frequency of vibratic

a. What is the ideal mechanical advantage of this system? The inclined plane dimensions are 7.2 meters length and 1.8 meters height.b. What effort force is required to move the 600N create? c. In practice, you need to supply an effort force of 75 N to lift the crate. What is the efficiency?d.  How could you redesign this compound machine so that the effort force needed was 50 N in practice? Assume the efficiency is your response from part C no matter what changes you make. Be specific with the changes you propose (if you add pulleys state how many, if you change the inclined plane dimensions state the new dimensions, etc.).

Write net torque and net force equation for a simple seesaw system

Provide any six important skills required for the design of plant layout and piping design.

Problem- Cargo ships can cause a lot of air pollution.Solution-  to use nuclear powered ships since they hold a lot of energy and can travel for long distances. How it will work is that it will need a nuclear reactor at the bottom of the boat to heat up the water and then turn it to electricity to power the boat. The boat will be made out of graphene which is a tough material to avoid any leaks in the boat. It will also contain many control rods because nuclear power is so powerful that it can create to much energy to handle. With control rods, you can slow down this process and keep it in a controlled manner. Since cargo ships are already is the ocean, there will be no need for any extra materials to make it work. -Do you think this will work? Why/Why not?  -What do you think is wrong with it/ How can this be improved? Please send this to someone else I need to record 50 responses for a science project. Thank you!

Develop a LabVIEW code of a wire cutting system. Include screenshots.

Paula has worked for Brindle Corporation for 3 years.  During this time, she has worked as a machine operator/cell leader in various work cells.  Recently, the plant went to mandatory 12-hour shifts and plans to remain on this schedule for several months.   Paula’s present work cell is manufacturing 3-inch diameter exhaust tubes that are made from stainless steel.  These tubes get a hole punched in them, a flange welded on, and burrs ground off.  The pipe then gets placed into a gage to check that it was made correctly.  (The tubes weigh about six pounds.)   Paula has been performing the welding operation.  She leans into the machine and loads the part into a fixture then positions the flange.  Both pieces are clamped (using hand clamps) into position and the machine is cycled by depressing two palm buttons.   The gaging operation requires placing the finished part into the gage and clamping it (using hand clamps) into place. A pin is depressed to verify the position of the hole and a…

C. List products or services that do not exist, but you would like to see made available. 1. 2. 5. 3. 4.

Paula has worked for Brindle Corporation for 3 years.  During this time, she has worked as a machine operator/cell leader in various work cells.  Recently, the plant went to mandatory 12-hour shifts and plans to remain on this schedule for several months.   Paula’s present work cell is manufacturing 3-inch diameter exhaust tubes that are made from stainless steel.  These tubes get a hole punched in them, a flange welded on, and burrs ground off.  The pipe then gets placed into a gage to check that it was made correctly.  (The tubes weigh about six pounds.)   Paula has been performing the welding operation.  She leans into the machine and loads the part into a fixture then positions the flange.  Both pieces are clamped (using hand clamps) into position and the machine is cycled by depressing two palm buttons.   The gaging operation requires placing the finished part into the gage and clamping it (using hand clamps) into place. A pin is depressed to verify the position of the hole and a…

use this logo and explain for saftey