Given an ideal 6 bit ADC with a reference voltage of 640mV, what is a VLSB of this ADC? What is the rms value of its quantization errors ?
Q: An incandescent lamp load generally considered to be made up of resistors take 4.8 kW from a 120 V…
A:
Q: Low Frequency Response: Compute for the following. d. Fcl(input) 9V 2.3 KQ 330 ΚΩ 1uF 1.6 ΚΩ 1uF H…
A: Point of Amplifier response is the frequency when gain is lesser than 3 db. The overall gain will be…
Q: The received power and noise power measured at a receiver is 0.5 mW and 150 nW, respectively.…
A:
Q: A 12-bit ADC is connected to the positive reference voltage of 1.5V and negative reference voltage…
A:
Q: R1. ww 5 Ohms R4 ww 3 Ohms R2 ww 3 Ohms ww 6 Ohms R3 ww 9 Ohms
A:
Q: 14.A 3-phase, 400-V (Line to Line) wye-connected synchronous motor has synchronous reactance of 1…
A: synchronous motor speed is independent of load . stator winding is energised by a AC source . The…
Q: ANALOG ELECTRONIC (FET) Determine the operating point of the amplifier by finding I(DQ) and V(GSQ)…
A: The required parameters can be calculated by using DC analysis of the amplifier circuit.
Q: 13.The armature of 6.6 kV, 3-phase, 20-pole, 300 rpm, Y-connected armature has 180 slots. The flux…
A:
Q: Q10- Design Colpitts oscillator to generate sine wave with frequency equal to 3 KHz, with gains…
A:
Q: Under some conditions, it is possible to approximate the effects of ferromagnetic materials by…
A: Given Few parameters of cylindrical wire,we need to determine magnetic field, magnetic field…
Q: Determine the total resistance across ab.
A:
Q: Topic: Maximum Power Transfer Theorem for an AC Circuit A. Calculate the value of the series…
A: Given:Circuit parameterV1=25…
Q: 7. In this problem, use without proof the fact that rect(t) convolved with itself is tri(t). Use…
A:
Q: What would be the current (Id) in a Silicon diode if, at a temperature of 95 °C, 0.67 volts are…
A:
Q: miz lent L L R = 8 KM, L = 0.3 m H, Q:- A 30 m long Transmission line has the following parameters:…
A: As per the guidelines of bartleyby I need to answer first three subparts only so kindly repost other…
Q: Two resistors, 18 ohms and 24 ohms, are to be connected in parallel across the certain voltage…
A:
Q: What would be the current (Id) in a Silicon diode if, at a temperature of 100° C, 0.63 volts are…
A: we have to find diode current ( Id ) at a temperature of 100°C and applied voltage is 0.63V given…
Q: 24.0 V 1+ 12.0 V www 16.0 Ω 28.0 Ω → 12.0 Ω WW →12 13 Calculate the voltage drop on 16 ohms. Note:…
A:
Q: Feedback: 2. An ideal series-shunt feedback amplifier has Rs negligibly small. If Vi= 100mV, Vfb =…
A:
Q: Consider n series-connected identical resistors of resistance R. Which of the following is true…
A: Second option is correct. The detailed solution is provided below.
Q: 4. The transistor's output impedance (Zox) is: A. 42214.69 Q B. 955.93 Q 5. The amplifier's current…
A:
Q: 3.- Suppose that each diode in the circuit shown in figure N°2 has a turn-on voltage of Vy=0.7…
A:
Q: 10.A sequential circuit has two JK flip-flops A and B, two inputs x and y, and one output z. The…
A:
Q: 3. We can find the frequency where the GAIN is 0 dB and the phase (phi) at that frequency. Then, the…
A: We are authorized to answer only three subparts at a time since you have not mentioned which…
Q: Q1: Using a 50 nF capacitor in the parallel RLC bandpass filter with a quality factor of 5 and a…
A: We need to analyse the parallel RLC circuit .
Q: 3) For each of following second order control system transfer function. Find the unit step response.…
A: i. The transfer is shown below: G(s)=180s2+12s+180 The Laplace transform of the unit step signal…
Q: Draw a Lattice diagram each for transient currents and transient voltages that are propagating at…
A: Given data is shown below. V=1.25×108μsl=250mt=10μsVg=15∠10°Zg=145∠25°
Q: Describe the relationship between the current and resistance
A:
Q: 3. For the circuit shown, find the Thevenin and Norton equivalent circuit to the left of terminal A…
A:
Q: A moving coil instrument having meter resistance of 5 Q is to be used as a voltmeter of range 0-100…
A: Given a moving coil instrument with, Meter resistance, Rm=5 Ω Meter current, Im=10 mA So meter…
Q: (1) show that the wr= resonance frequency is: 2 Lc-(^_^)² = 500 rads & 4H L IM R =1MF
A: Given here a electrical circuit and asked to find resonance frequency with proof.
Q: Determine the values of i2, i4, V2, V3, and V6 in Fig.(2). U3 + 4 V- E 6 A 3 A 6 V 12A 1214 -2V Di…
A:
Q: A three phase,Y connected, 215 V (line to line), 7.5 kW, 60 Hz, three pole IM has the following…
A:
Q: + \v2 Μ www R1 50 Ω 220 V www R4 - 200 Ω ww R2 150 Ω R3 150 Ω Μ R5 45 Ω ww
A: Given data, V=220V
Q: Low Frequency Response: Compute for the following. c. Zi
A: The input impedance of the circuit can be calculated by considering the bias resistance and input…
Q: Compute for the voltage Vab in the circuit shown below. a b R5 ww 2 Ohms V3 Holo 10V V1 R6 9 Ohms…
A:
Q: Question 19 Compute for the current is in the circuit shown below. O 1.0695 A O 1.0724 A 1.0745 A O…
A: In this question , we will find unknown current i1 in given circuit....
