Following graph is obtained when AC passesthroughVoltageCurrentBr/2wtO a. resistor and inductorO b. inductorО с. сараcitorO d. Resistor

Answered: Image /qna-images/answer/31b9bcde-8e7b-4f74-b917-80290532dbe6.jpg

Answered: Following graph is obtained when AC…

Following graph is obtained when AC passes through Voltage Current 7/2 3n/2 wt O a. resistor and inductor O b. inductor О с. сарасitor O d. Resistor

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter33: Inductors And Ac Circuits

Section: Chapter Questions

Problem 25PQ: A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH...

See similar textbooks

Related questions

Q: Alternating current (AC), rather than direct current (DC), is used for the distribution of electric…

A: We need to mention the True and false statements.

Q: An AC voltage source, with a peak output of 262 V, is connected to a 33-2 resistor. What is the rate…

Q: In the LR circuit shown below the switch is closed at t=0. If the voltage source is 90 volts, the…

A: Introduction:-The circuit is open. No current will flow from it.Given:-LR circuit…

Q: An ac circuit is shown in the figure. The rms current in the circuit is 1.3 A. What is the peak…

A: Given Irms = 1.3 A R = 30 ohm L = 190 mH = 0.19 H XL = 60 ohm XC = 120 ohm

Q: 60. The current in the following circuit is I 2 V I 3Ω 3Ω 3Ω

A: We are given voltage of battery. We are given value of resistances in the circuit. We first find the…

Q: Describe the opposition to the flow of charge carries by resistors, capacitors, inductors

A: In this question we have to describe the opposition to the flow of charge carriers by resistors,…

Q: 2. A series RLC circuit consists of a 100 2 resistor, a 0.15 H inductor, and a 30 µF capacitor. It…

Q: 18. För an a.c generator of maximum value 100 volt, the av quarter or a half cycle equal .. Volt..…

Q: An RL series circuit has the following components: 5.0-mH coil, 1.0-W resistor, What is the time…

Q: An RL series circuit contains a 9.2-mH coil, an 1.2- 2 resistor, a 16-V battery, an ammeter and…

Q: (a) What current (in A) flows when a 60.0 Hz, 550 V AC source is connected to a 0.270 μF capacitor?…

Q: #11 Step Up Transformer A transformer primary coil has 2,300 windings, while the sec- ondary coil…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Following graph is obtained when AC passes
through
Voltage
Current
Br/2
wt
O a. resistor and inductor
O b. inductor
О с. сараcitor
O d. Resistor

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
Check Your Understanding A transformer steps the line voltage down from 110 to 9.0 V so that a current of 0.50 A can be delivered to a doorbell (a) What is the ratio of the number of turns in the primary and secondary windings? (b) What is the current in the primary winding? (c) What is the resistance seen by the 110-V source?
Presbycusis is a hearing loss due to age that progressively affects higher frequencies. A hearing aid amplifier is designed to amplify all frequencies equally. To adjust its output for presbycusis, would you put a capacitor in series or parallel with the hearing aid's speaker? Explain.
The capacitor in Figure 23.55(b) will filler high—frequency signals by shorting them to earth/ground. (a) What capacitance is needed to produce a reactance of 10-0 m for a 5.00 kHz signal? (b) What would its reactance be at 3.00 Hz? (c) Discuss the implications of your answers to (a) and (b).
A transformer is used to supply a 12-V model train with power from a 110-V wall plug. The train operates at 50 W of power, (a) What is the rms current in the secondary coil of the transformer? (b) What is me rms current in the primary coil? (c) What is the ratio of the number of primary to secondary turns? (d) What is the resistance of the tram? (e) What is the resistance seen by the 110-V source?
An RLC circuit consists of a 150- resistor, a 21.0-F capacitor, and a 466-mH inductor connected in series with a 120-V, 60.0-Hz power supply. (a) What is the phase angle between the current and the applied voltage? (b) Which reaches its maximum earlier, the current or the voltage?
(a) What current flows when a 60.0 Hz, 480 V AC source is connected to a 0.250 (F capacitor? (b) What would the current be at 25.0 kHz?
(a) What is the voltage output of a transformer used for rechargeable flashlight batteries, if its primary has 500 turns, its secondary 4 turns, and the input voltage is 120 V? (b) What input current is required to produce a 4.00 A output? (c) What is the power input?
(a) What is the resistance of a 220-V AC short circuit that generates a peak power of 96.8 kW? (b) What would the average power be if the average power be if the voltage was 120 V AC?
A 75-turn, 10.0 cm diameter coil rotates at an angular velocity of 8.00 radius in a 1.25 T field, starting with the plane of the coil parallel to the field. (a) What is the peak emf? (b) At what time is the peak emf first reached? (c) At what time is the emf first at its meet negative? (d) What is the period of the AC voltage output?
(a) Find me current through a 0.500 H inductor connected to a 60.0 Hz, 430 V AC source. (b) What would the current be at 100 kHz?
Using RHR-l, show that the emfs in the sides of the generator loop in Figure 23.23 are in the same sense and thus add.