Given a figure shown below: Find: a. R b. All indicated current; c. V, and power consumed by the 692 resistor (P) 24V + 692 www I₁ 692 www 292 1₂ 13 www 892 wwwwwwwww 792 692

Q: A LED which bright one color when forward and another color on reverse is called * Multicolour LED O…

A: 1) in this questions, we need to find the Light Emitting Diode that emits one color when forward…

Q: on the line Express the unit vector directed toward the origin from an arbitrary point. described by…

A:

Q: A 500 V, 250 kW, long shunt compound generator induces an e.m.f. of 480 V when running at 1000…

A:

Q: A balanced load of 30 MW is supplied at 132 kV, 50 Hz and 0.85 p.f. lagging by means of a…

A:

Q: 3. A DC generator has no-load output voltage of 200 volts. Its armature circuit resistance is 0.75…

A:

Q: 120 V What is the peak secondary voltage? 10:1 transformation ratio and the diodes are silicon ellel…

A:

Q: A de generator has 4 poles and runs at 1,750 rpm. The winding is of a type that provides four…

A:

Q: 12 V Device 1 +18 V 3A 6 V Calculate the power associated with Device 1. Calculate the power…

A: We need to find out the power for given circuit

Q: An insulator in the form of a square sheet with side length L has a charge of +3Q distributed…

A:

Q: Given V₂ = -6 V, find the power (in Watts) of the element below. + Q Vx 10 -5 A

A: Given  Vx = -6 V I = -5 A

Q: Problem 03.049 - Mesh analysis: Independent voltage source and dependent current source In the…

A: Given:

Q: Write the truth table for a 3 input AND gate and sketch the appropriate logic symbol. Complete Logic…

A: As per the guidelines of bartleby i need to answer first question only so kindly repost other…

Q: 3.11 A dc generator has 4 poles and runs at 1,750 rpm. The winding is of a type that provides four…

A: Given data: Pole, P=4 Speed, N=1750 rpm Parallel paths, A=4 The flux per pole, Emf, E=230 V The…

Q: Write formulas for calculating the effective and average value of the voltage.

A: SOLUTION Find effective and average voltage formulas…

Q: 120 V * ?What type of circuit is this 00000 00000 V D₁ RL V D₁ 10kn3 Full wave rectifier O Half wave…

A:

Q: A 100 W CFL light manufactured by Buyer’s Choice consumes 23 watts andhas an illumination rating of…

A: Given- For CFL bulb- Power consumed= 23 watts Illumination rate= 1600 lumens Service life = 8000…

Q: 8. The maximum current that a 2W, 80 kQ2 resistor can safely conduct is___. 8

A: Given  P= 2 W R= 80000 Ω Find maximum current Im

Q: 49. The Internet Architecture Board is formerly known as: a. Internet Architecture Board b. Internet…

A: Internet Architecture Board: It is also called as IAB. It was originally established in the year…

Q: s] Fill the first column in the following table by one of the suitable technique according o its…

A: Communication of data refers to the transmission of data using computing and communication…

Q: Please write a short discussion for each number and explain.   1. Losses in a DC generator 2.…

A:

Q: a 50-ohm resistor is in series with a 40 microfarad capacitor across a constant potential source of…

A: In this question,  We need to determine the frequency of the circuit if current flow in the circuit…

Q: Q3) A-Draw the block diagram of successive modulation and filtering methode of SSBSC if the input…

A:

Q: * For the circuit shown, it is required to get the value of resistor which will limit the current…

A: In this question,  We need to choose the correct options What is resistance Rs  if forward voltage…

Q: A compound generator is to be operated as a flat-compounded long shunt compound generator. To obtain…

A: In this question we need to find a value of diverter resistance required to maintain no load voltage…

Q: Calculate the equivalent noise temperature of a receiver with a noise figure of 1.83 dB. No need for…

A: Given, Noise figure (NF) = 1.83 dB Equivalent noise temperature  of receiver (Teq) = ?

Q: If m(t) = A cos(wt) v, find the output signal of narrow band frequency modulation (eNBFM(t)) and…

A:

Q: Carefully analyze the circuit in Figure 2. How many possible delta connections are there and how…

A:

Q: The atomic number of silicon is 8 14 32 O 20 *< The circuit which is used to add a positive or…

A:

Q: SOLVE FOR VCE, IB, Ic, It VB, D

A: The required parameters can be calculated by using the DC analysis of the circuit.

Q: b) y[n]+ 1.2y[n-1] =2x[n-1] + x[n-3]

A: As per company guidelines we are supposed to answer only one question. Kindly repost other…

Q: A power supply produces a 0.6 W output with an input of 0.7 W. Its percentage of efficiency is A.…

A: Given: A power supply has, Input power, Pin=0.7 W. Output power, P0=0.6 W.

Q: Please show your detailed solution Number 14 The current in a series inductive circuit is 7.5 A at…

A: In this question,  We need to choose the correct options If power P= 425W And power factor = 0.47…

Q: Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a…

A: In this question,  We need to choose the correct options What is power factor of the circuit.  We…

Q: 3. Sketch the current waveform for the circuit in Figure below. The diac has a breakover potential…

A: Given data: The breakover potential, VB=20 V. The holding current, IH=20 mA. The given circuit…

Q: What value of inductance is required in order that its reactance at 580 kHz be equal to the…

A:

Q: Measure the individual current flowing through each resistor

A: It is given that:

Q: What is the “wattage” rating of a lamp whose hot resistance is 150 W when connected to a 117-V 25-Hz…

A: Given  Hot resistance = 150 ohms Voltage = 117 V Frequency = 25 Hz

Q: Zener Diodes are not working in the breakdown region O reverse biased O forward biased O zero…

A: when input voltage is positive , zener diode works as normal diode and is called forward baised…

Q: Questions 1- Draw the impedance triangle at f=1 kH

A:

Q: The circuit shown below is made of various comparator and a

A: Given:

Q: 3) For the following matrices A, compute (i.e., derive a formula for) e^t. b) for a given X E R. (1)…

A:

Q: ((ABC)' +D+E)' Solve equation using De Morgan's Theorem Draw the logic circuit diagram and truth…

A:

Q: The current io in the circuit shown is .> 0000 3A 10A SA -3A 9A O io 10Ω 50

A: The given circuit is,

Q: R(s) = G(s) s+3 s+5 Zero: s= C(s)

A: Given

Q: 1.56 Let x[n] and y[n] be given in Figs. P1.56(a) and (b), respectively. Carefully sketch the…

A:

Q: RT R1 100Ω R4 2200 R3 1500 R2 2000 R5 270Ω

A:

Q: The energy that "sloshes in and out" of a load without causing any net power transfer is called the…

A: Power:- Power can be defined as the amount of work completed in a given amount of time.  Watt (W),…

Q: b) Determine the input waveforms 4 and that pridaced the output waveforms in Figure bellow. NAND…

A:

Q: RT R1 100Ω R4 2200 R3 1500 R2 2000 R5 270Ω

A:

Q: * Which circuit is changing the shape of the input Clamper circuit O Clipper circuit O None O

A: This is the problem of application of diode. The solution is given in the next step.

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.