60 kip The A-36 steel column is encased in high-strength concrete as shown. If an axial force of 60 kip is applied to the column, determine the required area of the steel so that the force is shared equally between the steel and 9 in. 16 in. concrete. How far does the column shorten? It has an original length 8 ft of 8 ft. Answer: 8 = 0.0055 mm

Q: Determine the stability of the wall in different conditions mentioned down in table and provide a…

A:

Q: What is the principle of automatic compensator?

A: Principle of automatic compensator:

Q: Exercise 3. Find products of powers of all variables, mªl®g°¢° A° that have only the dimensional…

A: The given variables are m, l, g, φ and A

Q: 3.00 4.00 nswer to the nearest thousandth. 3.652 4.068 2.894 1.669 -2.00 1.00→→ $32. Determine the…

A:

Q: Instructions: Convert. Show complete solutions to get full credit. 1. 265.76 deg to degree minute…

A:

Q: using suitable example differentiate direct and indirect cost (overhead cost)

A: using suitable example differentiate direct and indirect cost (overhead cost)

Q: Determine the stability of the wall in different conditions mentioned down in table and provide a…

A:

Q: 3. A cube, 7feet on each edge, is floating in a pool of fresh water. If 2feet of the cube is above…

A: Given data: Volume of cube=7×7×7 ft3 2 ft of cube is above the water surface.

Q: Distinguish between free float and total float?

A:

Q: Incorrect Solutions/Asnwer. Please resolve this! THUMBS UP WILL BE GIVEN!

A: Given:- The magnitude of the applied load (P) = 29 kN  a = 270 mm  b = 195 mm θ=70° The diameter of…

Q: Explain what are solution grouts?

A: Explanation : Solution grouts are easier to make and therefore less expensive to instal. They are…

Q: läs 10 The following elements are the project resources Time and cost Time, cost, materials Time,…

A: Project resource management refers to a set of integrated procedures that enable project managers…

Q: Q2: The following blanks should be filled with a suitable preposition. 1. Yesterday, there was a…

A: Let's understand the some preposition.  "In" is generally used for longer time like "1995" or "2005…

Q: Complete the table below. LINE BEARING DIST (M) AB N 57° 59.7° W 37.736 97.129 BC N 87° 3' E CD S…

A: Answer  Let us first calculate the latitude and departure of given lines Latitude = Lcosθ latitude…

Q: Complete the integration: 1 Scos"2niax - an2x -an'2x+c Determine the value of "?".

A: cos22x= 1-sin22x

Q: What reduction factor are we going to use if p > Pb a. 0.9 b. 0.65 c. 0.45 d. Ø= 0.65 +0.25 Ey Et…

A: Given:-ρ>ρbTo find:-reduction factor

Q: he d n or er if n or er if n e al d P2.10. Refer to Figure P2.9 for the floor plan. Calculate the…

A:

Q: Explain what this equation is about and what each parameter means. dP TiwSiw T¡Si Pig sin(0) AL dz…

A: The given equation is: dPdz=-τlwSlwAl+τiSiAl-ρigsinθ The equation refers to the pressure equation in…

Q: Front is the boundary between contrasting air masses O True O False Previous Next Not saved Subm

A: This statement is true

Q: - Two masses are attached to a uniform meter stick as shown in the figure below. The masses of m1…

A: As in question masses are given in grams, so convert it in Newton (kg*9.81). By resolving the…

Q: How to convert kPa to meter of H2O?

A:

Q: where did you get the 1.35?

A:

Q: 1. A miniature model of the famous Taipei 101 will be made by pouring plaster of Paris in a cast.…

A: Taipei: It is a skyscraper in Taiwan's Taipei area. Until the completion of the Burj Khalifa, it had…

Q: Explain in detail how you calculated to get 4.42 mpa

A: Given:- A Brazilian test was conducted  The data of the test are given To determine:- The…

Q: Write short notes on the following: a: Role of a quantity surveyor. b:Price escalation clause of…

A: "As per our guidelines we are supposed to solve first three sub parts, kindly post other sub parts…

Q: How were the equations in the table of "visual work product integration" derived? /in other words…

A:

Q: 5. Verify the identity: 1 sec x V secx + tanx tan x secx + tanx

A:

Q: need the answer as soon as possibl

A:

Q: Convert 1:120 in inches to an equivalency scale of inches to feet 1"=1440' 1"=20' 1'=10" O 1"-10% Is…

A: Given scale (S) = 1:120 in inches Convert the scale of inches to feet.

Q: Add/subtract the following by hand. State your answer in the following format: D,M,S. Ex: 45,12,05…

A:

Q: What are the values of Q1, Q2, and Q3?

A:

Q: 7- An AON diagram is different from an AOA diagram in that it can show four types of relationships.…

A: Note- Since we only answer up to 3 sub-parts, we’ll answer the first3. Please resubmit the question…

Q: CUMULATIVE CUMULATIVE SIEVE AMOUNT AMOUNT PERCENT RETAINED, PERCENT PASSING SIZE RETAINED, g (a)…

A:

Q: A pipeline is to be built from a point on the bank of an 800m wide river to a point 3km downstream…

A: Width of river, w = 800 m = 0.8 km Also, x + y = 3 km Under the river, the cost per km = $ 750000…

Q: b. What is the value of W.S. in centimeters?

A: To find:- value of W.S. in centimeters

Q: 3- is the factor affecting the measurement of standard consistency of thecement paste?

A: Introduction : A cement paste's standard consistency is defined as the proportion of water added in…

Q: The 580-kg uniform beam is sub three external loads shown. Con reactions at the support point O is…

A:

Q: What should the diameter of the steering wheel be?  Each of the arrows you see stand for force F and…

A: This question is related to the Mechanics from Civil Engineering. Given Data -  Diameter of steering…

Q: GIVEN: diameter of sewer pipe = 1.8m Depth of water = 1.6m Q = 2.5m3/s Compute the velocity. Use 3…

A: Diameter of pipe, D =1.8mThe depth of water, d =1.6mThe discharge in pipe, Q =2.5 m3s

Q: quantity suveying

A: In quantity surveying, quantity of all materials like concrete, steel, brick, paints, ceiling,…

Q: Calculate the values of Xbar and Ybar to the centre of gravity of the shape shown below. Show all…

A:

Crack Detection

Concrete materials are meant for supporting structures, building foundations and they act as several load-bearing structures. Over time, due to environmental conditions, and based on the constituent materials used, concrete materials are subjected to a great degree of distress. Corrosion of the reinforcement bars due to chemical influences, uneven base, earthquake, drying shrinkages, and alkali-aggregate reactions are some of the reasons for concrete distress.