For same power transfer, same material and same length and same power loss. If the voltage is increased by 4 times. What will happen to the area of cross section of conductor?

Q: A 200V, 50 Hz single-phase supply feeds the following loads : a) Fluorescent lamps taking a current…

A: Given: Voltage, V=200 V frequency, f=50Hz Load currents: Current in fluorescent lamp for leading…

Q: Implement the following function using minimum number of CMOS transistor gates: f = x₁ * x₂ + X3 X4

A: We need to design the given Boolean function by using of CMOS .

Q: Given the boolean function: F (A, B, C, D) = m (1, 2, 3, 4, 6, 7, 8, 9, 11, 12, 13, 14) Implement…

A:

Q: 5. The switch in the circuit below was in position 1 for a long time before moving to position 2 at…

A: We need to find out current through inductor for given circuit.

Q: sensors

A: Given :- Different types of Sensors. To Find :- Explain these Sensors with the examples. Solution :-…

Q: 3 tof estion If the spectrum of the message signal is as shown Select one: O a. O b. The message is…

A:

Q: Question-9. A dc shunt motor develops 10 bhp at 600 rpm, when drawing 18 A at 500 V. Find the…

A: (1) The output rating of the motor is,  Pout=10  bhp In SI unit, the output power is,  1 bhp=745.7…

Q: An analog voltage in the range 0 to 9.6 V is divided in 16 equal intervals for conversion to 4-bit…

A: It is given that:- Range of Analog voltage = 0 - 9.6 V It is divded into 16 equal intervals for…

Q: n 10 ed out of question ed 11 out of question 12 d out of question Coherent demodulator cannot be…

A: The given problem is from amplitude modulation of communication system. The detailed explanation is…

Q: need to find the following items: 1) the current supplied by the source 2)the impedance seen at…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: is it possible you can work in multi-sim?

A: Given, We need to implement it in multisim.

Q: What is the main challenge for Anaerobic Digestion(AD) systems in the United States?

A: The main challenge for Anaerobic Digestion (AD) systems in the United States:   Variability in…

Q: 2. Use Cramer's Rule to solve for currents i and i₂ of the given circuit. 12v 12Ω 32v 2702 330 450

A:

Q: The damping ratio of a vibration system with damping is 0.3. The maximum value of the frequency…

A: In this question,  We need to choose the correct option What is resonance frequency.  If damping…

Q: Answer the following question 1. With two resistances connected in parallel a) The current trough…

A: In this question,  We need to choose the correct options.  We know  Ohms law  Current in the…

Q: A triangular voltage wave has a periodic time of 3/100 s. For the first 2/100 s of each cycle it…

A: We need to find out average value and RMS value and form factor for given waveform .

Q: Can Ohm's Law be applied to a capacitor in an alternating current circuit?

A: Ohm's Law:- Under the assumption that all physical parameters and temperatures remain constant,…

Q: Compare the dielectric and all other properties of solid, liquid and gaseous dielectric materials?

A: Dielectric materials are non-conductive. They are insulating and poor electrical conductors. Mica,…

Q: I₂ www 2024 ΤΩ www 0.21, www A. Rs ploy superposition to determine the individual contribution from…

A: We need to find out the current for given circuit by using of superposition Theorm .

Q: 4. A single phase, 60Hz, 20-km short transmission line supplies a load of 700 MW at 0.95 lagging pf…

A:

Q: Find the Norton and Thevenin equivalent of the circuit in the figure as seen by looking into…

A:

Q: 3. Determine the output voltages (Vol) and (Vo2) and current (I) for the circuit shown below. 20 V…

A:

Q: Given a Cosine signal whose amplitude is 5 volt RMS, and frequency of 1 cycle per second, determine…

A: Given data The amplitude of the cosine signal is, Arms=5 V. The frequency of the signal is, f=1…

Q: Thévenin's Theorem and Norton’s Theorem What is/are the advantage/s of using the two theorems in…

A: Thevenin theorem: Thevenin theorem states that a 2 terminal network containing linear &…

Q: The figure below shows a wire that forms a semicircle of radius R=10. 0 cm  and two straight…

A:

Q: Fill in the timing diagram for a falling-edge-triggered J-K flip-flop. (a) Assume Q begins at 0. (b)…

A:

Q: A 3-phase squirrel cage induction motor draws 10 kW from mains when loaded at a slip of 0.05. The…

A: Given: A 3-phase squirrel phase induction motor having, Input power, Pin=10 kW Slip, s = 0.05 Stator…

Q: An AM modulator op 10cos (200xt) and the modulation index is a 0.5. Determine the efficiency. Select…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: In the circuit, ε = 1.2 kV, C = 6.5 mF, R₁=R₂=R3=1 MQ. With C completely uncharged, switch S is…

