oys.karabuk.edu.tr/mod/quiz/attempt.php?attempt=12019&cmid=15692&page=4ubeOKHaritalar A (99+) Academia.ed...KBUZEM Türkçe (tr) ▼50_Power Electronics_1Derslerim / Çeşitli / MÜHENDİSLİK FAKÜLTESİ / Elektrik Elektronik Mühendisliği (İngilizce) / E2E350_Power Electronics_1 / 10 NisaFor controlled half wave rectifier, R=84ohm, f=50Hz and Vm=280V and a=1,5 rad.Calculate the average load voltage (V).In your calculations, take 3 digits after the comma and take pi = 3,14; Enter your answer into the system in terms ofthe desired unit only as a number.Yanıt:Sonraki sayfa

Answered: Image /qna-images/answer/c3be593c-5814-4cc3-9898-66817a3562d2.jpg

For controlled half wave rectifier, R=84ohm, f=50Hz and Vm=280V and a=1,5 rad. Calculate the average load voltage (V). In your calculations, take 3 digits after the comma and take pi = 3,14; Enter your answer into the system in terms of the desired unit only as a number. Yanıt:

For controlled half wave rectifier, R=84ohm, f=50Hz and Vm=280V and a=1,5 rad. Calculate the average load voltage (V). In your calculations, take 3 digits after the comma and take pi = 3,14; Enter your answer into the system in terms of the desired unit only as a number. Yanıt:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: For controlled half wave rectifier, R=80ohm, f=50Hz and Vm=280V and a=0,2 rad. Calculate the power…

A: We need to find out power absorbed by load .

Q: A single phase half wave controlled Rectifier has 400 sin 314 t as the input voltage and R as the…

A: Given: Input Voltage = 400sin(314t), type of load is resistance, SCR firing angle = 600. Need to…

Q: For uncontrolled half wave rectifier, R=80ohm, L=0.15H, f=50Hz and Vm=311V. Calculate the average…

A: R=80ohm, L=0.15H, f=50Hz and Vm=311V.

Q: For half wave rectifier output graph, find the rms value of the voltage

Q: An alternating voltage, given by v = 100 sin 314t is connected to a full-wave rectifier. The average…

A: In this question we will find avrage value of output in full wave rectifier..

Q: For a half wave controlled rectifier VS = 50 sin wt , α = 30° and load of 20Ω Find 1. Vav 2. Vrms 3.…

A: Note: As per our honor code, we are authorized to answer up to 3 sub-parts, we’ll answer the first…

Q: Vin + D₁ . + C₁1 RL Vout The rectifier above drives a 950- load with a peak voltage of 3.15V. For a…

A: Solution: Given Data: →Peak Voltage=3.15V→Smoothing…

Q: What is the fundamental frequency of the output voltage of a three-phase half-wave rectifier with a…

A: Given: The mains frequency is, f=56 Hz,

Q: Vin D₁ C₁ RL + Vout The rectifier above drives a 640- load with a peak voltage of 3.75V. For a…

Q: QUESTION 10 What is the PIV thru each diode? Use approximate diode model. 110Vrms 5:1 O 31.11V O…

A: In this question we need to find the PIV of the given bridge rectifier.

Q: en For uncontrolled full wave rectifier, R=80ohm, L=0.05H, f=50Hz and Vm=288V. Calculate the…

Q: Diode model with large reverse resistance, Please choose one: a. it is a practical model b. is the…

A: Correct option is D) it is full model

Q: A single phase full wave bridge rectifier is used to supply power. If resistive load of 8.5 ohm from…

Q: The basic reason why a Full-wave rectifier has half the ripple factor of a Half-wave rectifier is…

Q: The AC and DC power of the rectifier circuit are 322 Watts and 254 Watts respectively. The…

Q: A single-phase half wave controlled rectifier, operating at 120 V rms and 60 Hz ac supply, has a…

A: Given a single phase half wave controlled rectifier has, Operating voltage, Vrms=120 V Peak voltage,…

Q: Sir For uncontrolled half wave rectifier, R=80ohm, L=0.15H, f=50HZ and Vm=311V. Calculate the rms…

Q: Q3) If one of the diodes for the single-phase rectifier is damaged as shown, the output voltage will…

Q: For Ideal controlled rectifier which one of the following statement is correct? O a. RF and TUF…

Q: 55. A half-wave rectifier circuit is shown in the figure. The minimum reverse voltage rating (V) of…

A: In this question we need to choose a correct option

Q: Vin + D₁ . 19 - + RL Vout The rectifier above drives a 950- load with a peak voltage of 3.15V. For a…

Q: di nden sayfa uyurular For uncontrolled half wave rectifier, R=80ohm, L=0.15H, f=50Hz and Vm=311V.…

A: We need to find out the average value of current for given rectifier.

