Fluid originally flows through a tube at a rate of 100 cm3/s . To illustrate the sensitivity of flow rate to various factors, calculate the new flow rate for the following changes with all other factors remaining the same as in the original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid with 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube is used with a radius 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half the length, and the pressure difference is increased by a factor of 1.50.

Fluid originally flows through a tube at a rate of 100 cm3/s . To illustrate the sensitivity of flow rate to various factors, calculate the new flow rate for the following changes with all other factors remaining the same as in the original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid with 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube is used with a radius 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half the length, and the pressure difference is increased by a factor of 1.50.

Similar questions

A pipe made of two joined sections with different diameters of 1.0 and 4.0 inches, respectively. An incompressible fluid flows through this two section pipe. How will the speed of the fluid flow through the 4.0-inch section relate to that through the 1.0-inch section? (Answer in terms of v4-inch = [factor] x v1-inch.)
A fluid with a density of 920 kg/m³ and an absolute viscosity of 1.75x103 kg/m s is passing thru a 7.4 cm diameter tube at a mass flow rate of 3.9 kg/s. What is the Reynold's number of this fluid flow?
Water is flowing in a pipe with a varying diameter, and at all points the water completelyfills the pipe. At point 1, the diameter of the pipe is 15 cm, and the fluid speed is 1.20 m/s.What is the fluid speed in the pipe at points 2 and 3 where the diameters are (a) 11 cm and(b) 6.0 cm, respectively? (c) Calculate the volume of the water discharged from the openend of the pipe in 1.0 hour.
B) Water flows inside a pipe as shown in Fig. (3). At the lower point, the pipe diameter is 5 cm and pressure is P1 = 18 kPa. At another point y = 0.3 m higher, the pipe diameter is 2 cm and pressure is P2 = 10 kPa. Calculate: %3D %3D %3D (a) the speed of flow in the lower and upper sections. (b) the volume flow rate through the pipe. P2 P Fig. 3
A container of cross-sectional area 107 cm2 contains liquid of density 1.75 g/cm3 to a height of 6.80 cm above a small hole of area 1.00 cm2 in the side. (a) Find the speed of the fluid as it leaves the hole.(b) Find the flow rate through the hole.
A manometer using oil (density 0.900 g/cm3) as a fluid is connected to an air tank. Suddenly the pressure in the tank increases by 7.48 mmHg. Density of mercury is 13.6 g/cm3. (A) By how much does the fluid level rise in the side of the manometer that is open to the atmosphere? ____cm (b)By how much does the fluid level rise in the side of the manometer that is open to the atmosphere if the manometer used mercury instead? ___cm
container of cross-sectional area 122 cm2 contains liquid of density 1.75 g/cm3 to a height of 6.40 cm above a small hole of area 1.00 cm2 in the side. (Just need help with part b) (a) Find the speed of the fluid as it leaves the hole. 1.12 m/s(b) Find the flow rate through the hole. (The answer is not 0.196)
A glucose solution being administered with an IV has a flow rate of 3.95 cm3/min Q = 3.95 cm3/min a. What will the new flow rate be if the glucose is replaced by whole blood having the same density but a viscosity 2.50 times that of the glucose in cm3/min? All other factors remain constant.
Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow rate to various factors, calculate the new flow rate for the following changes with all other factors remaining the same as in the original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid with 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube is used with a radius 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half the length, and the pressure difference is increased by a factor of 1.50.
Water moves through a constricted pipe in an ideal steady flow. At the lower point, the flow rate is 20 m3/s and the diameter at this lower point is 10 cm. Given that the upper point has diameter of 5 cm, what is the flow rate at the upper point? Possible Answers: 40 m^3/s 20 m^3/s 10 m^3/s 5 m^3/s
Consider the hydraulic lift shown in the figure. The small piston has an area A of 0.0330 m², and the large piston has an area A2 of 4.00 m2. What force F2 will the large piston provide if the small piston is pushed down with a force F of 17.0 N? Assume that the fluid used in the lift is incompressible. F2 %3D Y2 A, A, If the small piston A1 is slowly depressed a distance of yi = 0.200 m, what distance y2 will the large piston A2 rise? y2 = What is the magnitude W of the work done when pushing down the small piston A1? What is the magnitude W, of the work done when pushing up the large piston A2? W = J W2 =
A large tank contains water to a depth of 1.0 m. Water emerges from a small hole in the side of the tank 20 cm below the water level. If the diameter of the hole is 0.50 cm, what is the water flow rate from the hole?