•Write out the equation you intend to use before substituting in it.•If an equation is not used, write a short note indicating the principle used or the operation performed. Problem#4:From the figure, a cylinder weighing850 lb is held against a smooth inclineby means of the weightless rod AB.Determine the forces exerted on thecylinder by the rod and the incline.25°55°

Answered: Image /qna-images/answer/b6d2a979-d616-4602-89d7-0201c0aa8865.jpg

Answered: From the figure, a cylinder weighing…

From the figure, a cylinder weighing 850 lb is held against a smooth incline by means of the weightless rod AB. Determine the forces exerted on the cylinder by the rod and the incline.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter11: Angular Momentum

Section: Chapter Questions

Problem 24P: Repeat the preceding problem replacing the marble with a solid cylinder. Explain the new result.

See similar textbooks

Related questions

Q: 2) A train at a constant 42.0 km/h moves east for 36.0 min, then in a direction 53.0° east of due…

Q: What is the electric force from the rod on the point charge Q? Suppose that Q=15.5 nC and L = 3.67…

Q: Let's say we were to measure the force of gravity between two objects. Next we move the objects 10…

Q: The large blade of a helicopter is rotating in a horizontal circle. The length of the blade is 6.02…

A: The large blade of a helicopter is rotating in a horizontal circle.The length of the blade is r1=…

Q: A pilot is flying a plane at 220 m/s and an altitude of 500 meters. If she needs to deliver supplies…

Q: Boat A negotiates a curve whose radius is 330 m. Boat B negotiates a curve whose radius is 150 m.…

A: We know that the centripetal acceleration where, v is the speed of the boatand r is the radius of…

Q: (numbers 40-41) Use the circuit diagram shown. 40. How much power is being consumed by the 3 Ohm…

Q: What must the charge (sign and magnitude) of a 2.45 g particle be for it to remain stationary when…

A: Mass of charge ( m) = 2.45 g 2.45× 10-³kgElectric field E = 650 N/ C ( downwards)

Q: 2. Your friend is planning to ride his bike up a ramp and land on the roof of a building as shown…

A: The height of ramp is h=4 m.The horizontal length of ramp is x=3 m.The height of building is L=6…

Q: Emily Halsey banana mass M over the edge of a bridge height eight she drops a banana and it falls to…

Q: A wave with a length of 5m will likely experience more diffraction than a wave with a length of 5mm.…

A: Diffraction is the bending of waves around obstacles and spreading waves as they pass through small…

Q: How do you do part d,e, f?

Q: 7) A graduated cylinder filled with water is shown to the right. a) Measure the volume of water to…

Q: A turtle ambles leisurely, as turtles tend to do, when it moves from a location with position vector…

Q: An airplane flies with an airspeed of 50.0 m/s [E 40° N]. If the velocity of the airplane, according…

Q: The velocity of a particle moving in the xy plane is given by = 5.5 t 5.0 t²)i + 9.0 j, with vin…

Q: Defibrillator: Capacitance and energy. (a) If a 2,200-V defibrillator is designed to carry a maximum…

Q: A flat sheet of paper of area 0.335 m² is oriented so that the normal to the sheet is at an angle of…

A: The area of the paper sheet is The orientation of the paper sheet is The magnitude of the electric…

Q: 53. A simple pendulum is made my attaching a rod of negligible mass to a 2.0 kg pendulum bob at the…

Q: If 39% of the body weight is distributed above the superior surface of the L5 intervertebral disc…

A: Given:Body weight Force distributed above the superior surface of the disc Area of the superior…

Q: Find the unit vector that points from point O toward point A. 31° A 1 | 37° 1 Answers: nA/O=(i F =…

A: Write the position vectors of points O and A.Write the position vector of the line connecting point…

Q: How far from a 7.00 µC point charge will the potential be 300 V?

