Given in the circuit,  R1 = 2 ohms R2 = 6 ohms L = 1 H C = 1/3 F E = 20 V   Find the current through L assuming zero initial conditions. Show step-by-step solution.

Q: (c) A solar farm contains 300 modules each with an active area of 1 m² and generates 30 kW of power.…

A: Utilization factor: Utilization factor is also known as the use factor where the time used by…

Q: 1. Find and draw the Fourier Transform of the signal shown if figure below: f(t) -T A coswot

A: 1) To find the Fourier transform of the given signal f(t) = cos(wot)  And also draw it's Fourier…

Q: V, is a 60Hz source with a peak voltage VP-120V is feeding a rectifier, assume ideal diode. The load…

A:

Q: A power station has a maximum demand of 2500 kW and number of kWh generated per year is 45 x 105.…

A: Given a power station with, Maximum demand = 2500 kW Number of kWh generated per year = 45×105

Q: Q1-write the following quantities by using power of ten :- • 29000kw 7000Ω • 0.0003ms • 0.05A •…

A:

Q: wwww wwww Fig. 40.17 If in Fig. 40.17, R = 220 k2, and C= 500 pF, what will be the frequency of…

A: Given, A phase shift oscillator employing the network Where, Resistance, R=220 kΩ Capacitance,…

Q: Find the total impedance at the point X and Y in the circuit shown Given: jՅԶ տ Ռ – 1.5 2 -j 2 2 : -…

A:

Q: Determine the frequency and duty cycle

A:

Q: An R−L−C series circuit has a current which lags the applied voltage by 45°. The voltage across the…

A:

Q: An integrated circuit is .. A. A complicated circuit B. An integrating device C. Much costlier than…

A: The word integrated in IC (integrated circuit) will tells that it has so many operations to perform…

Q: Find the value of the v across 6H

A:

Q: Determine X(S) expressed as a rational polynomial with simplified numerator and factored denominator…

A:

Q: A plane wave in air with an electric field amplitude of 2 V/m is incident normally upon the surface…

A: given here a plane wave in air with an electric field amplitude of 2 V/m is incident normally upon…

Q: Convert the analog voltage Y(t) = 3 sin(2πt) mV into a discrete time signal and show your answer in…

A:

Q: • 29000kw 7000Ω • 0.0003ms . 0.05 A • 0.00009v • 7000000v 9000kw Q2- converts the following:- a.…

A: All the given data and answers are given below.

Q: P 11.9-11 Determine the coil voltages, V₁, V2, V3. and V4, for the circuit shown in Figure P…

A:

Q: 4. An electric scooter company considers choosing a DFM a architecture with the following modules…

A: The 20 years of electric scooter manufacturing experience hydo Sports is one of the best electric…

Q: Find the value of the v across 6H 120 cos co V 10 H sm OF -OV

A:

Q: Fig. 39.15 shows a negative voltage feedback amplifier with typical values. What is the feedback…

A: Given feedback amplifier circuit, Input voltage = 101 mV Feedback voltage = 100 mV Output voltage =…

Q: 3 Ampere current is flowing in a circuit having resistance 40 ohms. Find the voltage applied to the…

A: Given: Current flowing in the circuit, I = 3 amp Circuit having resistance, R = 40 ohm

Q: Choose the statements that are true/correct about instruments used in circuits.    The ammeter is…

A: Statement 1: The ammeter is connected along the circuit Solution 1:  To measure the current in a…

Q: Question 1 Match the description with the (non-ideal) filter type. Here, P refers to a passband…

A: Filter: It is a circuit that attenuates some signal and passes the other signal. It reduces the…

Q: 2. Referring to the previous example, if the additional loads have a power factor of 0.866 leading,…

A: Given data: Additional loads have the power factor of 0.866 leading. Then, find the kVA of the loads…

Q: In Fig. 39.16, what is the feedback fraction m₂? (1) 0.01 (iii) 0.04 (ii) 0.02 (iv) 0.05 Vin 2 μV…

A: Given feedback amplifier circuit:

