Answered: Find the transfer function of the…

Engineering

Electrical Engineering

Find the transfer function of the Bode-plot shown in the figure below. 0 dB + -20 dB- 0° -180° 0.1 1 @ = 1 @ = 1 log w

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 4RQ: A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant...

See similar textbooks

Related questions

Q: 02: For the feedback circuit in fig(2): What is the F.B. topology Draw the basic amplifier without…

A: Given that feedback amplifier with common emitter current gain input impedance

Q: Determine the absolute value of current l₂ R₂ 81 R₁ w w Rs 62 32 R₁ www R₁ 36 61 R₁. Ohm R₂. Ohm R3.…

Q: Why is grounding essential in transmission cabling installations?

A: For a number of crucial reasons, grounding is required in transmission cabling installations,…

Q: Discuss the principle behind 3D NAND technology in modern SSDs.

A: It is asked to discuss the principle behind 3D NAND technology in modern SSDs.

Q: Q6: When x, y and z are positive and less than 6, a certain magnetic field intensity may be…

Q: draw the phase portrait as function of the control parameter mu. Classify the bifurcations that…

A: Given,The system function is given as,

Q: compute the value of the perpendicular component and of P.

A: Given:for the given system, with parallel component of P is 300 N. To find:value of the…

Q: • A 150 MW power station delivers 150 MW for 1 hour, 100 MW for 2 hours. 50 MW for 6 hours, 20 MW…

A: Dear,as per company guidelines,we can answer only one question at a time, kindly post other question…

Q: 1. For the circuit of the figure if V1 has a voltage of 5V, determine the value of R1 if ID1=¹/2 D2…

A: In this question, we need to determine the resistance R1 and diode currents as shown the circuit.we…

Q: In the below-given diagram, find the current through R₁ and R₂ resistance using KCL.

A: Given circuit is shown below:

Q: Write an 8085 assembly language program to find the sum of all even numbers between 1 and 50…

A: It is given that:8085 microprocessor Required :An 8085 assembly language program to find the sum of…

Q: Design a 4-bit addition-subtraction circuit which performs addition or subtraction based on the…

Q: Q2. Sketch g(t)=e¹sin (27).

Q: Find Leg In below figure.

A: Given circuit is shown below:

Q: 2. Draw the diagram of the Root Locus (Root Locus) of the following system, b) G(s) s+9 (s + 1)(s +…

A: Given:an open loop system function, To find:we have to draw the root locus of the given system.

Q: 3. Determine if the following signals are periodic or non-periodic. a. y = sin(t) + sin(t) b. y sin…

A: It is given that:

Q: For the circuit shown in Fig.2, find the current through the 302 resistance by use the Thevenin's…

A: As we can see "pACp" and "BqDB" are forming a delta network.So, we will first reduce this circuit…

Q: Consider the networks shown in below figure чие a --120 b The ratio between the Z and Z is Zo Z₂

A: Given circuit is shown that:

Q: Q3/A- Determine Zi, Zo, and Vo for the network of Fig.4 if Vi 20 mV 4+20V B- Why FET transistor more…

Q: 4. Calculate the voltage Vx in the network shown in Figure B using mesh current method. 10 1520° V…

Q: A single phase thyristor adjust line spacing converter with a resistive load is shown below: V₁-V…

A: Given information is shown below:

Q: Refer to Fig 4.5.3 IfA=0 and B = 1, what will be the logic states at X, Y and Z? ox OA.X=0, Y=0, Z=1…

A: The logic diagram,and,

Q: Determine v₁ and v₂ in the circuit of Fig. 3.71.

A: Given circuit is shown below:

Q: Ad-50 Roka (b) 100 Ry ₩ Art (c) AJ-8 Ry 다 R2km Com 220 (d) Find out the value of Rf that will…

A: Given circuit:

Q: Could you please go further into how to apply nodal analysis to an op-amp circuit? Thank you

Q: Discuss the technological advancements that have improved bend resistance in modern fiber-optic…

A: Technological advancements in fiber optic cables have significantly improved their bending…

Q: ip Lp = 50 mH moo ell N₂ = 20 N₁ = 80 Lg k=0.8

A: The value of the primary induced voltage at the rate of 0.08Wb/s.Given:

Q: (c) Show that these expressions can be simplified as M (X,Y,Z) = X.Y + X.Z+Y.Z = (X+Y) (X + Z) (Y +…

A: To Prove:c. d. Introduction:The truth table for the given description…

Q: 4. Find out the value of Rf that will produce the indicated closed-loop gain in each amplifier in…

A: Given circuit:

Q: A Gray code is a sequence of binary numbers with the property that no more than 1 bit changes in…

A: According to the question, we need to construct a 3-bit Gray code counter.

Q: 11 R1 M R2 Ob Figure 3: A resistor circuit Given resistors R₁ = 1k0, R₂ = 2k, and current source l₁…

A: We must determine the voltage across the ab terminal in the questions provided.

Q: Explain the concept of Fault Ride-Through (FRT) capability in wind power generation systems. How do…

A: Fault Ride-Through (FRT) capability refers to the ability of wind power generation systems,…

Q: What are the techniques used in microcontrollers for power optimization and battery conservation?

Q: Discuss the concept of Voltage Source Converters (VSCs) in high-voltage direct current (HVDC)…

A: Voltage Source Converters (VSCs) are key components in high-voltage direct current (HVDC)…

Q: Consider the energy gap of a silicon-based semiconductor at 0°K to be 1.21 eV and the material…

A: Given information is shown below:

Q: Describe the challenges and techniques associated with splicing and terminating fiber-optic cables.

