for the circuit sh reference thresh
Q: A three-phase, 60-Hz, 765-kV transmission line has an inductance of 1.0071 mH/Km per phase and a…
A: It is given that: f=60 HzV=765 KVL=1.0071 mH/km per phase=1.0071×10-3 H/km per phaseC=0.0099 μF/km…
Q: Find the load voltage V₁, the load current / L, and the current supplied by each cell in the battery…
A:
Q: Q2: The value of Electric field is given as E = 100ap -200ap +300az V/m. Find the incremental work…
A:
Q: An infinite length line conducts current along the Y axis. The current is unknown but the magnetic…
A: According to ampere circuital law.
Q: ME. 15. A square surface with one edge at 1.2 meters is oriented with its normal unit vector…
A: We need to find out electric flux Passing through the given surface
Q: Q6: Two mutually coupled coils, A and B, are connected in series to a 360 V d.c. supply. Coil A has…
A: Given Two mutually coupled coils. we need to determine the mutual inductance and coefficient…
Q: What is the frequency corresponding to a wavelength of 1 meters?
A:
Q: Hand written plz 41) Find 16 (joil & 2 (6(ja) For S G = D(D²+ 100)
A:
Q: A permanent-magnet moving-coil instrument has a moving coil of 4 cm height, 8 cm width, 3000 turns…
A: In this question we will find deflecting torque for given PMMC...
Q: A. Given the sinusoidal current I(v)=5 cos(30t+10°) A, Find : c) Angular frequency a) The amplitude…
A:
Q: Q3/The BCD7421( 1001 011 in hexadecimal number O 56 O 60 O 134 O None of them O 96 O 65
A: In this question we will convert BCD to hexadecimal...
Q: (A) 0.114 mA. (B) 0.172 mA. (C) 44.7 μΑ. (D) 160 μA. (E) 69.0 μA. &1 1₁ www R₁ R₂ ww 11.50
A: We need to find out current for given circuit
Q: 13. How can three separate lighting circuits be served with only four wires?
A: By connecting circuits in parallel, three separate lighting circuits can be served with only four…
Q: The most usual form of op-amp package
A:
Q: A 10KVA single-phase transformer provides a no-load secondary voltage of 110 volts. If the…
A:
Q: (3-a) Is this an analogue or digital electronic problem? Explain the difference.
A: It is a digital electronic problem
Q: Q7/Chose the correct answer for the output G of the following circuit ( Assume that A= 111100 B=…
A: Given A digital logic circuit is given . We need to find the output of the circuit. Please find the…
Q: Get the block diagram and transfer function of the following diagram
A: The given circuit of a DC generator is shown below. It is asked to find the transfer function and…
Q: A 5000-KVA 230/13.8-kV single-phase power transformer has a per-unit resistance of 1 percent and a…
A: In this question we need to find a equivalent circuit referred to LV side of transformer , voltage…
Q: What is Photovoltaics (PV)? What are the advantages and disadvantages of using solar energy? How…
A: Photovoltaic cell is also called a solar cell. It is generate the electricity with the presence of…
Q: Find Lx and Rx for the Maxwell Bridge circuit if that is balanced for R₁ = 50 kn, R₂ = 8.2 kn, R3 =…
A: In this question we need to find the value of Lx and Rx for the given Maxwell bridge circuit.
Q: 83. The power input to a 6 pole, 3 phase, 50 Hz induction motor is 42 KW; the speed is 970 rpm. The…
A:
Q: Given the equation of the magnetic field H= 3y2z ax +2 By (A/m) find the current density J = curl(H)…
A: In this question, We need to choose the correct options What is current density J?
Q: (2-a) Determine the Q point, then illustrate it on the transistor I-V characteristic curves. (2-b)…
A: In the above given question they have mentioned a common emitter transistor circuit. Here our…
Q: W W R₁ R₂ E If E=49 V, R1= 15 Ohms, and R2= 70 Ohms, find the total current in Amperes.
A: Given, The circuit is E=49 VR1=15 ΩR2=70 Ω
Q: Q3: Region! (x0) is dielectric with & Find Eti, E1, E2, D2, D2, D2 3, region2 (x<0) is a perfect…
A:
Q: Q5/Find the solution of the following operation for binary numbers 11010.101- 100101.010…
A: In this questions we need to perform the binary substraction using 2 complement method.
Q: Q8/F(A,B,C,D)= [m(0,2,5,8,10,13)+[d(1,7,12,15) G(A,B,C,D)= [m(6,7,11,12)+[d(0,2,3,8,13,15) Chose the…
A:
Q: The converter that employed to vary the root mean square voltage across the load at constant…
A: an ac chopper is a thyristor power converter that converts a fixed voltage, fixed frequency ac input…
Q: Calculate the r.m.s. value of the induced e.m.f. per phase of a 10-pole, 3-phase, 50Hz alternator…
A: It is given that: P=10 polesf=50 HzSlots/pole/phase=m=2Slot/pole=2×3=6Total slots=2×10×3=60Total…
Q: A 5.0 MHz magnetic field travels in a fluid for which the propagation velocity is 10x10 m/sec.…
A:
Q: In a 3-phase, 4-wire system, the line voltage is 4157 V. What is the line to neutral voltage?