Q: A single-phase full bridge uncontrolled rectifier is supplied by 220 V (rms) line voltage . The load…

A: The supply current I(s) is a pure sinusoidal because the application of sinusoidal voltage to the…

Q: • Sketch the output voltage of the given circuit assuming that the diode is silicon. Indicate the…

A: We need to find out the output voltage and we need to draw it .

Q: For the full wave rectifier circuit, the voltage regulator value is 0. Discuss what could be the…

A: Need to analyze the given block diagram and identify the error in the given circuit.

Q: 02:- Find the level of F, for each circuit shown in the Fgure below. Also, determine the status of…

A: When number of diodes are in parallel, diode getting highest forward voltage will on. If a diode is…

Q: For controlled half wave rectifier, R=44ohm, f=50Hz and Vm=280V and x=0,9 rad. Calculate the average…

A: In this question we need to find the average voltage at load side

Q: What is the average voltage of the rectifier’s output voltage Vo?

A: In this question we need to find a average output voltage of the given rectifier

Q: A transformer with 440/340 line voltage ratio is used in a three phase half wave rectifier. The load…

Q: The half wave rectifier is supplied with 110V, 70Hz signal. Assume the number of turns in the…

Q: For the bridge rectifier shown, assume R₁ = 1.2 kn, C = 100 μF, Vin=220 Vrms, f=60 Hz, turns…

Q: A single-phase full bridge uncontrolled rectifier is supplied by 220 V (rms) line voltage . The load…

A: In this question we need to find a average output voltage of single phase full wave rectifier.

Q: A single phase half controlled bridge rectifier is used to supply power. If resistive load of 14 ohm…

A: In this question, semi converter or single phase half controlled bridge rectifier is given..We have…

Q: For uncontrolled half wave rectifier, R=80ohm, L=0.15H, f=50Hz and Vm=311V. Calculate the average…

A: To calculate the average current for an uncontrolled half-wave rectifier, we can use the following…

Q: For controlled half wave rectifier, R=80ohm, f=50Hz and Vm=280V and a=0,2 rad. Calculate the average…

A: It is given that: R=80 ohmf=50 HzVm=280 Vα=0.2 rad=0.2×180π=11.46°

Q: al How wave Graercise b) How many rectifier many rectifier c) Explain wildth 2 have dia des have…

A: 1)the three-phase diode rectifier converts a three-phase AC voltage at input into the DC voltage at…

Q: + R + Vin Vout 5 V =

Q: The half wave rectifier is supplied with 230V, 70HZ signal. Assume the number of turns in the…

Q: What is the peak output voltage for this half-wave rectifier? Express answer in Volts (primary…

Question

oys.karabuk.edu.tr/mod/quiz/attempt.php?attempt=12019&cmid=15692&page=4
ube
OK
Haritalar A (99+) Academia.ed...
KBUZEM Türkçe (tr) ▼
50_Power Electronics_1
Derslerim / Çeşitli / MÜHENDİSLİK FAKÜLTESİ / Elektrik Elektronik Mühendisliği (İngilizce) / E2E350_Power Electronics_1 / 10 Nisa
For controlled half wave rectifier, R=84ohm, f=50Hz and Vm=280V and a=1,5 rad.
Calculate the average load voltage (V).
In your calculations, take 3 digits after the comma and take pi = 3,14; Enter your answer into the system in terms of
the desired unit only as a number.
Yanıt:
Sonraki sayfa

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data and what we need to find

VIEW

Step 2: Finding average output voltage Vo

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the barrier potantial of silicon diode at room temperature?
For half wave rectifier circuit shown below Is = 5sin(wt), ripple factor = Is R. O a. 2,5 Ob. 1.21 О с. 1 o d. 2.1
The single-phase half wave rectifier is suppling an (RL) load. Assume that power is equal to 1500 , where R=3Ω, a=π/6 and β=2π/3. find maximum voltage.
Electronic
i need the answer quickly
Electronic
For the figure shown, If SCR 3 and SCR 4 are conducting. The output voltage of three phase controlled rectifier is 1 3 云太 dc 4 本

A FW rectifier outputs 48VDA with 10% ripple on a 7.5Ω resistor. is requested. Identify the capacitor providing these values (capacitance and ripple current - ripple current). Identify the necessary welding transformer for 120VAA 60Hz welding.
Vin + D₁ K C₁RL + Vout The rectifier above drives a 950-2 load with a peak voltage of 3.15V. For a 100-µF smoothing capacitor, calculate the ripple amplitude if the frequency is 50 Hz. (Assume VD,on = 0.75 V)
For uncontrolled full wave rectifier, R=44ohm, L=0.05H, f=50Hz and Vm=299V. Calculate the amplitude of the 2nd ac voltage (V) term of the output voltage. In your calculations, take 3 digits after the comma and take pi = 3,14; Enter your answer into the system in terms of the desired unit only as a number.