Given that Q = 20 m3/s, calculate the flow depth of the stream after the scour hole.

Q: Water flows in a channel whose bottom slope is 0.5° and whose cross section is as shown in Fig. The…

A:

Q: 1m 2m 2m 2 m 4m 3m

A:

Q: Two horizontal pipes in series , each 1000 ft long and discahrges water at the rate of 4.75 ft^3/s,…

A:

Q: 1) Find the rate of flow in m³/sec/m (at right angles to the cross section shown in Figure 7.33)…

A: Given two stand pipes/piezometers installed at two points along the flow in  a permeable medium. The…

Q: 3. The figure shown is a frustum of a cone with an orifice in the bottom of 0.20 m². If the water…

A:

Q: A soil sample 10 cm in diameter is placed in a tube 1.2 m long. A constant supply of water is…

A:

Q: Show step by step solu

A: Q=1.555D2Explanation:

Q: Three pipes of different lengths and diameters connected in series, discharges 160 liters per…

A:

Q: Find Irrigation time to achieve an average infiltration depth of 100 mm

A:

Q: A weir installed at the end of a rectangular channel controls the flow of water. The rate of flow is…

A:

Q: ater flows through an open channel that has a cross-sec own in the figure. Flow is uniform and the…

A:

Q: The following information are given: Mud density= 10 ppg, depth=D11000 ft., It is required to use…

A: The given data is shown below: Mud density=10 ppgDepth=11000 ftHydrostatic pressure=450 psiWater…

Q: Draw the downstream water profile for the following step-up and step-down conditions.

A: Given Water flow diagrams and it is asked to draw downstream water profile of Sub-critical and…

Q: Q#2: A rectangular notch is 1m wide. Water flows over this notch to a depth of 150mm. Then the same…

A: Given data  Rectangular notch Width Depth Triangular notch Coefficient of discharge  Angle To find…

Q: A rectangular concrete channel 5m wide carries water as shown in the figure below. The channel bed…

A: GIVEN : WIDTH ( B )= 5 m SLOPE OF BED = 0.0013   TO FIND   DISCHARGE ( Q )

Q: A channel with a section as shown carries 1.1 m'/s of water with the depth as shown. The slope of…

A: Given:- The discharge of the water = 1.1 m3/s The depth of the water = 1.1 m  The width of the…

Q: For the cross section shown below, what is the required flow rate (assuming uniform flow) to cause…

A:

Q: The peak flow data for 5 years is provided in the table below. Based on the table below, what are…

A: Determine the a, b and c value in above table.

Q: t: A certain lined irrigation channel with a cross section shown in figure I in the next page. It is…

A: Discharge= 30 m3 /s Velocity= 1 m/s

Q: it is the depth difference between the waterlevel measured after some time during borehole pumping…

A: it is the depth difference between the waterlevel measured after some time during borehole pumping…

Q: 20m Smooth pipe: d = 50mm openjet pi 80m 10m + 40m

A: Given:- d=50 mm=50×10-3 mQ=50 m3/d=503600 m3/s,     f=0.014

Q: wo reservoirs having difference in water levels as 12m are connected by a pipe line 3 km long and 30…

A:

Q: weir installed at the end of a rectangular channel controls the flow of water. The rate of flow is…

A: To find percentage error in discharge measured

Q: The mean daily discharge hydrograph from a basin is given below. It is known that the recession limb…

A:

Q: An earth dam is shown in (Figure 1). Determine the seepage rate, q, in m³/day/m Length using…

A:

Q: Drawdown in the pumping test refers to: a) The amount of water level decline in a well due to…

A: The ground water which is stored between the rocks are called as aquifer. The aquifers are…

Q: |. The velocity of flow through a channel is

A: To find : Velocity of flow

Q: Q3 Figure Q3 shows a flow net for flow through a weir, the base of which is 2m below the ground…

A: To find the 1. Total head 2. Uplift pressure 3.total rate of seepage 4.average hydraulic gradient at…

Q: Manning's equation is Q = where Cm AR 2/3 1/2 n Q = Cm = = flow (m³/s) 1.49 USC system 1.00 SI…

A: D = 275.3317482 8/3√(Qn/S1/2)Explanation:

Q: Need help asap. Water flows in a wide channel at q = 10 m³/s/m and a depth of 1.25 m. If the flow…

A:

Q: Water flows in a rectangular channel at a depth of 20 cm and with downstream depth after the…

A:

Q: 6. The figure shown is a frustum of a cone with an orifice in the bottom of 0.20 m². If the water…

A:

Q: A trapezoidal notch having bottom width of 1.0 m is installed in a 2.0 m X 2.0 m rectangular…

A: Using relation for trapezoidal notchQ=cd2gH32[23B+815Htanθ]cd=0.64H=depth=1.5mTop width=2mBottom…

Q: Water is to flow at the rate of 25 m³/s in the concrete channel shown. Find the required vertical…

A: Given : Flow rate in channel (Q) = 25 m3/s n = 0.013

Q: 1 m 2 m 2 m 1m 2 m 4 m 3 m

A:

Q: The figure shown is a cross-section of a cast iron pipe with coefficient of roughness n = 0.012. If…

A:

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.