Fluid X with a viscosity of 0.4 cP and a specific gravity of 0.8 is flowing from the upper reservoir as shown in the figure below at 100 m3/hour. What should be the elevation ( in meters) in the upper reservoir? The pipe is made of commercial steel.

The pipe is a schedule-40 stainless steel pipe. The final answer should be in units of psi/ft.

6.39. Two large water tanks are connected by a 10-ft piece of 3-in pipe. The levels in the tanks are equal. When the pressure difference between the tanks is 30 lbf/in², what is the flow rate through the pipe?

C2. A conical tube is fixed vertically with its smaller end upwards and it forms a part of the pipeline. The velocity at the smaller end is 5.3 m/s and at the larger end is 2.9 m/s. The length of the conical tube is 1.2 m and the flow rate of the water is 125 liters/s. The pressure at the smaller end is equivalent to a head of 8.5 m of water. Considering the following two cases: (1) Neglecting friction,(without head loss) determine (i) the diameter at the smaller end in meter, (ii) the diameter at the larger end in meter, and (iii) the pressure at the larger end of the tube in m of water. (2) If a head loss (with head loss)in the tube,h= 0.0153(V1-V2)2 , where V1 is the velocity at the smaller end and V2 is the velocity at the larger end, determine (iv) the head loss in m of water and (v) the pressure at the larger end of the tube in m of water. (Enter only the values by referring to the unit given. Also, upload the handwritten answers in the link provided) (i) the diameter at the…