A: GivenCharge (Q) =7.00 µC Potential (V )= 300 V

Q: 18. Calculate the magnitude and inclination of the resultant forces shown below. 300 N 12 722 N 5…

Q: How far from a 7.00 µC point charge will the potential be 300 V? and b) At what distance will it be…

Q: An electron (q=-1.6*10^-19 C; m = 9.1 * 10^-31 kg) enters a region of uniform electric field (E =…

Q: The energy of formation of a vacancy in copper is 1.03 eV. Estimate the relative change in the…

A: The vacancies develop in the elements when the energy is provided by raising the temperature of the…

Q: A particular form of electromagnetic radiation has a frequency of 7.18 × 10 Hz. Part 1 of 3 What is…

A: 1)Write the relationship between the wavelength and the frequency. Substitute the corresponding…

Q: A cubic container of volume 2.30 L holds 0.535 mol of nitrogen gas at a temperature of 30°C. What is…

Q: Briefly explain the differences between Rayleigh, Tyndall and Raman light scattering.

A: Rayleigh, Tyndall, and Raman scattering are three different phenomena related to the scattering of…

Q: In nuclear fission, a nucleus splits roughly in half. a)What is the potential (in V) 4.50 ✕ 10−14 m…

Q: A parallel plate capacitor has plate area A and spacing s. (A) What is the capacitance? (B) Find the…

Q: A 0.11 kg apple falls off a tree branch that is 2.2 m above the thick grass. The apple sins 0.065 m…

A: Mass of apple ( m) = 0.11 kg Height of tree branch ( h ) = 0.065 m Sinks distance of apple ( d ) =…

Q: If a bulb of resistance 45.0 Ω is connected to a 4.50-V voltage source, what is the power produced…

A: The resistance is The voltage source is

Q: After a 7.04E-3 F capacitor is fully charged by a 7.52 V battery, what is the energy stored in this…

A: Capacitance (C) = 7.04E-3 F = 7.04 × 10-3 FVoltage across capacitor…

Q: A charge of -4.43nC is uniformly distributed along the x-axis from X = 0 to X = 24cm. A charge of…

Q: When Babe Ruth hit a homer over the 7.9 m -high right-field fence 94 m from home plate, roughly what…

A: for projectile motion equation of motion can be written as,The horizontal motion equation: The…

Q: mass, m=1.50 kg, is attached to a spring that has a displacement function given by the following…

Q: Part A A signal is traveling at 90% of the speed of light. How many feet can the signal travel in 10…

A: Write the given values to the suitable variables.Here, v is the time.

Q: A remotely controlled toy car travels along a straight line and its position changes with time…

A: Position as a function of time,

Q: In the figure here, a ball is thrown up onto a roof, landing 4.40 s later at height h=20.0 m above…

Q: A plane is flying directly into a headwind at 300.0 km/h relative to the air. The air is blowing at…

Q: A friend drops a .625 kg ball from 2.2 meters above you. Determine the force that you have to exert…

A: Given that, the mass of the ball is m=0.625kg. The height of dropping the ball is H= 2.2…

Q: An onject is dropped from a height of 86.3 m above ground level. a. Determine the distance traveled…

Q: A parachutist whose mass is 60 kg drops from a helicopter hovering 1000 m above the ground and falls…

A: The equation of the motion are: (equation 1) (equation 2)Newtons law…

Q: 23. Crank ABC is subjected to force P as shown in the figure. Knowing that P must have a 200 N…

Q: Problem 9: A secret agent skis off a slope inclined at 0= 29.9 degrees below horizontal at a speed…

Q: A hot-air balloon is rising upward with a constant speed of 2.39 m/s. When the balloon is 6.74 m…

A: Initial velocity of hot-air balloon is in upward direction.Height from the ground is From the…

Q: Early researchers were very excited when they were able to predict the energy of an electron at a…

Q: A 12 V ·9 B EXAMPLE Headlight openstax™ What if-q = -3000 C? How much energy does the battery…

A: Given - q = -3000C ∴ q = 3000 C Voltage of battery Vo= 12 V

Q: The upward normal force exerted by the floor is 620 N on an elevator passenger who weighs 650 N.…

A: Draw the free-body diagram of the system.

