Given: Density of water = 1,000 kg/m3 and g - 9.81 m/s?.DQuestion 7What is the difference of pressure in kN/m2 between (2) and (1), P2 - P1?Given that the specific gravity of the oil is 0.94.(Answer in kN/m? round to 3 significant figures.)Oil69 cmWater23 cmWater

Answered: Image /qna-images/answer/721b5f82-2166-49df-accc-42dd355fc2a8.jpg

Given: Density of water = 1,000 kg/m and g = 9.81 m/s?. D Question 7 What is the difference of pressure in kN/m² between (2) and (1), P2 - P? Given that the specific gravity of the oil is 0.94. (Answer in kN/m? round to 3 significant figures.) Oil 69 cm (1) Water 23 em Water

Given: Density of water = 1,000 kg/m and g = 9.81 m/s?. D Question 7 What is the difference of pressure in kN/m² between (2) and (1), P2 - P? Given that the specific gravity of the oil is 0.94. (Answer in kN/m? round to 3 significant figures.) Oil 69 cm (1) Water 23 em Water

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A double-fluid manometer is attached to an air pipe as shown in the figure. The the specific gravity…

A: Given:s1=14Patm=100 KPaP=76 KPah1=22 cmh2=40 cm

Q: A backyard swimming pool holds 185 cu yd (yd3) of water. What isthe mass of the water in pounds?

A: In the unit factor method, one unit is converted to another unit without changing its value. The…

Q: A block of wood floats in water with 7 inches projecting above the water surface. If the same block…

Q: It is estimated that 80 percent of an iceberg's volume is below the surface, while only 10 percent…

Q: What would be the rotation rate (in rad/sec) if during rotation the water in the nght leg (with a…

Q: lb Compute the density ( ft3 kg lbf ) and the specific weight ( ft3 KN m3 -) of m3 mercury ( sp. gr.…

A: Given data, Specific gravity S= 13.6 Let density of water = ρ1 = 1000 kg/m3 = 62.4 lb/ft3

Q: "hat is the air pressure (kpa) in a car tier? The pipe pressure is measured to be 20 kpa. For layers…

Q: Q1) Answer “FOUR" of the Following Objective Questions. You should use Equations, Relations, and…

Q: In the figure shown below. Let X-2 cm, Y = 10 cm, specific weight of water = 9850 N/m?, Benzene…

A: Givan Data: X=2cm: 0.02m Y =10cm; 0.1m Benzene density…

Q: A cylindrical container has a 6.0-in diameter and weighs 0.50 lb when empty. When filled to a depth…

Q: 5) Consider 4 immiscible liquids in an open tank (open to atmosphere) as shown below. Find the gauge…

A: Pressure is the intensity of force exerted over a characteristic area. The force exerted by the…

Q: Q2:Find the Specific weight of fluid D 2 cm 5 cm B 0.5 cm Water

A: From Pascal's Law

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

A: Given Data: The absolute pressure at the bottom is, P=625 kPa=625 kPa×1000 PakPa=625000 Pa. The…

Q: The empty steel cylinder in Figure below floats in the position shown. What is cylinder mass in 3 ст…

A: The given figure

Q: Q2: For the pipeline system shown in Figure, determine the value of pressure at Gasoline pipe. The…

A: The pressure in a pipe can be calculated by measuring it at different cross-sections. The pressure…

Q: Find the difference in pressures between points A and B in Fig. 2.47. Neglect weight of air. [Ans.…

Q: A platinum disc aboard the International Space Station has a thickness of 6 in. and a diameter of 2…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

Q: The bottom of a steel "boat" is a 7 m ✕ 8 m ✕ 5 cm piece of steel (ρsteel = 7900 kg/m3). The sides…

A: Givendimensions of steel =7m×8m×0.05mρsteel=7900kg/m3

Q: Q2: Determine the height (h) if the dial gage pressure is 80 kPa. Oil 80 kPa SG= 0.72 75 cm Air…

A: Given:

Q: A solid block, of specifi c gravity 0.9, fl oats such that75 percent of its volume is in water and…

A: Calculate the volume of the block. Here, V is the volume of the block, l is the length of the…

Q: A box of carton having 50 cm on each side floats in water. The specific gravity of the carton is…

A: S.G = 0.6 Side of carton = 50 cm = 0.5 m (S.W.)water = 9790 N/m3 To find: Submerge depth of…

Q: A circular plate of diameter 3.25 m is vertically placed in water in such a way that the centre of…

Q: 4. If 6.5 m³ of oil weighs 46,800 N, calculate its density in kg/m³. (a) 285 (b) 258 (c) 82 (d) 734

A: Given : volume of oil , V = 6.5 m3 weight of oil , W = 46800 N To find : density

Q: Rolex threw a certain type of rock into a freshwater lake. As a dare, one of his friend would need…

A: Submerged body When body is submerged in the water then some force exerted by the water that is…

Q: Q3: gage A in the figure reads 290 Kpa. What is the height h of water? and what does gage B read.

Q: An object with sg object = cu.m. what is the total volume O 13707.14 O 6650.00 O 10766.67 O 9240.91…

A: calculated the total volume of the object.

