂ = 50, N3 = 50. If the magnetizing current is neglected, and the currents in two windings on secondary side are 2230° and 22150°, then what is the value of the primary current in Ampere? I 0000000000- N₁ № ₂ Z 00000 00000 Z N3 H I₁₂ I₁₂₁ ¹3
A 35-ohm diverter resistance is shunted across the series field of a DC series generator is supplying a current of 6 A to a series lighting system through a feeder of total resistance, 1.25 ohm. The terminal voltage is 2,300 V. The armature and series field resistances are respectively 18 and 15 ohms respectively. Determine the power developed in the armature of the generator?