Answered: Give the Energy balance at an open…

Name: 4. Give the Energy balance at an open heater.
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: 4. Give the Energy balance at an open heater.

Engineering

Mechanical Engineering

Give the Energy balance at an open heater

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Derive the energy balance equation that has K, the heating rate, on the left-hand side of the…

A: The energy balance equation states that the rate of change of energy within a system is equal to the…

Q: Q1 (a) Differentiate between open feedwater heaters and closed feedwater heaters.

Q: In a geothermal power plant, vapour is converted into working fluid in the Select one:

A: Solution:

Q: A reheat cycle with two stages of reheating is executed, with steam expanding initially from 202.65…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 2. A boiler produces a steam at 2.417 Mpa and 468.9oC. The steam enters a turbine where after the…

Q: B) A heat pump that operates on the ideal vapor compression cycle with refrigerant-134a is used to…

A: given : heat pump -

Q: A two stage refrigeration cycle is shown in fig. B. The working fluid is refrigerant 134a. The…

A: Given: Working fluid-R 134A Evaporator temperature of cycle 1=-40 oF Condenser temperature of…

Q: 1. A smaller power plant produces 25 kg/s steam at 3 MPa, 600o C in the boiler. It cools the…

A: At state1, h1=209.31kjkgα1=0.001012m3kgP1=12.35 KPa At state 2,…

Q: 2. Draw and Explain Schematic diagram of Geo Thermal power plant. Discuss its advantages.

Q: In a geothermal plant operation , which device is suitable for converting vapor into liquid .…

Q: Question No.13: a.) Develop an expression for work done and COP of a vapour compression…

Q: An engine in a cycle absorbs 5000 J of heat and discard 1000 J to a cold reservoir How much work is…

A: Workdone= Heat discard- Heat absorbed...

Q: A certain power plant produces a net power output of 120 MW. The constant pressure condenser…

Q: Refrigerant 22 is the working fluid in a Carnot refrigeration cycle operating at steady state. The…

A: To Find : the coefficient of performance . Given : temp at evaporator Te=-30°C temp at entering at…

Q: Q3)The following conditions are for simple steam power plant: Equipment Turbine inlet outlet work…

A: Turbine inlet pressure P1=40 bar=4 Mpa Turbine inlet temperature T1=320°C Turbine work WT=1000kJkg…

Q: Refrigerator 2 is a refrigerator that operates as an ideal vapor refrigeration cycle, and uses the…

A: Given:The refrigerant and temperature conditions are the same as in Refrigerator 1.The compressor…

Q: An ideal gas-turbine cycle has two stages of expansion and two stages of compression. The pressure…

A: given data An ideal gas-turbine cycle has two stages of expansion and two stages of compression.The…

Q: window-mounted air conditioner supplies 19 m3/min of air at 15°C, 1 bar to a room. Air returns from…

Q: 3.) Draw a schematic diagram of a simple refrigeration vapor-compression cycle, and explain the…

Q: An air conditioner is used to cool a house. When the outside air temperature is 306K and the inside…

A: Given data: Outside air temperature is TH=306 K Room temperature is TL=295 K Cooling effect is 17 kW

Q: .Steam at 210 bar and 760 oC enters a Reheat engine and expands to 10 bar. At this point it leaves…

Q: Figure on the right provides steady-state operating data for an ideal vapor-compression…

A: Given data :- The mass flow rate of refrigerant (m) = 30.59 lb/min Determine :- a) the…

Q: The figure below shows a vapor power cycle that provides process heat and produces power. The steam…

Q: Draw the multipressure systems with cycle diagram i. one compressor and two evaporators (at same…

A: Please refer the following refrigeration cycles on P-h diagrams.

Q: A refrigerator uses refrigerant-134s as a working fluid and operates on an ideal vapour-compression…

A: (4) To find: The heat removed. Given: The higher working pressure is Ph=6 bar. The lower working…

Q: A steam turbine receives steam from a boiler at 8 MPa and 480°C. After some time, a third of the…

A: Boiler exit condition @ P[1] = 8000[kPa], T[1] = 480[C]First extraction @ P[2] = 6500[kPa]First…

Q: Question text The energy rate balance for both refrigeration and heat pump cycles takes the same…

A: Heat Pump is a device which is used to extract the heat from outside to…

Q: In basic terms explain the ideal and the actual of the following cycle 1. Reheat-Regenerative 2.…

A: The Rankine Cycle is a mechanical cycle that converts the pressure energy of steam into mechanical…

Q: Steam is supplied to a two stage turbine at 40 bar and 450°C. It expands in the first turbine until…

Q: 2-What is the principle work of the thermocouples?

Q: Give at least 3 Advantages of electrical Reheat Regenerative Cycle in Thermal Power Plant.

A: To be explained:-electrical Reheat Regenerative Cycle in Thermal Power Plant.

Q: I need correct answer in 20 minutes please Find the cycle efficiency and specific steam consumption…

Q: A two stroke spark ignition engine is running at 2000 rpm, compute the time (in milli second) for…

Q: The Working fluid in heat pumps is called _______ Which is not a thermal energy sink a.…

Q: 1. A turbine is supplied with steam at 25 BAR, 42C and exhaust into a condenser at 55 KPa. Find the…

Q: What are the basic concepts to chose the number, type and location of feed water heaters in a…

A: A feedwater heater is used in the power plant to preheat the boiler feed water. The Source of the…

Q: 10.) An ideal gas with goes thru the quasistatic cycle shown to the right. The Pabs(atm) steps are:…

Q: The heat engine has a 30 % efficiency. It could have absorbed. . KJ heat from the heat source if it…

A: Efficiency of heat engine, η=30 % Heat rejected to heat sink, QL=30 kJ

Topic Video

Question

4. Give the Energy balance at an open heater.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

T-s diagram of regenerative rankine cycle:

VIEW

Schematic representation of open water heater:

VIEW

Energy balance at an open heater:

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

please provide full calculations thank you
The coefficient of performance (COP) for a vapor compression cycle chiller is 8. If the chiller can produce 46 tons of cooling, how much electric power (in kW) does the chiller consume? Fill in the electric power of the chiller in kW.
贪411 461l1 zain IQ Asiacell M Superheating process .8 should exists for protecting the сycle. none of these answers. should not exist in the cycle to keep it working efficiently. is necessary to keep the refrigerant at low temperature. The refrigerant leaving the .7 compressor follows an isentropic process. an isothermal process. an adiabatic process an isotropic process. All specific physical quantities are .5 measured relative to
3/7 Explain the following: 1. The flue gases leaving the air heater must be at high temperature? 2. Air and Flue gases can be circulated inside the boiler with out using fans? 3. The air leaked to the steam cycle must be removed?
Choose the close thermodynamic system a. Gas turbine b. Thermo-flask c. Centrifugal pump d. Pressure cooker
Need Help from the Masters. Thank you!
Q4 Explain the Combine Heat Power Plant and its components in details.
04: A! B: Explain and draw the water circulation in H.P. steam power plants? Good Luck Head of Dept. Instructor Duof Dr Ahmed L Shkara
Work is done on a system in (mark all): a) Refrigeration cycle b) Power cycle c) Heat pump cycle
subject: thermodynamics A turbine is supplied with steam at 25 BAR, 42C and exhaust into a condenser at 55 KPa. Find the thermal efficiency of the cycle. Draw the schematic and T-S diagrams with corresponding labels.
I need the answer as soon as possible
6 In absorption cooling system, Water can never be used as working fluid. Select one: True False