For the following closed traverse find the Azimuth of Line ED in the closed traverse if angle X was 65o 43'? Note: write the answer in degrees format (i.e 20o 30' can be written as 20.5 degrees) * 5 B D E Point A D E Angle 71• 45' 00" 147 57' 00" 132° 15' 00" ? 107° 33' 00"

For the following closed traverse find the Azimuth of Line ED in the closed traverse if angle X was 65o 43'? Note: write the answer in degrees format (i.e 20o 30' can be written as 20.5 degrees) * 5 B D E Point A D E Angle 71• 45' 00" 147 57' 00" 132° 15' 00" ? 107° 33' 00"

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: PROBLEM NO. 05. Given the following tabulated data for a close traverse in which the lengths of BC…

Q: The angles about a point R have the following observed values. A = 120°5’ 20”, B = 132°27’30”, and C…

Q: Compute the angle (0) from the below figure: A(11150.509, 11825.802) B(11807.821, 11582.456) 402…

A: Coordinate (x,y) = (Departure, Latitude) To Determine Angle (θ) from the given figure.

Q: Question 8 A survey is performed on a closed traverse as shown in the Figure below. Assume line AB…

A: A closed traverse ABCDEFA as shown in the figure.Where,Also,FB of AB (True east).To find: Azimuth…

Q: Q2: In the traverse below, find the length of CD, so that the point ADH will be on one line Line…

Q: Given the balanced Azimuths for the 4 sided traverse below, calculate the new internal angles.…

Q: Question 6 Lay out the traverse for the following. Does it close? What is the angular error? Station…

Q: Q1: for the traverse in the table below: 1- Draw a sketch 2- Balance the angles 3- Compute the…

A: Disclaimer “Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: 19. Adjust the Close Traverse shown belo Azimuth (from Course Length, m North) AB 493.01 4°02' BC…

Q: 2. Adjust the angles to substitute for the misclosure. misclosure #of angles) Misclosure correction…

A: As per authoring guidelines, if the question number is not specified, the first question or three…

Q: SITUATION 1- Hissing Data Given: Traverse with omitted measurements. (a) Calculate the distance of…

A: A closed traverse is given in tabulated form and it has been asked to determine missing data. Please…

Q: Reduce the set of profile notes in Table 2-7, and perform the arithmetic check.

Q: Station Sight (+) Stadia Sight (-) Stadia Elev. ВМА 510,38 6,920 6,240 5,360 5,470 4,210 4,330 TP1…

Q: A closed traverse has the following data: Lat=-0.65, Dep=+0.34 Σ[LAT]=1726.8, Σ[DEP]= 1876.3,…

A: Objective: To determine the corrected latitude of given course using Transit Rule. Given: Total…

Q: A closed traverse was surveyed and the resulting values of latitudes and departures were computed.…

Q: 3. From Figure 3.1 calculates angular error, traverse accuracy, adjusted coordinate (N, E), adjusted…

A: Data givenFind:(a) Angular error(b) Traverse accuracy(c) Adjusted coordinate(d) Adjusted distance(e)…

Q: N88 28' 24"E A B 258.182 M A traverse from A to H is shown from the S87' 33' 16"E figure below.…

A: (a) Adjust the traverse by compass rule Latitude = L cos θ Departure = L Sin θ Lines Distance…

Q: Survey Example Problem Interior Line Correction New Station Angle Length (L) Factor Interior Angle A…

Q: X8-1. The adjusted clockwise interior angles of a traverse which originates and closes at point A…

A: Given:

Q: 3. From Figure 3.1 calculates angular error, traverse accuracy, adjusted coordinate (N, E), adjusted…

A: Data given Find: (a) Angular error (b) Traverse accuracy (c) Adjusted coordinate (d) Adjusted…

Q: Problem 2: Calculate the correction in Latitude and Departure using a) Compass Rule and b) Transit…

Q: Please answer letter a. Compass rule , In EF length 1127.26

A: To find corrected latitude and departure

Q: Line Length Bearing meter S 80° 46' W N 40° 00' W АВ 550.63 ВС 295.08 CD 610.19 Unknown DE 886.17 S…

A: As the length and the bearing of the lines are given: Calculating the missing bearings of CD and GA.

Q: Given the following data of a closed traverse LINE DISTANCE (m) BEARING 1-2 42.2255 N 17°35' E 2-3…

Q: Adjust the data of a closed compass traverse. Tabulate the adjusted directions of each line ab bc cd…

A: Convert the data in whole circle bearing: Line Length FB BB FB-BB AB 330.75 34o55' 215o 180o5'…

Q: Situation 4] From the given data ofa dlosed traverse, The adjusted bearing of BC using compassrule.…

Q: 7 Line AB BC CD DE EA Dist. 55.70 55.50 36.30 58.10 47.40 AZIMUTH-NORTH forward 115-30 32-10 327-06…

Q: (Q1) Compute the coordinate of point P in the below figure, if you know the azimuth of AB equal…

A: azimuth of AB = 240010'05" co-ordinates of A =(1372.71, 1215.30) θ1=113056'39" θ2=92020'18"…

Q: Balance by the compass rule the traverse data tabulated below. Also determine the corrected length,…

Q: Balance the traverse by compass rule. b) Calculate the coordinates of each station.