A: Given VL = 4157 V
Q: HOW TO EXTRACT THE VALUE OF C 1 F 2J√L.C 1 04*10 2+√ 3 1* 10³² *C
A:
Q: Q3. Using the prir ple of superposition, determine voltage drop across the resistor R3 (61.) of the…
A: In this questions we need to find the voltage across resistor R3 using super position theorem. In…
Q: A will light two different colors, such as red or green, depending on the direction of the current…
A: .........will light two different colors, such as red or green, depending on the direction of the…
Q: If a signal x(n) is passed through a system to get a output signal of y(n)=x(n+1 then the signal is…
A: In this question we will write about given signal...
Q: 4/ The Output of function F is: 2X1 € don't care ${ 2X1 Max 2X1 Mux 4X1 Mux A B
A:
Q: Explain amplifier characteristics and how the practical characteristics differ from the ideal…
A: Two distinct questions are here. In the first question, the ideal amplifier characteristics need to…
Q: Q1/The binary number ( 1011011011011.1110111100111)=( ) in octal number O No one of them O…
A:
Q: 1. For unsymmetrical analysis in power system why we use operator a? 2. In Delta connected load,…
A: 1. The operator "α" stands for an abbreviation for showing a difference phase shift of 120 degrees.…
Q: 2-d) Draw a complete small signal circuit model, then find the voltage gain. Explain two…
A:
Q: H.W: Find the Laplace Transform of the following: 1. te-3t sin 2t 7. $ 10-11₂ -3t sin 2t dt eje 8.…
A: NOTE: As per our company guidelines we are supposed to answer only first three sub parts. Kindly…
Q: Problem #4: If a motor has a slip of 2% at rated voltage, determine the value of the slip when…
A: The induction motor Torque is directly proportional to product of slip and square of applied voltage…
Q: Verify that the message signal is recovered from a modulated DSB signal by first multiplying it by a…
A: Given: Message signal m(t) recovered from a Modulated DSB signal. Required: The message signal is…
Q: For the following sequence {3.2,-2.2,-1.5,1.4,1.89,3.3…}, Quantize it using a uniform quantizer in…
A: Given,The sequence is,=3.2,-2.2,-1.5,1.4,1.89,3.3…The range of the quantizer is,=-3, 3total levels…
Q: Problem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is…
A:
Q: Q7/Chose the correct answer for the output G of the following circuit (Assume that A= 111100 B=…
A:
Q: 2. Describe what a zero-voltage drop could be.
A: Zero- Voltage Drop : When reaches the negative terminal of a battery, the voltage in any circuit is…
Q: 9) When a capacitor is connected to an a.c. supply the current (a) leads the voltage by 180° (b) is…
A:
Q: Q6) The cable between two electric transmission towers has a length ends under a tension P (Fig. 5).…
A: Given data is shown below. Length of cable l=2000m Density p=8890 kg/m3 Natural frequency 0≤ω1 to…
Step by step
Solved in 2 steps with 1 images
- Convert the circuit from a T to a pi configurationCurrent Attempt in Progress In the figure R₁ = R₂=4.502, R3-7.202, R4 3.80, R5 1.302, and R6 R7 Rg=8.802, and the ideal batteries have emfs 1 = 26 V and 82-8.3 V. What are the (a) magnitude and (b) direction (up or down) of current is and the (c) magnitude and (d) direction of current i2? What is the energy transfer rate in (e) battery 1 and (f) battery 2? Is energy being supplied or absorbed in (g) battery 1 and (h) battery 2? (a) Number i (b) (c) Number (d) O (e) Number i (8) O (f) Number i (h) O O R₁ R₂ www R₂ R₂ Ro Units Units Units Units ww www R₂ R₁ 4 8,0 342 R₂ O OFind IA, IB, IC, V1kohms, V5.1kohms, and V2kohms
- I need answer with explaination In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltageWith V1, voltage peak to peak is 10 volts, R1=200 Ohm, R2=1000 Ohm and C1= 300 nF. Find Vx, voltage across the the capacitor, C1 and R2 when the frequency is 1000 Hz and 10000 HzProblem: 25 mH m Find Leq In below figure. 10 mH m 60 mH m 20 mH m 30 mH m -o b L 0000
- A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?Calculation for DC Equivalent Circuit and ac Equivalent Circuit(b) Figure Q5(b) shows a 3.5 km long single phase distributor supplied two loads. The loads connected to point B and C are as follows: Point B - 120 A at 0.9 lagging power factor • Point C - 150 A at 0.85 lagging power factor The line resistance and reactance are 0.05 N and 0.15 Q per km respectively. If the voltage at the far end is maintained at 230 V, (i) Calculate the total voltage drop. Calculate the voltage at point B, VB. (iii) Calculate the the sending voltage, VA. (iv) Calculate the sending end power factor.