Fruit juices at 30 ° C containing 5% total solids were concentrated via a single effect evaporator. The evaporator is operated in a vacuum at an evaporation temperature of 80 ° C, and 90% quality steam is supplied at 169.06 kPa. The desired concentration of the final product is 40% total solids. The rate of concentrated product leaving the evaporator is 1500 kg / hour. The specific heat of fruit juice is 4.05 kJ / (kg ° C), and the concentrated product 3.175 kJ / (kg ° C). Count A. The required steam rate is = Answererkg / hour. b. Steam economy if the condensate temperature cannot be released at 90 ° C. = Answer (kg evaporated air / kg steam)

Q: Estimate the one-dimensional heat transfer per unit area through the composite= wall in Figure 1(a).…

A: The heat flow through the plane wall is a direct application of Fourier's law. It states that the…

Q: A 2,000 lb/h solution containing 10% NaOH at 80°F is to be concentrated to 40% NaOH using a single…

A: The challenge is to use a single-effect evaporator to increase the concentration of a sodium…

Q: Calculate the energy requirement to raise the temperature of 1 kg of water from 30 ° C of water to…

A: Given that, Mass of water m = 1 Kg Initial Temperature T1 = 30oC = 303.15 K Final Temperature T2 =…

Q: Fruit juices at 30 ° C containing 5% total solids were concentrated via a single effect evaporator.…

A: Mass flow rate of product, mP = 3000 kg/h Initial solid concentration of the feed juice, xS(F) =…

Q: a single effect evaporator was used to concentrate 10 000 kg / hr of tomato juice from 5% total…

A: This is a problem related to the evaporator and heat transfer. The data given: Mass of tomato juice…

Q: Fruit juices at 25 ° C containing 5% total solids were concentrated via a single effect evaporator.…

A:

Q: Fruit juices at 20 ° C containing 5% total solids were concentrated via a single effect evaporator.…

A:

Q: Calculate AG and AS when 1 mole of ethanol is vaporized at 65 ° C and 1 atm pressure. The latent…

A: Latent Heat of vaporization of 1 g of ethanol = 200 cal  Temperature  = T  = 65 C  Molecular weight…

Q: Fruit juices at 25 ° C containing 5% total solids were concentrated via a single effect evaporator.…

A:

Q: A forward feed triple effect evaporator is used to fed 13608 kg/hr of NaOH solution containing 10…

A: Overall mass balance and heat balance are applied. Temperature change for each evaporator is…

Q: Air at 95°C and 4% RH is passed over the cooling coil so that the air dry ball temperature becomes…

A:

Q: air at 25 ° C and 50% RH is heated using a heat exchanger to 75 ° C. Using a psychometric chart,…

A:

Q: fruit juice at 25 ° C containing 5% total solids concentrated via a single effect evaporator. The…

A:

Q: Jutio How much heat is required to raise the temperature of 5 lbm of water from 50°F to 150°F?…

A: Given Mass of water m = 5 lbmInitial temperature T1 = 50 FFinal temperature T2 =150 FSpecific heat…

Q: A single effect evaporator was used to concentrate 8000 kg / hr of tomato juice from 5% total solids…

A: Given data The mass flow rate of tomato juice is (mf) = 8000 kg / hr The increase in  concentration…

Q: A laboratory runs a solid test. The weight of the crucible is 48.6212 g and the weight of the…

A: given = weight of evaporating dish = 50.3032 g / 100 mL = W1 weight of the evaporating dish and dry…

Q: In a hot air heating system, the furnace heats air from 66°F to 120°F. If the air is then circulated…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A single effect evaporator was used to concentrate 10.000 kg / hr of tomato juice from 5% total…

A:

Q: Ethane is contained in a piston/cylinder arrangement at a temperature of 100oC and a pressure of 10…

A: The temperature attained by the ethane after passing the cylinder is to be calculated for the given…

Q: Fruit juices at 30 ° C containing 5% total solids were concentrated via a single effect evaporator.…

A: Given: Fruit juice in the product of a single effect evaporator mp = 2000 kg/hr Percent solids in…

Q: A 44-g sample of liquid water at 25.0 C is mixed with 27 g of water at 45.0°C. The final temperature…

A:

Q: use the heat of formation method state the reference states and fill in the inlet-outlet enthalpy…

A: The reference states are:C2H5OH(v): 25 °C, 1 atmCH3CHO(v): 25 °C, 1 atmH2(g): 25 °C, 1 atmThe…

Q: Air at 35 C and 65% RH is heated using a heat exchanger to reach 85 ° C. Using the psychrometrio…

A: Given Data: Dry bulb temperature TDB1 = 35 °C Relative Humidity RH% = 65% Dry bulb temperature TDB2…

Q: Fruit juices at 20 ° C containing 5% total solids were concentrated via a single effect evaporator.…

A:

Q: A large vertical plate 4 m high is maintained at 60°C and exposed to atmospheric air at 10°C.…

A:

Q: A single effect evaporator is used to concentrate 8000 kg / hr of tomato juice from 5% total solids…

A:

Q: a single effect vaporator was used to concentrate 8000 kg / hr of tomato juice from 5% total solids…

A: In heat transfer, a single-effect evaporator is a simple machine in which steam provides energy for…

Q: A single effect evaporator was used to concentrate 8000 kg / hr of tomato juice from 5% total solids…

A:

Q: A single effect evaporator is used to concentrate 10000 kg / hr of tomato juice from 5% total solids…

A: Mass flow rate of feed, mF = 10000 kg/h Initial solid concentration of the feed juice, xS(F) = 0.05…

Distillation

Distillation is a process/technique to separate more volatile components from less volatile components using the principle of relative volatility. In chemical engineering, distillation is one of the most common and important topics that is involved in almost every industry and process.