Q: explain the advancement and what kind of innovation in electrical power systems that will be…
A: Clean energy: It is a part and parcel of todays need of energy demand. It is much emphasized as it…
Q: Low Frequency Response: Compute for the following. g. Dominant Frequency
A: The required parameters can be calculated by using DC analysis and AC analysis of the amplifier…
Q: Feedback: 3. An ideal shunt-shunt feedback amplifier has Rs =∞ . If Ii = 100 microAmp, I fb = 99…
A:
Q: An ideal battery of terminal voltage 22 volts charges two practical batteries connected in parallel…
A:
Q: Simplify the following Boolean functions by tracing it on a K Map, grouping of blocks the best…
A:
Q: Compute for the voltage Vab in the circuit shown below. a b- -13.3752 V -12.6547 V -13.7037 V ○…
A:
Q: A 3.3 kV, 3-phase, Y-connected alternator has a full load current of 100 A. On short circuit a field…
A:
Q: Problem 2. A 20-ohm resistor is connected in parallel with a variable resistor R. The parallel…
A:
Q: Define full adder, make its truth table, solve for the equation of SUM and CARRY and draw its logic…
A: Full adder is a circuit that performs addition operation. Full adder is a digital circuit that adds…
Q: Large Signal Ampl: 1. Determine the input power, output power, and efficiency resulting in a class B…
A: The conversion efficiency of a Class B Amplifier is expressed as the ratio of Peak signal voltage…
Q: 31 32 33 34 35 Determine the equivalent resistance between terminals a and b. www 10 ohms 10 ohms…
A:
Q: The received power and noise power measured at a receiver is 0.5 mW and 150 nW, respectively.…
A:
Q: B = 85. Check if approximation can be used. Show calculation proof. +Vcc=20V RB wwwww 1kn2 IB V BE…
A: Brief description: For the given BJT we need to calculate values of all the DC currents such as IB,…
Given an ideal 6 bit ADC with a reference voltage of 640mV, what is a VLSB of this ADC?
What is the rms value of its quantization errors ?
Step by step
Solved in 2 steps with 2 images
- a) Describe the main sources of errors in a measurement process and state how they may be avoided or reduced. b) List two sources of coherent interference and describe how each may be minimized or eliminated. c) An 8-Bit ADC is used to convert an audio signal ranging over 0 – 12 V. What is the RMS quantization noise associated with full-scale operation of this ADC?VHDL Testbench Generate the following waveforms as part of a VHDL testbench using multiple processes. Note that cntr, and en signals are periodic signals and din and rst are not. Assume each time division is 10 ns. The ... represents the repeating pattern. Write your testbench as a parameterized waveform based on the parameter TD = 10 ns.A) For the -K FFs shown below. Given the waveforms, Determine the Q output wave (PGT) CK B) Perform each of the following conversions: (0110.0000) BCD =(---s. (11100.1)2= (---- c d1001010) -6 (100010)- (-----)aray cod, (D3.E) 16- (-----) 2 BCD.
- Sketch each of the following special digital sequences: a. 58 (n) b. -28 (n-5) c. -5u(n) d. 5u(n-2)An analog signal having a maximum frequency of 10 kHz is being transmitted through a PCM system with a uniform quantizer having 256 levels. What will be the minimum transmission bandwidth of the transmitted PCM signal?The information in an analog signal voltage waveform is to be transmitted over a PCM system with an accuracy of : 0.1 % of the peak-to-peak analog signal. The analog voltage waveform has a bandwidth of 43 Hz and an amplitude range of - 10 to 10 Vots. Determine the minimum bit rate fin bps) required in the PCM system? O a 688 O 774 O c 387 O d 86 Oe 258
- 3. What happens if the inverting & non-inverting i/p of the comparator interchanged? 4. Are there any limitations of such a vCO? Explain 5. Explain how a sine wave can be generated from such a VCO circuit. 6. List some applications for such a Vco.Find T of the integrated output waveform of dual slope ADC is shown in above figure. Time T is calculated for 8 bit counter with 4MHZ Clock.What is the purpose of low pass filtering a PWM source? To minimise noise produced by the PWM pulses To improve PWM efficiency To increase the amplitude of the PWM signal To rectify the PWM signal
- For a signal in the range of 6 to 63, in order to have a resolution of 0.17, we need. Number of levels Select one: a. 337 b. 338 c.333 For the device measuring temperature in the range of 36.8:44.5, and the results are stored in 5 bits, the step size is Select one: a. 0.24839 b. 0.03182 c. 2.62258A major advantage of PRTS is that they are very linear. A disadvantage is that they have poor sensitivity. Select one: True FalseFor a resolution of 0.08 V, determine the seven bit sign magnitude PCM code for a sample of -2.19Va. 0101110b. 1011011c. 0011100d. 0011011 NOTE: A bit confused regarding the sign bit 0 and 1. Does 0 represents negative (-) or positive (+)?