for the following voltage and current phasors, )calculate the apparent power in VA. V = 140 20⁰ Vrms I = 15 2 I= 15 2 )calculate the real power in Watts. 9⁰ Vrms V = 189 2 59⁰ Arms 2 41⁰ Arms 3) calculate the apparent power in VA. V = 138 20⁰ Vrms I=14 Z 2 42⁰ Arms

Q: 9.26 (Properties) Sketch each signal and then find its Fourier transform. (a) x(t) = r(t)…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Find the voltage across and the current through the capacitor both at = 20 µSec. 2m 5V 2n + 3~ Z…

A: To Find: The voltage across the capacitor at t=20 μs Current through the capacitor at t=20 μs…

Q: A shunt motor on a 240- V line has an armature current of 75 A. If the field- circuit resistance is…

A:

Q: Consider the circuit in (Figure 1). Suppose that i = 4.0 A. Figure 25 Ω 502 ww {100 Ω la 2002 www 1…

A:

Q: REVIEW Refer to the National Electrical Code or the working drawings when necessary. Where…

A: Here it is asked to solve question (2), so we are solving that question only. Given information to…

Q: II. PREPARATION A. You will use a basic meter movement having Ifs= 25 mA and internal resistance of…

A:

Q: minimum SOP

A:

Q: Example 9. Determine I, V₁, V₂, and V for the series dc configuration of Fig. 2.25

A:

Q: An industrial heater has a nameplate that reads: 1) What is the real power? 225 Vrms 51 Hz 190 kVA…

A: Given, An industrial heater has a nameplate reads:- 1)  225 Vrms 51Hz 190kVA 0.86 lagging 2)  195…

Q: 2. Find Vo using (a) node analysis, and (b) loop analysis. Verify Tellegen's theorem 12V 3 ΚΩ 4 ΚΩ…

A: Given: A network, To find: a) Voltage V0 using node ananlysis, b) Voltage V0 using mesh ananlysis,…

Q: V1= - 10 sen(wt + 30°)V  y   V2 = 20 cos(wt - 45º)V  Find=  v1+v2

A: Introduction A voltage that oscillates in a sinusoidal pattern over time is called a sinusoidal…

Q: QUESTION 3 Find the height of an infinitely long conductor from point P which is carrying current c…

A: Given: Current, I=6.28 A Field intensity=0.5

Q: 6. For this waveform, find I(s). A) I(s) = 10/s B) I(s) = C) I(s) = (10/s) [e-²s - e-³s] D) I(s) =…

A:

Q: Use a 560 nFnF capacitor to design a low-pass passive filter with a cutoff frequency of 59…

A: In this question we need to design a low-pass passive filter with a cutoff frequency of 59 krad/s

Q: Find the inductance of a solenoid 50 cm long and 4 cm diameter wound with 2000 turns of wire

A: Given- The length of the solenoid, l = 50 cm Diameter, d = 4 cm Radius, r = 2 cm Total number of…

Q: 2) Complex Power A load operates at 240V RMS. The load absorbs 8 KW at a lagging power factor of…

A:

Q: Find the Thevenin equivalent from the terminal a and b. Data: R₁ = 49, R₂ = 211, R₂ = 6N, R₁ = 29,…

A:

Q: For the circuit given below, find the Thèvenin equivalent at terminals a-b, where R = 30. Please…

A:

Q: sin(t-2). 2. Calculate the Fourier transform (X(jw)) of x(t): x(t) = (2) Determine @M, such that for…

A: The above question is based on the Fourier transform of sinc function and application of Nyquist…

Q: Find the total steady-state error for the system below if the input is 5u(t) and the disturbance is…

A:

Q: 17. For the set of input waveforms in Figure 3–83, determine the output for the gate shown and draw…

A:

Q: 6 differences in electrical engineering principles in theory from practice?

A:

Q: Consider the circuit given below. 892 ww 592 8 A M 292 If /= 2 A, determine the voltage vx in the…

A:

Q: Consider the circuit in (Figure 1). Suppose that i = 4.0 A. Part A Use the mesh-current method to…

A: It is given that:

Q: The circuit in Fig. 5.79 is for a difference amplifier. Find vo given that v1 = 1 V and v2 = 2 V.