Q: A body weighs 1000 lb with gravity g defined in the English system. (a) What is the mass in kg? (b)…

A: Given: To find: (a) What is the mass in kg? (b) What will the weight be in N? in the lunar…

Q: Determine the atmospheric pressure (po) when the Barometer height is (76 cm), the density of mercury…

A: Given data as per questionBarometric height =76 cmspecific gravity of mercury=13.6we know thatp=ρgh

Q: What height of a column of special gage liquid (sp gr 1.85) would exert the same pressure as a…

Q: For the Figure, the cover gate AB closes a circular opening 178.4 cm in diameter. The minimum mass…

Q: What percent of the volume of a piece of iceberg (sg=0.915) will float above the water?

A: Givenspecific gravity of the icebergsg=0.915

Q: For the curved surface AB shown in the figure below, if the specific gravity of the fluid, S = 3.6,…

A: Given data: S=3.6, L=2.5mwater density ρ=1000 kg/m3To be Find: aMagnitude of vertical…

Q: A cylindrical evacuated container has the area of 792 cm? is closed with a lid. What is the value of…

Q: 1. Clouds can weigh thousands of pounds due to their liquid water content. Often this content is…

Q: 2. A cube with 15 cm sides is submerged in oil (So= 0.88) and held under the surface by a downward…

Q: QUESTION 5 A vertical rectangular plate with a width of 16 m and a height of 13 m is located 4 m…

Q: Sherman tank weighs 3

A: 1. W=66.8kip ( 1 ST=2kip) 2 .m=2075.499slug ( 1kg= 0.068522 slug) Note- gravity on mars value is…

Q: Q1:: Consider a large cubic ice block of (1 m) surface area floating in seawater. The specific…

A: Buoyancy force: Buoyancy force is the force that causes a body to float on th surface of the fluid.…

Q: Required information Gate AB shown in the figure is 1.2 m long and 0.8 m into the paper. The…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

Q: H1.4 Air is contained in a vertical piston-cylinder device. The piston, with a mass of 30 kg and…

A: Given:The mass of the piston, The diameter of the piston, The outside ambient pressure,

Q: Air 175 kPa Q3: gage A in the figure reads 290 Kpa. water What is the height h of water? and what…

A: This question is related to the gauge pressure. Gauge pressure is the pressure that lies above the…

Q: Syafiq weights at 80 kg. He is 175 cm tall, with average waist diameter of 35 cm. He plans to fly…

Q: The tank contains water and immiscible oil with S=0.97. What is h in cm?

A: Solution:

Concept explainers

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

PLEASE ANSWER QUICKLY
A barge pulled by a tugboat can be described as a rect- angular box that is open on the top. A certain barge is 30.2 feet wide and 12.50 feet high, with the base of each side being 116 feet long. If the barge itself weighs 6.58 x 10 pounds, what will be the draft (depth in the water) if the cargo weighs 1.12 × 10°pounds in (a) sea- water with a density of 1.025 g/mL and (b) freshwater with a density of 0.997 g/mL?
ASAP, PLS ANSWER CORRECTLY. Dont round off initial values, round off in final ans only pls ty
You are performing a pressure/elevation calculation is US units using the specific weight of water at 4C, which is 62. 4 b/f² . Your calculations leave you with a value of p = 10.0 /f².which you recognize is not a valid pressure unit. Complete the question by converting the b/f2 quantity into /in² . What is the pressure in lb/in2 ?
a u-tube manometer filled with water,density 62.2 lbm/ft3, shows a height difference of 10in. the right branch is tilted to make an angle of 30 degrees with the horizontal, what should the length of the column of water in the tilted tube to have the same pressure with the u-tube manometer? which is the answer? a. 8.66 in b. 25.4 cm c. 23.329 cm d. 22.0 in
I need a fast solution
The density of a steel anchor is 4205 kg/cu.m that is attached to a cylinder with 0.60m diameter, height of 1.2m, and with a mass of 34kg that floats in water with its axis vertical(upright). The steel anchor is attached to the cylinder which causes it to be submerged to a depth of "h" meters and remain in equilibrium position. a) Determine the equation based on the relationship between the weight of the anchor, "Wa" and the submerged depth "h". (Show step by step solution)
Pressure at A=22kpa
The bottom corner of a water tank that is 3 m wide (into the page) is constructed with a flat panel at an angle of 45° as shown in the figure below. The panel in question is shown as a heavy line. Note that water has a density of 1000 kg/m3. Determine: 2a) The magnitude of the total resultant force acting on the panel, FR 2b) The depth of below the water surface at which the resultant force vector acts on the panel, d
For the manometer shown in the image, all fluids are at 20°C. If PB- PA = 90 kPa, determine the height H in centimeters. The specific weight of water is 9790 N/m³ and the specific weight of mercury is 133100 N/m³. Meriam red oil, SG = 0.827 Water 18 cm H 35 cm Numeric Response B Mercury
Q1: Consider a large cubic ice block of (1 m) surface area floating in seawater. The specifie gravity of ice is 0.92. If a (15 cm) high portion of the ice block extends above the surface of the water, determine the height of the ice block below the water surface, h? 15 em Sea Water Ice Block
A 27m3 CUBICAL TANK IS FULL OF TWO DIFFERENT FLUIDS OF EQUAL PARTS. AN OBJECT WAS THROWN AND WAS PARTIALLY SUBMERGED PROJECTING 15% ABOVE THE FLUID SURFACE. IF THE HEIGHT OF THE OBJECT IS 3m AND THE SPECIFIC GRAVITY OF THE FLUIDS ARE 0.9 AND 0.82, FIND THE SPECIFIC GRAVITY OF THE OBJECT. * Your answer