Find the following: A. (1100)2 (101)2 B. (1101)2+(101)2 C. (10011000)BCD + (10010111) BCD

Q: 4. Find Ix and Vab from the given circuit below. 50 V + 1 ohm 2 ohms a b + 21x

A:

Q: Show that the sum of the powers of both circuits is zero.

A:

Q: Explain the acoustical property of frequency and give the corresponding musical term.

A:

Q: Draw the transistor level of a 3-input CMOS NAND gate. Assuming the inputs are 111, specify the…

A:

Q: Q4) Find the following: A. (1100); × (101): B. (1101)+(101); C. (10011000) BCD + (10010111)acD

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Q4) Find the following: A. (1100): x (101): B. (1101)+(101): C. (10011000) BCD + (10010111)BCD D.…

A:

Q: Question A 500 kVA, 3-phase transformer has iron loses of 300 W and full load copper losses of 600…

A: Given- 500 kVA, 3 phase transformer. iron losses = 300 W, full load copper losses of 600 W. To Find-…

Q: Q) Two impedances Z₁-(10+j5) and Z₂=(8+j6) are connected in parallel across a voltage of V=200+j0.…

A: Given - Z1=(10+j5) ,Z2=(8+j6) , Voltage, V = 200 + j0 ,     To find- (i) Circuit current (I) , (ii)…

Q: Solve the ff R1, R2 and I3 with solution

A: It is given that: R3=100 ΩVR=2.0VVG=2.2 VVB=2.0 VI1=2 AI2=20 mA

Q: Q5-Obtained the syndrome table for (5,3) systematic cyclic code generated by g(x)=1+x², then find…

A: Given: For (5,3) systematic cyclic code generator polynomial, g(x)=1+x2  Received code word = [1 1 0…

Q: 3. The 6dB attenuator will cause a 6dB loss in the power of any waveform that passes through the…

A:

Q: An audio signal 10sin 2π(2000t) amplitude modulates a carrier 20sin  2π(200000t). i) Sketch the…

A:

Q: 7. Both inputs to a NOR latch are high. The R input goes low, then the S input goes low. What is the…

A: The latch is a device that stores one bit of data. The Latch works on the level-triggered clock…

Q: When the peak output voltage is 100 V, the PIV for each diode in a center- tapped full-wave…

A: Given The peak output voltage is 100 volts PIV for each diode in the centre tapped full wave…

Q: Question The circuit in figure is used to measure the power consumed by the load. The current coil…

A: Given- current coil & voltage coil resistance- =0.02 Ω & 1000 Ω. To Find- The measured power…

Q: Write the mathematical model of the circuit using either KCL or KVL

A: The required mathematical model can be obtained by applying Kirchhoff's voltage law.

Q: The capacitor in a clamper circuit is in parallel with the voltage source True O False O None O

A: In this question,  We need to choose the correct options This question is releted to connection of…

Q: A current of 1 A is maintained in a simple circuit with a total resistance of 2.5 0. How much heat…

A: It is given that: I=1 ART=2.5 Ωt=4.5 s

Q: 4. Find the Laplace transform, zeros, poles and ROC of the following time-domain functions. a. x(t)…

A:

Q: Find the impulse response h[n] of the causal LTI discrete-system satisfying the following difference…

A:

Q: The input characteristics of common emitter is between IC and VCEO IB and VBE O IE and IBO IB and…

A: input characteristics are drawn between input voltage and input current  .  given common emitter…

Q: Why is automation crucial in the modern world?

A:

Q: The atomic number of silicon is 8 14 32 O 20 *< The circuit which is used to add a positive or…

A:

Q: Using state transition matrix and Laplace transform

A: In the given questions we need to calculate state transition matrix using the Laplace transform.

Q: Derive the Boolean expression for the logic circuit shown below: A AB COE D

A: Given: The logic circuit is,

Q: Using Manual drawing or CAD. Convert the pictorial cabling to a wiring diagram

A: According to the question, for the given diagram as shown below, We need to draw wiring diagram.

Q: If m(t) = A cos(wt) v, find the output signal of narrow band frequency modulation (eNBFM(t)) and…

A:

Q: Q4) Find the following: A. (1100): x (101): B. (1101); +(101); C. (10011000) BCD + (10010111)BCD D.…

A:

Q: 120 V fo Ideal diodes 2.2kQ 2.2 ΚΩ 2.2 k

A:

Q: on 5. Consider a filter with the frequency response H(w) = c¯ c-(196²+jwto) (5a) Show that this…

A: Given,The frequency response of the filter is,Hω=e-49ω2+jωt0

Q: Electrical Engineering What are the implications of intensity in energy generation

A: Given: Energy intensity: Intensity has a deep role in the energy generation. Energy intensity is…

Q: Find the current I flowing thru a bulb due to a constant flow of charge of 60 C that passes any…

A: Given: The charge flowing through bulb, q=60 C. Time to pass any cross section of conductor, t=60 s.…

Q: 1. A discrete LTI system has an inpu x[n] and impulse response h[r shown below. Find the output y[r…

A:

Q: A 240 V, 60 Hz single phase source supplies a parallel circuit consisting of two branches. Branch 1…

A:

Q: 244. The apparent power drawn by an a.c. circuit is 20 kVA and reactive power is 12 kVA. The real…

A: Given, Apparent power, S=20 kVA. Reactive power, Q=12 kVAR. Real power, P=?

Q: 6. From the figure below, determine the current I and the voltage across terminals A & B. 100 V + 12…

A:

Q: The input characteristics of common emitter is between IE and IB O IC and VCE O IB and VBE O IB and…

A: Since you have posted the multiple questions so we are supposed to answer the 1st one.  1)

Q: An FM wave is given by s(t) = 20 sin (6 x 108t + 7 sin 1250t). Determine (i) The carrier and…

A:

Q: Can you please explain how you calculated an impedance of 2.341?

A: It is given that:

Q: Determine the transition voltage (VT) that will cause a variation in state for the diode. 8 V 10…

A: We need to find out transition voltage for given circuit.

Q: Three leads of a compressor are connected as shown. What is the totalresistance between S and R when…

A:

Q: L 1₁ ↓ __. R₁ 1₂ rest of circuit R₂ In Ra To 7 <← 1₂ Is R₂ 14 Question: Given that R1-8kohms,…

A:

Q: Draw the schematic symbol of the following: a.) function/signal generator b.) diode

A:

Q: The current that varies sinusoidally with time. Blank 1

A: Current  is defined as rate of flow of electron in a conductor.

Q: A coil is used for producing a flux of 0.24 x 10 webers. If the current flowing in the coil is 2 amp…

A: Given: Coil producing flux, φ=0.24×10-3 Wb. Current flowing in coil, I=2 amp. Coil turns, N=200.

Q: a JK flip-flop changes state when b. K changes c. J and K changes d. when T switches from 1 to 0…

A: In this question we have to tell which option is correct and provide correct explanation for the…

Q: Design a 4-bit shift register having: - a sequential input SI; - 4 parallel inputs D0, D1, D2, D3;…

A: According to the question, we need to design a 4-bit shift register. The conditions are given below,…

Q: A galvanometer with a full-scale current of 10 mA has a resistance of 10000. The multiplying power…

A: Given, Im=10 mA Rm=100 ohm  Rsh=100 ohm

Q: Calculate the power factor in Delta connected load. If the phase voltage at the load is 200 V and…

A:

Q: Zener Diodes are not working in the breakdown region O reverse biased O forward biased O zero…

A: when input voltage is positive , zener diode works as normal diode and is called forward baised…

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.