For the circuit below, calculate E, equivalent circuit resistance (RT), the load voltage (VLoad), and the average power converted by Rload (PLoad) if the potentiometer wiper is at the:1)Top, 2)Middle, 3)Bottom Esupply =49V Rsupply=2k Rpot=14k Rload = 6k Rsupply

What is the voltage, current (amps) on all the resistors and the equivalent resistance?

2) Calculate the total current (IT)? C1 0.1μF 14V 15 kHz C2 0.047µF R1 47002 R2 33052 www. 8 0.22pF R3 8052 IT=

Using the formulas found in question 1, compute the amount of capacitive  current  needed in the circuit  to correct the power factor to 90%.

5. How do the 2 different voltmeter readings compare to each other and to the voltage predicted by circuit theory? MacBook Pro

. Calculate the load power for the circuit Vs 120 Vac RL 300 N

1. Calculate the outputvoltage for the circuit as shown. 10K 1.2K 12V o- 22K 100K 100K 10K 9V o 18K 12K 2.2K 47K 33K 1.5K -5V -

how to control load voltage using hysteresys band in this buck converter 2 volt to fullfil Vload = 75v?

Can I get a step by step please? TIA

Determine the voltage output from a Wheatstone bridge if four active strain gages are used in an initially balanced bridge to measure a strain of 750 µɛ.  Assume that a digital voltmeter (Rin = infinity) will be used to measure the output voltage and that Sg =2.01   and the supply voltage is 10 volts.  Assume that each gage resistance is 350 ohms.     14.06 mv     7.538 mv     28.12 mv     15.66 mv     3.246 mv