what is the answer to this? Find the work (in ft-lb) done by winding up a hanging cable of length 100 ft and weight-density 3 lb/ft.ft-lbHow much work (in ft-Ib) is done to lift the cable 50 ft?ft-lbHow much additional work (in ft-lb) is done when winding up the cable of length 100 ft by hanging a 500 lb weight at the end of the cable?ft-lb

a) Let the length of the hanging cable be L and the weight density be w. The force due to hanging…

Find the work (in ft-lb) done by winding up a hanging cable of length 100 ft and weight-density 3 Ib/ft. ft-lb How much work (in ft-lb) is done to lift the cable 50 ft? ft-lb How much additional work (in ft-lb) is done when winding up the cable of length 100 ft by hanging a 500 lb weight at the end of the cable? ft-lb

Find the work (in ft-lb) done by winding up a hanging cable of length 100 ft and weight-density 3 Ib/ft. ft-lb How much work (in ft-lb) is done to lift the cable 50 ft? ft-lb How much additional work (in ft-lb) is done when winding up the cable of length 100 ft by hanging a 500 lb weight at the end of the cable? ft-lb

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter5: Energy

Section: Chapter Questions

Problem 5P: Starting from rest, a 5.00-kg block slides 2.50 m down a rough 30.0 incline. The coefficient of...

See similar textbooks

Similar questions

Suppose you are reshelving books in a library. As you lift a book from the floor and place it on the top shelf, two forces act on the book: your upward lifting force and the downward gravity force. (a) Is the mechanical work done by your lifting force positive, zero, or negative? (b) Is the work done by the gravity force positive, zero, or negative? (c) Is the sum of the works done by both forces positive, zero, or negative?
. A particular hydraulic pile driver uses a ram with a mass of 1040 kg. If the maximum pile energy is 11,780J, how high must the ram he raised to achieve this value? Assuming it takes 0.62 s for the pile driver’s winch motor to raise the ram at a constant speed to this height, what is the power output by the motor in completing this task? Express your answer in both watts and horsepower.
A 5.0-kg box rests on a horizontal surface. The coefficient of kinetic friction between the box and surface is K=0.50 . A horizontal force pulls the box at constant velocity for 10 cm. Find the work done by (a) the applied horizontal force, (b) the frictional force, and (c) the net force.
A 300 g hockey puck is shot across an ice-covered pond. Before the hockey puck was hit, the puck was at rest. After the hit, the puck has a speed of 40 m/s. The puck comes to rest after going a distance of 30 m. (a) Describe how the energy of the puck changes over time, giving the numerical values of any work or energy involved. (b) Find the magnitude of the net friction force.
For each of the situations given, state whether frictional forces do positive, negative, or zero work on the italicized object. (a) A plate slides across a table and is brought to rest by friction. (b) A person pushes a chair at constant speed across a rough, horizontal surface. (c) A box is set down on a stationary conveyor belt. The conveyor belt is then turned on and the box begins to move, being carried along by the belt. (d) A person exerts a horizontal force on a banana at rest on a counter top. The banana remains at rest.
Starting from rest, a 5.00-kg block slides 2.50 m down a rough 30.0 incline. The coefficient of kinetic friction between the block and the incline is k = 0.436. Determine (a) the work done by the force of gravity, (b) the work done by the friction force between block and incline, and (c) the work done by the normal force. (d) Qualitatively, how would the answers change if a shorter ramp at a steeper angle were used to span the same vertical height?
A tension force of 175 N inclined at 20.0 above the horizontal is used to pull a 40.0-kg packing crate a distance of 6.00 m on a rough surface. If the crate moves at a constant speed, find (a) the work done by the tension force and (b) the coefficient of kinetic friction between the crate and surface.
. In the annual Empire State Building race, contestants run up 1,575 steps to a height of 1,050 ft. In 2003, Australian Paul Crake completed the race in a record time of 9 min and 33 S, Mr., Crake weighed 143 lb (65 kg) , (a) How much work did Mr., Crake do in reaching the top of the building? (b) What was his average power output (in ft-lb/s and in hp)?
The system shown in Figure P5.43 is used to lift an object of mass m = 76.0 kg. A constant downward force of magnitude F is applied to the loose end of the rope such that the hanging object moves upward at constant speed. Neglecting the masses of the rope and pulleys, find (a) the required value of F, (b) the tensions T1, T2, and T3, and (c) the work done by the applied force in raising the object a distance of 1.80 m. Figure P5.43
A hummingbird is able to hover because, as the wings move downward, they exert a downward force on the air. Newtons third law tells us that the air exerts an equal and opposite force (upward) on the wings. The average of this force must be equal to the weight of the bird when it hovers. If the wings move through a distance of 3.5 cm with each stroke, and the wings beat 80 times per second, determine the work performed by the wings on the air in 1 m if the mass of the hummingbird is 3.0 g.
Starting from rest, a 5.00-kg block slides 2.50 m down a rough 30.0 incline. The coefficient of kinetic friction between the block and the incline is k = 0.436. Determine (a) the work done by the force of gravity, (b) the work done by the friction force between block and incline, and (c) the work done by the normal force. (d) Qualitatively, how would the answers change if a shorter ramp at a steeper angle were used to span the same vertical height?
Review. You can think of the workkinetic energy theorem as a second theory of motion, parallel to Newtons laws in describing how outside influences affect the motion of an object. In this problem, solve parts (a), (b), and (c) separately from parts (d) and (e) so you can compare the predictions of the two theories. A 15.0-g bullet is accelerated from rest to a speed of 780 m/s in a rifle barrel of length 72.0 cm. (a) Find the kinetic energy of the bullet as it leaves the barrel. (b) Use the workkinetic energy theorem to find the net work that is done on the bullet. (c) Use your result to part (b) to find the magnitude of the average net force that acted on the bullet while it was in the barrel. (d) Now model the bullet as a particle under constant acceleration. Find the constant acceleration of a bullet that starts from rest and gains a speed of 780 m/s over a distance of 72.0 cm. (e) Modeling the bullet as a particle under a net force, find the net force that acted on it during its acceleration. (f) What conclusion can you draw from comparing your results of parts (c) and (e)?