Q: tance Questions 2 For the following circuit assume Vi-9 V, Vz1-5V, VD1-0.6V. Vo is: R = 1 k Dowww…

A:

Q: Calculate its new rating

A:

Q: Show that the RF filter is given by the transfer function

A: It is given that:

Q: For a 3-input logic circuit shown below, the output Z can be expressed as P Doz R

A: Given logic gate circuit,

Q: An industrial process requires a power of 10 kW with a lagging power factor of 0.6 in a single-phase…

A:

Q: 2. Using the Illustration below. Compute the total impedance (Z), the total current (1), the voltage…

A:

Q: 9. If the output voltage of an amplifier is 1.2 V rms and its voltage gain is 50, what is the rms…

A: Given: Output voltage, V0=1.2 V Voltage gain, Av=50

Q: In order to light a LED: O send a HIGH signal and this will be written in the Loop function send a…

A: In order to light a LED what we will do in a program : options : Send a HIGH signal and this will…

Q: In the following circuit the diodes are 0.7 constant voltage model 10V Select one: a. None of the…

A: Introduction:- When two diodes are connected in anti-parallel then voltage drop across one diode…

Q: The output voltage Vout of the two stage amplifier shown in the figure is 10 V. The input voltage…

A: Given data, Av1dB=40 dBAv2=250Vout=10 V

Q: A heater is required to give 1000 cal/min on a 200V dc circuit. What length of wire is required for…

A: Given, P=1000 cal/minV=200 VR=3 Ω/m

Q: a) Use two input AND and two input OR gates to realize the function. b) Convert the circuit to…

A: For AND gate, When the all inputs are high then only the output of AND gate is high and remaining…

Q: A transformer rated at a maximum of 25kVA supplies a 12kW load at power factor 0.60 lagging. a) What…

A: Transformer :- It transfers electric energy and changes voltage through the principle of…

Q: ect all that are true    A) A PID controller can always be written as an observer-based controller…

A: PID controller refers to Proportional Integral Controllers. Device used in  in industrial…

Q: Two coils A and B known to have the same resistance are connected across a 110-volts, 60 cycle line.…

A: Given data, Two coils are connected in series.  Resistance of both coils are same. Supply 110 V, 60…

Q: arious possible impulse respons sidering the stability and causa

A: Given as,

Q: Design a bandpass filter with a lower cutoff frequency of 26.1 kHz and an upper cutoff frequency of…

A: To design a Bandpass filter with lower cutoff frequency fL = 26.1 KHz and Higher cutoff frequency fH…

Q: Fig. 39.17 shows the negative voltage feedback amplifier. What is the value of feedback fraction?…

A:

Q: P 12.7-5 A three-phase Y-connected source simultaneously supplies power to two separate balanced…

A:

Q: Using the practical diode model, the current in the circuit shown is: A 1.89 mA C 2.02 mA CA B OC…

A:

Q: Example 2.33. Using Node voltage method, find the current in the 302 resistance for the net- work…

A: Given circuit,

Q: A closed surface is defined in cylindrical coordinates by: 2 < ρ < 5, 0.07 π≤ϕ≤π7 and 1.93≤ z ≤0.…

A:

Q: In general terms we can consider that the real propagation of electromagnetic waves is rectilinear.…

A: The oscillations between an electric field and a magnetic field produce waves known as…

Q: A- Calculate the excitation field current of the synchronous turbo generato needed to get a Vrated…

A: Short Circuit Ratio: SCR or Short circuit Ratio is defined as the field current necessary to…

Q: 2. In the following differential equations, the linear stationary system is represented by ( ) A.…

A: Types of system  Linear and Non linear Time variant and time invariant  Causal and noncausal…

Q: High-Pass, Band-Pass and Band-Reject Filters are commonly used filters in DSP. In this task,…

A: Types of filters Band stop filter  Band pass filter  Low pass filter  High pass filter

Norton Theorem

In the current circuit law, the Norton theorem (also known as the Mayer-Norton theorem) is a simplification that can be applied to networks generated by a constant line of opposition, power sources, and current assets. In two network terminals, it can be switched on with a current supply and single resistor respectively.