A: Given data, Emf ε=1.2 kV Capacitance C=6.5 mF Resistance R1=R2=R3=1 MΩ Circuit:-

Q: Suppose that the instantaneous voltage on a 50 transmission line is given by the following equation,…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: With reference to the attached circuit image: If the capacitor is now removed from the attached…

A: Given, The given circuit diagram,

Q: PROBLEM 2: Consider the circuit shown below and assume Vs(t) = 9V, Is(t) = 0.25A, R₁ = 100 S2, R2 =…

A: In d.c. analysis, under steady state condition, a capacitor will behave as Open circuit. The voltage…

Q: In reference to the attached sample circuit: If the capacitor is now removed from the attached…

A: The given circuit is as shown below,

Q: etermine the I 1010 + 492 The value of RN is - valent at terminals a-b for the circuit in the…

A: Norton's current is short circuit current at load terminal. Norton's resistance is the equivalent…

Q: INSTRUCTION: 1. Choose one (1) real-world application of typical digital signal processing and…

A: It is asked choose any one of the real world application of typical digital signal processing. Also…

Q: Calculate the energy stored in a 1000 μF capacitor at t = 50μs if the voltage across it is 1.5 cos…

A: Given,Capacitor, C=1000 μFTime, t=50 μsecVoltage across capacitor, Vc=1.5 cos105t V

Q: CLK 0 CLK D I: L

A: The truth Table of D flip flop Clk D Qn+1 Remarks 0 x Qn No Change 1 0 0 Reset 1 1 1 Set

Q: The switch shown in the circuit below has been closed for a long time prior to t= 0. Then, it opens…

A: When the circuit is closed for a long time, the inductor will behave as short-circuit. The circuit…

Q: Question-9. A dc shunt motor develops 10 bhp at 600 rpm, when drawing 18 A at 500 V. Find the…

A: Given - Output of dc shunt motor =10 bhp, Input current = 18A, Input voltage = 500 V,   To find -…

Q: A simple buck converter operates with a 50 kHz switching frequency and a de input voltage of V₂ = 40…

A: Buck converter Given Input voltage Vg =40 V operating frequency fs =50 kHz Output voltage =V =20 V…

Q: 1. A 100 resistor and a 20 a resistor are connected in series with a 6-V source. What is the voltage…

A:

Q: Voltage Trace Measure Save/Recall Auto- scale Time Setup Display Cursors Print Utility

A: The functions of the signs or menu buttons present in the figure representing an oscilloscope are…

Q: 2. a) Draw the diagram of a 16-bit microprocessor with a 32 bit address bus and 16 bit data bus…

A: According to the question, we need to show the interface of the 16-bit microprocessor with given RAM…

Q: All the logic functions can be implemented with only NOR Gates. (.........) Simpler logic circuits…

A: Since you have posted the multiple questions so we are supposed to answer 3 subpart. NAND and NOR…

Q: Size the feeder conductor appropriate for the following motor loads : (a) 460 V, 3-phase, 10 hp, (b)…

A: The given motor load is  (a) 460 V, 3-phase, 10 hp  Table 430.250 of NEC  is shown below:  Using…

Q: Q21. Consider a star-connected system with a reactance of 692 and resistance of 892 per phase is…

A: It is given that:- R = 8 ohm/phaseXL= j6 ohm/phaseVL =440 V

Q: You have been asked to investigate the loading effects on an alternator supplying a load and also…

A:

Q: 5) Change the 14p to 14 peso The CONPOWER electricity company charge 14p per kilowatt hour.…

A: Given: Oven: 2 kW, 2 hours Light bulb: 80 W, 3 hours Microwave: 700 W, 30 min Guitar: 15 W, 15 min…

Q: A 1002 resistor is connected in series with a pure inductance of 31.4 mH and the circuit is…

A:

Q: In the circuit shown, the switch has been in position a for a very long time before it moves to…

A: In this question we need to find the current and voltage across the inductor for the given…

Motor Load, Torque, and Power Quality Requirement

An electric motor is a gadget that changes electrical energy into mechanical energy over to follow up on a mechanical burden. The weight set on the motor because of this mechanical movement is known as motor load. Appropriately matching the motor burden to the engine is vital to forestall harm to the engine or wasteful and unnecessary expensive activity. Engines perform such undertakings as moving a thing starting with one spot then onto the next, cutting it, changing its shape, etc. The motors might be evaluated as far as a few variables including power yield, voltage, current, and temperature. Harm to an engine might happen when it is worked under over the top engine load contrasted with its appraised limit.