A: Lattitud and departure signs . N- E: Both positive S-E : Lattitude negative , Departure positive S-W…

Q: A closed traverse has the following data. Find the length and bearing of side EA

A: To find length and bearing of side EA

Q: From the field notes of a closed traverse shown below, adjust the traverse. Lines Bearing Distances…

Q: Adjust the traverse using the TRANSIT RULE, and determine the following:a) azimuth (from north) of…

Q: LINES BEARING DISTANCES АВ N 53°27' E 59.82 m. S 6°54' E S 29°08' W ВС 70.36 m. CD 76.62 m. DA N…

Q: ADJUSTMENT. Trace accurately the traverse 15. GRAPHICAL plotted below and perform the reguired…

A: Introduction- The Guide survey is a simple and frequently used method for establishing the relative…

Q: Problem 4 From the closed traverse data shown. (Note: In the computation of latitude, departure,…

A: Azimuth from south is given, so first convert it into bearing. LATITUDE = LCOSθ DEPARTURE = LSINθ L…

Q: The following are the incorrected consecutive coordinated of a traverse. Adjust the traverse by…

A: Line Latitude Departure Northing Southing Easting Westing AB +21.500 -65.450 BC -80.755…

Q: LINES BEARING DISTANCES АВ N 53°27' E 59.82 m. S 6°54' E S 29°08' W ВС 70.36 m. CD 76.62 m. DA N…

Concept explainers

Traverse Survey

Traverse surveying is a popular method of surveying. Traversing is that type of survey where several connected survey lines form a framework and the directions and lengths of the survey lines are measured with the help of a tool to measure angles and tape or chain respectively. Traverse networks involve placing survey stations in a queue or trail and using pre-tested points as a basis for looking at the next point. This type of surveying is different from Tacheometric surveying, where only angles are measured and the process of chaining is reduced.

Question

20
For the following closed traverse find the Azimuth of Line ED in the closed traverse if angle X
was 65o 43'?
Note: write the answer in degrees format (i.e 20o 30' can be written as 20.5 degrees) *
B.
А
D
E-
Point
A
B
D
E
Angle
71. 45' 00"
147° 57' 00"
132° 15' 00"
107° 33' 00"

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Note: Use sketch wherever necessary! (Q1) Compute the coordinate of point P in the below figure, if you know the azimuth of AB equal (αAB= 240°10′05") and horizontal distance pf line CP equal (Scp=250.34 m). P(?, ?) C(?, 1227.52) 82 01 B(1030.10, ?) A (1372.71, 1215.30) 01- 113°56'39" 02 92°20'18"
The interior angles of a triangle were measured as follows Compute the most probable value of angle A. a. 41deg 85’ b. 41deg 41’ c. 40deg 46’ 9” d. 39deg 41.2’
: Determine the graph and conversion of the following angles.1. Convert the following azimuth 190º15.40'45” to heading.2. Graphic 66º7´9”3. Convert the following heading S 74º9'30” W to azimuth.4. Convert the following azimuth 200º46´7.12” to heading.5. Graph 245º52´14”
A closed traverse shown has the following data: LINES BEARING DISTANCE AB S 15*38' W 24.22 m BC S 69*11' E 15.92 m CD N 57*58' E DA S 80°43' W 1. Find the distance CD in meters. a. 81.20 m b. 34.67 m c. 77.48 m d. 59.01 m 2. Find the distance DA in meters. a. 61.89 m b. 49.18 m c. 50.28 m d. 75.02 m 3. Find the area in a. 512.37 m2 m. b. 1123.61 m2 C. 191.99 m? d. 1315.60 m?
3. The following data if a closed traverse is shown in the technical description. The area of the closed traverse is 63147.05 sq. m. LINES AB BC CD LAT. a -240.20 -160.00 DA 179.70 Solve for the unknown variables. DEP. 120 с e -220 DMD b d f 8 2A 26460.0 X -86480.0 39534.0
No.5 only!!
HI! HELP ME PLEASE. TYSM.
V;19 | ZAO N O o GOX U | KOREK Traverse_ho... 0:- The table below shows the ficld measurements for a traverse A, B.C. D, E, if the Azimuth of AB = 290" and the coordinate of point A (1000, 1000) . Calculate the coordinates of all stations of the traverse. Point Line Length(m) Azimuth Angle to the right A AB 50 290 B 90 BC 65 95 CD 61 D 120 DE 50 E A
Q. Compass. Survey.
Problem 5 For the given data of a close traverse, determine the missing distance of course CD and the bearing of course DE, solve the AREA using DPD. Sketch the traverse. LINES DISTANCE (m) BEARING LATITUDE DEPARTURE DMD DOUBLE AREA 56 N 33°10' E AB вс 5 76°16' E 95 CD 5 21°38' E DE 46 EF 67 N 81°51' W FA 105 N 23°01' w Area =
P2 89°50" 268° 81°35' Y, 185°35' 102°10' 95°5' 80°25' P4 P3 270°30' 90°25' 191°
A traverse was done by a group of civil engineering students. The folowing measurementswere recorded. Refers to the figure below.a. Calculate the azimuth and bearing of the traverse lines. b. Adjust the traverse by compass rule. c. Calculate the area enclosed by the traverse. Use DMD method. d. Calculate the coordinates of all stations if TP has N = 1230.014 and E = 9180.017Note: Tabulate your calculations.