For the, 1060 H18, aluminum beam and loading shown, the beam is of rectangular cross-section with following dimensional parameters: b = 6", h = 10", 1 = 500-in4, Q = 75-in³,

Q: Confused where the value 2.64 came for vb. You say vb equals 2.64 but also 4.08

A: vb = 2.64 instead of 4.08 m/s.

Q: In Figure 2, solve for the force which will act on the glass window and locate the center of…

A: Given: To find the force and center of pressure.

Q: d the resultant and its orientation.

A: given

Q: S0ON so

A:

Q: can someone draw figure for this based on the solution given

A:

Q: ال الثاني ON is the resultant of four forces, one of these forces is unknown Find t e and its…

A: GIVEN:

Q: Ten and one-half foot-pounds of work is required to compress a spring 2 inches from its natural…

A: Given data  Work = 10+1/2 (lb-ft) Initial compression = 2in  Find the work required to compress the…

Q: Convert each temperature. 22 °C to K (approximate room temperature)

A: Given, temperature = 22oC we know 1oC = 273 K

Q: How much change in the power of wind will take place if wind velocity becomes 3 times and blade…

A: To determine the change in power of the wind if the velocity of the wind becomes 3 times and length…

Q: Find the measure of the angle (in degrees) made by the resultant of the concurrent forces with…

A:

Q: QUESTION If a vector is multiplied by a scalar: O Then its magnitude is increased by the square root…

A: Vector: A vector is a quantity which has both magnitude and direction. The notation of vector is →…

Q: find area between line y=-2+x and y=x^(1/2) and x-axis

A:

Q: 9. Find the volume of a hollow sphere if it's inside diameter is 1 inch and the outside diameter 5…

A: The volume of a hollow sphere can be obtained using the formula,

Q: Direction: Locate the center of gravity in figures A & B by putting a dot or a point in each of the…

A:

Q: It is the property of the body to resist a rotation.   Rotational KE   Moment of torque   Moment…

A: Property of body which resist the  rotation is moment of inertia  Rotational kinetic is energy of…

Q: In the compressor, the exit area should be smaller than the inlet area due to increasing the liquid…

A: A compressor is a device that increases the pressure of a working fluid by reducing the volume of…

Q: The piston diameter of a 6-stroke 1-cylinder gasoline engine is given as 4.25 inch mm, the piston…

A:

Q: Find mobility

A: Solution: The mobility of the given mechanism is calculated through Grubler's criteria: M = 3 (n-1)…

Q: I need to lift a large engine block but at my age, I can only create 160lbs of force. I will build a…

A: Let F1 =160lb L1 =Distance between fulcrum to F1 F2 = 575lb L2=1.5ft As we know that the moment at…

Q: find the fbd solution

A:

Q: Find the volumes of the solids generated by revolving the shaded regions The x-axis The y-axis

A:

Q: 1. A tank contains 8733 lbs of water at room temperature. How many hours would it take to empty the…

A: According to the given dataamount of the water in the tanklwe need to find the time to empty the…

Q: y F1 = 15000 N 40° F2=26000 N 12 30° F3 =36000 N Find the direction of the resultant force 15.7°…

A: As given in question, Force F1 = 15,000 N Force F2 = 26,000 N Force F3 = 36,000 N   Hypotenuse of…

Q: Find the center of gravity of a spindle that is 26 cm diameter at 12cm length, 6 cm diameter at 7.5…

A:

Q: Relate what is happening between the pressure, area and force in the following illustrations: 2.

A: Pressure= Pressure is the result of applied force per unit area. Area= It is the area which is in…

Q: 7. Construct the third projection of the solid.

A:

Q: Hello, I need help with the answer of 3.14 from the picture, please.

A:

Q: The white petrolatum has specific gravity of 0.850 , what is the weight of this substance needed to…

A: GivenS.G=0.850volume V=2 fluid ounce

Q: can you solve second problem, i asked for two solutions to two problems

A:

Q: 6. Given two projections of the solid, construct the third one. O

A:

Q: Force is the quantity of the matter owned gravity. True

A: Given Data⇒ Definition of Force

Q: The white petrolatum has specific gravity of 0.850, what is the weight of this substance meeded to…

A: Given:Specific gravity of white petroleum is 0.852 fluid ounce=59.147 ml

Q: Can you please do 5.67.   Thx

A: Draw the free body diagram.

Q: How do you solve for the resultant forces?

A: The component of forces in x-direction, Fx=20cos70+50cos20=53.825 lbs   The component of forces in…

Q: Solve it Properly and with right answer.

A: Case-1 Given data: The inside diameter is, di = d. The outside diameter is, do = 1.5d. Calculate…

Q: The signboard with a mass of 100 kg (with center of mass at point G) is to be attached to the rod AB…

A: Given:-m=100 kgA=(0,0,0)B=(0,2,0)C=(1,0,2)D=(-2,0,1)To find:-Tension in rods BC and DBReaction at A

Q: A circular section of lawn on a golf course needs to be watered with 2 inches of water per week. If…

A: The diameter of the circular section is 100 feet. The circular section needs to be watered with 2…

Q: The parameter of a single-degree-of-freedom system are given by m=1 kg, c=5 N-sec/m, and k=16 N/m.…

A:

Q: 5. Given two projections of the solid, construct the third

A: The given solid :                 Given question : Two projections of the solid are given, construct…

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.