For the following feedback system choose the correct closed-loop poles.RoE(2s+15)1SO Ys+6controllerProcessO 0, -6O 15/6O -3, -5O None of the aboveO -15/2O 0, -6, -15/2

First calculate closed loop transfer function and then equate denominator to get closed loop poles.

Answered: For the following feedback system…

For the following feedback system choose the correct closed-loop poles. RoE (2s+15) 1 S s+6 O Y controller Process O 0, -6 O 15/6 O -3, -5 O None of the above O -15/2 O 0, -6, -15/2

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Q1: The total harmonic distortion of a closed loop system is 5%. Distortion without feedback is 10%.…

Q: Q5: A linear feedback control system has the block diagram shown in figure 1. Using block diagram…

A: Control systems are represented by transfer function. This can be written in both time domain and…

Q: The open loop transfer function of a unit feedback control system is given as G(s) = as +1 2 s². The…

A: Given- Open loop transfer function of a unity feedback system, Gs=as+1s2 Phase margin, P.M.=45°.…

Q: Cascade Compensation is done by connecting the compensator of a Control system O in parallel with…

A: Cascade compensation means adding block in series with gain block.

Q: An op-amp differentiator circuit is configured as having a O capacitor as the input element and…

A: Find the explanation below

Q: Q-3: A- (a) The closed-loop gain of a negative-feedback amplifier is Arg -80 and the open-loop gain…

Q: K Open loop transfer function of a unity feedback system is (1–S)* he closed loop pole to be at S=2,…

A: Given: Unity feedback system OLTF=K1-s Pole of closed loop at s=2

Q: What is value of K so that phase margin will be 60 degrees.

A: Given open loop transfer function is - Gs=Ks+53 Given phase margin is - Phase margin=60o

Q: A closed-loop control system has a forward loop with a gain of 6 and a feedback loop with a gain of…

Q: 12. It is the ratio of the Open loop differential gain and the Common Mode gain Common Mode…

Q: +1 R 0.5 0.5 H Figure 1 a. What is the direct transmission gain from input R to output C? b. What is…

A: Here we discuss about the concepts related to the block diagram of the control system. NOTE :-…

Q: Consider a system with no zeros and only one pole as +5. Place this system in the forward path of a…

A: Here the system has only pole at +5. So G(s)=1s-5 Also the PD controller has Kp=300 and…

Q: Fill in the blanks with the most convenient answer: The main problem with .... s that control…

Q: The type of the feedback in this circuit is:

A: In the given question we need to discuss about the type of feedback in system.

Q: In a positive feedback system ,the error can be calculated by subtracting the feedback value with…

A: Feedback systems are an important part of control system. The feedback system is either positive or…

Q: Q- 1. Match the Following: SN Component 1 Comparator Double ended Differential 2 mode of operation…

Q: In Negative Feedback Amplifier the gain without feedback is 100. Feedback ratio is 1/75 and if the…

A: Given: Av=100β=175Vin=100 mV

Q: Given the information appearing in the multiple-feedback BPF, calculate fo

A: The cutoff frequency can be calculated by using the general expression of multiple feedback band…

Q: edback system has the following open-loop poles: -2+j1, -2-j1, -0.2. The a

Q: Q) Find the type of negative feedback in the given circuit Find the type of the feedback in the…

Q: relative change in gain with negative feedback given that the return ratio d the feedback factor is…

A: Return ratio (Aβ) = 24 Feedback factor = 3 Open loop gain A = 2

Q: QUESTION 1 A unity feedback system has open loop transfer function shown below. Find K1 so that the…

A: Given, Open loop transfer function of the system, HGs=k1ss+k1k2 ζ=0.4tp=2 sec

Q: 11. Which block diagram shown below best describes a band pass filter? Vout С. Vin A. Vin Vout OVout…

A: 7- The conditions set by Barkhausen criterion for feedback type oscillators are as follows: 1- The…

Q: e feedback control system mu

A: To explain the correct option as,

Q: (B) The state space representation for a closed loop system is shown in figure (5): 1. What is the…

