Find the sum of two sinusoidal voltages, given as follows: v₁ (t)=V1 cos(wt+₁) and V₂ (t)=V2 cos(wt+2). You are told that V1 =13, V2 = 17, w = 1,000, 1 = 30° and $2 = 43º. Hint: we recommend using the phasor transform to add these signals in the frequency domain. Once you have added the signals, please enter the angle (in degrees) below. Enter the answer to 3 significant figures.

Find the sum of two sinusoidal voltages, given as follows: v₁ (t)=V1 cos(wt+₁) and V₂ (t)=V2 cos(wt+2). You are told that V1 =13, V2 = 17, w = 1,000, 1 = 30° and $2 = 43º. Hint: we recommend using the phasor transform to add these signals in the frequency domain. Once you have added the signals, please enter the angle (in degrees) below. Enter the answer to 3 significant figures.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.6P: (a) Transform v(t)=75cos(377t15) to phasor form. Comment on whether =377 appears in your answer. (b)...

See similar textbooks

Similar questions

1. Graph the following complex numbers and convert in the specified form a. 5-j7 to exponential form b. 5 cjs (-45°) to rectangular form C. -2-j3 to polar form d. 32-45° to exponential form of complex numbers, (10pts each)
The summation of continuous- time sinusoids is Select one: a. Periodic under certain conditions O b. Always periodic O c. Never periodic O d. Periodic only if all the sinusoids are identical in frequency and phase
From the provided AC voltages add them together by transforming them into phasors. You must express the final result as a sinsoid within a time domain with their accomping phase angles in radians. All complex math must also be shown.
Given the two sinusoidal waveforms, f(t) = -50coswt - 30sinwt and g(t) =55coswt - 15sinwt Find the amplitude of g(t) ANSWER Blank 1
* ?Find the overall TF of the following system 2+1 13+1 * ?obtain the step and sinusoidal response of the system ?What are the delay time and MP of the system ?is the system stable? prove your answer
C1 L1 R1 V1 Vout V1 contains the fundamental and its harmonics (fo, 2fo, 3fo, ...). The amplitude of the harmonics is inversely proportional to the harmonic number. V(fo) = 10 mV V(2fo) = 10mv/2 = 5 mV V(3fo) = 10mv/3 = 3.33 mV V(4fo) = 10mv/4 = 2.55 mV a) What is the minimum value of Q for the circuit that will attenuate the third harmonic (3fo) in Vout to be less than 1% of the fundamental? b) What is the amplitude of the fifth harmonic (5fo) as a percentage of the fundamental?
Given the two sinusoidal waveforms, f(t) = -50coswt - 30sinwt and g(t) = 55coswt - 15sinwt. Find the phase angle by which f(t) leads g(t) ANSWER f(t) leads g(t) by Blank 1
Problem 5 The voltage signals below have identical peak values. Their rms values are also the same. If the first waveform is a sinusoid, what is the pulse duration Tpulse of the second waveform? Provide your answer in terms of T, the period. V ← Tpulse time 5- K time
A series RL circuit is connected to a sinusoidal voltage source at t = 0. In general, which of the following best describes the complete response of the current? Select one: O a. sum of exponentials b. sum of sinusoids O c. exponential + sinusoid O d. product of exponential and sinusoid O e. sinusoid + product of exponential and sinusoid O f. exponential + product of linear and exponential term
In the circuit in Figure 2, the capacitor and The circuit of resistance is defined as a load circuit. A) Find the average power dissipated by the load circuit. B) how much of the average power calculated in a) by the resistance in the load circuit and how much spent by the capacitor? Comment on the results obtained? C) In the circuit in Figure 2, 2 / 3? A coil of is connected in series. In this case, Calculate the transformer ratio (n) to optimize power distribution to the load? Obtained comment on the result? D) Calculate the complex power and reactive power dissipated by the load in the newly created circuit.
Power in Extreme Frequency Limits. You and your team have been assigned to find a power supply for the circuit in the drawing. which can be used to supply a dc voltage at 15.0 V, or a high frequency ac signal with a root-mean-square (rms) voltage of 15.0 V. The components in the circuit have the following values: R=4.600, C= 20 nF, and L = 22 mH. Your task is to estimate the peak wattage (i.e.. power) required of the power supply for (a) the dc and (b) the high frequency signals. Conceptual Example 5 will provide insight into this problem. (a) Number (b) Number 24.4 196 R ww Units W Units W C HH elle L R
A series RL circuit is connected to a sinusoidal voltage source at t = 0. In general, which of the following best describes the complete response of the current? Select one: a. sum of exponentials Ob. sum of sinusoids O c. exponential + sinusoid O d. product of exponential and sinusoid O e. sinusoid + product of exponential and sinusoid O f. exponential + product of linear and exponential term O g. sinusoid + product of linear and exponential term