Concept explainers

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics.

Equilibrium of Forces

The tension created on one body during push or pull is known as force.

Question

•
Write out the equation you intend to use before substituting in it.
•
If an equation is not used, write a short note indicating the principle used or the operation performed.

Problem#4:
From the figure, a cylinder weighing
850 lb is held against a smooth incline
by means of the weightless rod AB.
Determine the forces exerted on the
cylinder by the rod and the incline.
25°
55°

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data

VIEW

Step 2: Here the system is in equilibrium, hence the net force any direction is zero.

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Determine the magnitude of the acceleration of point C. Express your answer to three significant figures and include the appropriate units. • View Available Hint(s) ? m ac = Value S
Determine the n- and t-components of the force F which is exerted by the rod AB on the crank OA. Evaluate your general expression for F = 118 N and (a) 0 = 23°, B = 18° and (b) 0 = 23°, B = 35° B Answers: (a) Fn = N (b) Fn- = N i i -x N, Ft= i N, Ft= i
A spade is modelled as a uniform rod, of mass 2kg and length 90cm, attached to a uniform square lamina, of side 20cm and mass 0.5kg. A gardener holds the spade horizontally with hands 30cm and 60cm from the end of the rod. Find the vertical forces exerted by the gardener's hands. Im stuck on this q, pls help.
A cylinder having a mass of 40kgs with a radius of 0.5m is pushed to the right without rotation and with an acceleration of 2m/s^2. Determine the location of the horizontal force P if the coefficient of friction is 0.30
The fishing pole in the figure makes an angle of 20.0o with the horizontal. What is the torque exerted by the fish about an axisperpendicular to the page and passing through the angler’s hand if the fish pulls on the fishing line with a force of 100 N at anangle 37.0o below the horizontal? The force is applied at a point of 2.00 m from the angler’s hands.
A 208N force is applied to a 0.93m long uniform rod (shown in the figure) at the end opposite the pivot point. The angle 01 is equal to 25° and 02 equals 67°. 02 Pivot point The magnitude of the torque due to F about some pivot point is determined by T| = rFsin0. Determine the magnitude of the torque, T, on the rod about the pivot point due to F.
The cable AB prevents bar OA from rotating clockwise about the pivot O. If the cable tension is 740 N, determine the n- and t- components of this force acting on point A of the bar. 1.6 m B Answers: Tn' i 9 Tt= i II = 1.2 m 61° N N
A 1204-N uniform beam is attached to a vertical wall at one end and is supported by a cable at the other end A 1515-N crate hangs from the far end of the beam. Find the magnitude of the tension in the wire. The angle theta (9) is 29 degrees and the angle phi () is 53 degrees. The length of the beamis L Вeam ROUND OFF FINAL ANSWER TO THE NEAREST WHOLE NUMBER. INPUT THE SYMBOL OF THE UNIT. NO SPACE BETWEEN THE NUMBER AND THE UNIT.
The cable AB prevents bar OA from rotating clockwise about the pivot O. If the cable tension is 820 N, determine the n- and t- components of this force acting on point A of the bar. A 2.0 m B Answers: Tn= i Tt= i 1.6 m 74° N N
In the following mechanism, T1 torque and F1 force act on the AB link. Equilibrium conditionSCD according to the superposition principle, the magnitude of torque required to be applied to the CB.obtain by making drawings? (F1 is vertical from mid point of ABIt is applied directly) O=40⁰, CB=3m, AB=2m
Determine then- and t-components of the force F which is exerted by the rod AB on the crank OA. Evaluate your general expression for F = 100 N and (a) 0 = 19°, ß = 16° and (b) 0 = 18°, ß = 35° %3D F B -x Answers: (a) Fn = i N, Ft = i N (b) Fn = i N, F = i N
A 1350N window washers platform, 3.5 m long is suspended by two vertical wires at its ends. A 600N person is standing 2.0m form the right end. What are the tensions on both sides in two wires?