A:

Q: You are designing a 2nd order unity gain Tschebyscheff active low-pass filter using the Sallen-Key…

A: Given: A 2nd-order unity gain Tschebyscheff active low-pass filter using the Sallen-Key topology.…

Q: 3. A square loop whose sides are 10 cm is placed inside a uniform magnetic field that is increasing…

A: Given data Sides of the square loop, a=10 cm Rate of change of magnetic field, dBdt=0.5 T/s (a)…

Q: Ro U9 + I

A: We need to find out the value of unknown resistance and maximum power for given resistor in the the…

Q: incorrect. answer should be 7.18 MHz please resolve.

A:

Q: Convert the following decimal integers to 12-bit two's complement form. Show your work as most…

A: Given the following decimal integer 1023 -1984    To convert into 12 bit 2's complement form

Q: Draw (a) a logic diagram using only two-input NOR gates to implement the following function F(A, B,…

A: Given the  FA,B,C,D=A⊕B,C⊕D

Q: what will happen to frequency if load increases ?

A: Given: What will happen to frequency if load increases?

Q: Exercise 1 A three phase, 400 kV, 50 Hz, 1000 km long line is operating with VS =VR = V = 1.0 p.u.…

A: Solution of question (1): Given information is written below. Length of the line is l=1000 km. The…

Q: R₁ = 240 Q NC 120 V / 12 V D₂ D₁ D₂ Voltage range: From DA R₂ = 1 KQ Potentiometer C₁ C₁ 220 μF 0.1…

A:

Q: ■mple 6. For the series de configuration of Figure etermine V₁, VŔ, and I. +0.5 V ID↓ Si +51 VD +…

A:

Q: can you please elaborate on how you got the equations? if its nodal analysis can you explain it in…

A: It is given that: Assuming the opamp to be ideal. Eo=6 V and e1(t)=4cos(t-90) V

Q: Show the complete steps and the small signal model to derive the equation that represents the…

A:

Q: x@y xy (x©y) z (x@y)z (x@y)2 + xy •C

A:

Q: The output expression of the given circuit.

A: Given- Logic circuit,   To find- The output expression.

Q: 100 V + 千 560 0

A:

Q: 3 ● Row 1 2 4 5 6 7 8 9 10 11 12 13 14 15 Refer to the National Electrical Code® or the working…

A: Here it is asked to solve question (2), so we are solving that question only. “Since you have posted…

Q: For the circuit shown (Figure 2), determine the range (i.e., maximum and minimum values) of V₁ such…

A:

Q: A power grid is to be created in a city. There are several buildings and there are paired…

A: According to the question, A power grid is to be created in a city. There are several buildings and…

Q: 4mA ↑ Ⓒ ins lka ka 12 222mA m 4A) A lkn = I₂ Eselivered 00 -47 V₁=0.20 10 -112V/₂=16.4V 2 O O 03-2-4…

A: Given Data: A DC circuit with known values of, Node voltages Mesh currents Tellegan's Theorem: It…

Q: Recommend general considerations when selecting a site for generating station.

A: We need to tell about general considerations when selecting a site for generating station.

Q: 1. Which of these expressions describes the waveform shown? A) v(t) = 5t [u(t)- u(t+2)] V B) v(t) =…

A: Introduction A unit step signal, which is also referred to as a step function or unit step…

Q: Find the supply voltage, 'V' shown in the circuit, if I = 20 mA, R1 = 10 kO and R2 = 36 kO. | 12 |…

A: Given, Circuit is given as, Circuit current, I=20 mA. Resistors, R1=10 kΩ, R2=36 kΩ.

Q: 5. V(s) = 5 + 6/(s+4)-7s/(s²+25) Find v(t) -4t A) v(t) = [5 8(t) + 6 e4 – 7 cos(5t)] u(t) V B) v(t)…

A: Inverese Laplace transform formulae used in this problem are as follows.

Q: Find the Thevenin and Norton equivalent circuit at terminals a-b for the circuit shown below, where…

A:

Q: Filter functions like as sed and awk are often used when it comes to formatting data contained…

A: We need to tell whether the given statement is correct or wrong.