Q: a) An operational amplifier with non-inverting voltage feedback is given in Figure Q4.a. It has the…

A: An op-amp circuit is given as shown below. Open loop gain, AOL=100000 Open loop output impedance,…

Q: Problem 6. A feedback loop has the three stages shown. Find the operating point and the open-loop…

A: From the given loop: y=2-x z=y√3 x=z2 From the above equations: (z/√3)= 2-z2 Solving this quadratic…

Q: Q-3: A- (a) The closed-loop gain of a negative-feedback amplifier is AFg = -80 and the open-loop…

A: For negative feed back , closed loop gain with feedback AFB = A1+Aβ From above , feedback factor β =…

Q: 168 (b) The midrange open-loop gain of a certain op-amp is reduces this gain by 60 dB. Calculate the…

A: Given: AOL1=168dB After feedback, the open-loop gain reduces by 60 dB so a new open-loop gain will…

Q: of a A Cascade Compensator is connected Control system in both forward and feedback path of the…

A: to predict the answer

Q: In Figure is given. 12- R(-) Y() O A) Open-loop system with single input and single output O B)…

A: For the given system, the loop is absent. Hence it is not a closed-loop system. Now, it has only one…

Q: feedback system root locus graph shown in figure below. he angle of departure theta= 12 10 8. 6. 4 2…

Q: The negative feedback closed-loop system was subjected to 15V. The system has a forward gain of 2…

A: It is given that:

Q: A ramp input applied to an unity feedback system results in 5% steady state error. The type number…

Q: determine the ransfer function of this system using block diagram transformations like moving…

Q: 1. The control block diagram for a standard op-amp circuit is illustrated in figure (a) Find the…

A: In this question we will find transfer function of opamp.....And will make it to unit gain negative…

Q: Consider the unity feedback system with open loop transfer function shown below. Find the breakin…

A: In this question, Find the breakout point This is unity feedback system with open loop transfer…

Q: 2020/2021 Q5: A linear feedback control system has the block diagram shown in figure 1. Using block…

Q: what will happen to the feedback fraction and frequency of oscillation of the circuit when the…

Q: What is the closed loop transfer function?

A: The closed loop transfer function can be obtained by reducing the series connected block first and…

Q: Describe the Block diagram reduction Rules 10 and 11 (eliminating negative feed and positive…

Concept explainers

Differential amplifier

There are two amplifying stages with common degeneration in a differential amplifier.

Question

For the following feedback system choose the correct closed-loop poles.
RoE
(2s+15)
1
S
O Y
s+6
controller
Process
O 0, -6
O 15/6
O -3, -5
O None of the above
O -15/2
O 0, -6, -15/2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An amplifier has an open loop gain of the value equal to 1. Determine the gain when 0.5 % of negative feedback is introduced.
Determine the phase margin (PM) of a unity gain feedback control system given the following open loop transfer function. G(s) = 1.15/(s + 1) a. 150⁰ O b. 0⁰ OC 60° Od. 180° O e. 30⁰ O 1.90⁰ O g. 1200 Clear my choice
1.
For a lead compensator whose zero is (-2,0) is used in a feedback control system to provide a phase lead of 45 .for desired pole location (S1=-2+3.3j), that represents the design specifications, this compensators pole is at
In which type of feedback the output value is subtracted from the input value ? a. Positive Feedback O b. No feedback O c. Negative Feedback O d. Linear Feedback
A ramp input applied to an unity feedback system results in 5% steady state error. The type number and velocity error constant of the system are respectively 1. 2. 3. 1 and 20 0 and 20 0 and 4. 1 and 1 20 20
Need typed solution of all the three parts correctly
The type of the feedback in this circuit is: VDD lin M X Rp1 M₁ Select one: O a. series-shunt t feedback O b. shunt-shunt O c. series-series feedback O d. shunt-series feedback - Vout
I need the answer quickly
Linear Feedback Systems
Please solve this problem I do not understand If my answer is true, solve it clearly please as my question is clear.