A: Splicing and terminating fiber-optic cables are critical processes in the field of…

Q: 1) Assume that we have an inverter with its input tied to ground. Assume that the inverter drives…

A: The given is the inverter drives another logic gate which maximum high voltage of .a) Find is the…

Q: Draw the developed diagram of the stator winding of a 3-phase machine with 24-slot and 4-pole. The…

A: The given is asked to draw the diagram.To draw the diagram of the stator winding of a phase machine…

Q: Consider the circuit show in below figure 4Ω 200°V + rms -j 202 The average power delivered by the…

A: Given circuit is shown below:

Q: How does "thermal throttling" affect SSD performance and longevity

Q: Q. 4 Determine and sketch the magnitude and phase spectra of the following signal: 3лm 5 5πn + 46…

Q: Find the overall transfer function for the given system and also find the value of BS to make…

Q: 18 E = R (V/m) R² find the electric potential of point A with respect to point B where A is at +2 m…

A: It is given that:

Q: 10 V 50 Hz C1 HH 3.3u R1 560 i. Mesh (Loop) Analysis Nodal Analysis. ii. C2=1.8u L1 + ieee 680m…

Q: QUESTION 2 (Parallel circuits) L Determine the currents in the circuit of Figure above. If the…

Q: The Potential coil in a meter is energized by line voltage and consists of many turns of fine wire…

Q: How does a Phase Locked Loop (PLL) enhance microcontroller functionalities?

A: A Phase-Locked Loop (PLL) is an electronic feedback control system that plays a crucial role in…

Q: Write the mesh currents for the network of Fig. 17.14 having a dependent current source.

A: Given circuit is shown below:

Q: A Frequency Modulation (FM) waveform x(t) is described by the following equation: x(t) = 10 cos…

Q: In the following circuit, given that R₁ = 15k, R₂ = 20k, R3 = 30kn id R4 = 15kn. a/ Calculate the…

A: Given Data:A DC resistive circuit with,DC voltageTo Find:a. The equivalent resistance.b. The total…

Question

Q.21 Find the transfer function of the Bode-plot shown
in the figure below.
0 dB +
-20 dB-
0°
-180°
0.1
@ = 1
@= 1
log w

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Summarize the given information.

VIEW

Step 2: Conclude the information from Bode plots.

VIEW

Step 3: Determine transfer function.

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 10 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is resonance? Explain how the condition of resonance is obtained in a series RLC circuit. Determine impedance, current, and power factor of RLC circuit at resonance.
In the circuit of Figure, the magnitudes of V₁ and V at the resonance are twice L C that of VD. The inductance of the coil for R* 50 Hz is 520⁰ VR www. 502 Vc ell V₁
A parallel R-L-C circuit is fed by a constant current source of variable frequency. The circuit resonates at 100 kHz and the Q-factor measured at this frequency is 5. Find the frequencies at which the amplitude of the voltage across the circuit falls to (a) 70.7% (b) 50% of the resonant frequency amplitude.
We use the transfer function Vo (s) / Vi (s) for the electric circuit given in the figure.in terms of parameters. R1 = 1Kohm to the transfer function you found,Bode the expression you get by typing the values R2 = 1Kohm C1 = 1nF, C2 = 1nFDraw the diagram.
9 - In Bode diagram the frequency at which the two asymptotes meet is called ... A) the corner frequency B) asymptotic frequency C) gain cross over frequency O D) gain frequency O E) phase cross over frequency
Proposed an industrial application with a transfer function. Using the proposed transfer function: 1. Sketch the corresponding magnitude and phase asymptotic Bode plot by hand (Using semi log paper). 2. Plot the corresponding Bode plot in MATLAB and verify that the result corresponds to you hand-sketched asymptotic plot. refer here https://www.mathworks.com/help/ident/reflbode.html 3. Use the MATLAB function to obtain the gain margin and phase margin. Tips: watch class video 4. Comment on system stability based on obtaining gain margin and phase margin.
Eill in the blank with corect answers B Frequency Series Resonance - Impedance vs. Frequency. The graph of impedance against frequency for an RLC series resonance circuit is shown in the picture. At which point the current will be maximum At point A At point C At point B At point D The inner most layer of an optical fhotI Is cantu Impedance
semi-log facsimile and draw asymptotic Bode plots (magnitude & phase).
7. The Bode diagrams of the open-loop transfer function is given in the attached sheet. Find graphically | The type of the system • The phase and gain margins The phase and gain margins where the gain is increased 10 times. Justify your answers by indicating in the figure the corresponding quantities. 60 40 20 -20 -60 -80 -100 -120 0.01 10 0.1 1.0 100 1000 w (rad/s) -45 -90 -135 -180 -225 -270 0.01 100 0.1 1.0 10 1000 w Irad/s) - • (aP) I (/)9I (souBap) (mn97
A tank circuit contains a capacitor and an inductor that produce 30 2 of reactance at the resonant frequency. The inductor has a Q of 15. The voltage of 277V is connected to the circuit. What is the total circuit current of the resonant frequency? Show your work. a) IT= 0.615 A b) IT= 0.423 A c) IT = 0.846 A d) IT= 0.321 A
Find I, VR, V, and Vc at the resonance in the next figure, with VS-50mV, R-220 hms, X100 ohms , and Xc100 ohms
Given the following transfer function, use the Bode plot paper and draw the asymptotic amplitude/magnitude Bode plot, as well as phase plot. Show all values on sketches