find the current flow in resistance 3 ohm ww 392 Used Nodal analysis. 69 29 ww 1 3А 12V 492

Q: Q3) Find the average value of the function f(x)=√cos 4x + 1, on [ 0, 1 0) Using Numerical Interne

A: Given data, Function is given as, fx=cos4x+1 Limit is given 0,π2

Q: Q2) Design a clamper to perform the function indicated in Figure (2), and calculate the time…

A:

Q: 20. The following data are given for a two-branch parallel circuit: E = 120, R₂ = 30, XL = 25, Xc =…

A:

Q: alternative name for volt/ohm

A:

Q: Consider the circuit in Fig. 16.12(a). Find the value of the voltage across the capacitor assuming…

A: given data, Vs(t) = 10u(t)

Q: ind the Current Io. In figure (2). Чта 2mA IT Iks Iz 31KR IY 2km Slkr 4 Io Is Fig.2 lkn 16 MA

A: The circuit given as

Q: For the dual oscilloscope displays shown in the figure with H, of 500 µs/div and V of 20 mV/div find…

A:

Q: Sensors are important in data acquisition system. Explain briefly the basic working principle of an…

A: A sensor is a device that detects input of any kind from the physical world and reacts to it. Light,…

Q: convert the transfer functions into linear differential equations: a) 1/(1.896s+1) b)…

A: Given data : Transfer functions are  (a). 1(1.896s+1) (b)130.19(s2+8.22s+130.19)

Q: 1. For the network given on Figure 44, determine the IpQ, VGSQ, VDs, and Vs. + VGSQ 18 V 2.2 ΚΩ IDQ…

A: We need to find current and voltage for given circuit

Q: for the system shown in the block diagram of figure below determine the values of gain k1 and…

A: k1,k2=?Max. overshoot for unit step mp=e-πξ1-ξ2=0.25 (given)e-πξ1-ξ2=0.25Apply ln on both…

Q: 3 Fies Nyquist criterion. A system is described by the state variable equations 0 -1 0 -2 0 0 -3] *…

A:

Q: V₂₂ 11. The movement of the multirange voltmeter in Fig. 4-17 has a full- scale current of 50 µA and…

A: Given data, The full load is current  50A The voltage V1, V2, V3 is 150 V, 50V and  10V The value of…

Q: 4. The switch has been open for a long time before closing at t = 0. Find v(t) and dv/dt for t > 0+.…

A: Given circuit:-

Q: In the bridge circuit, I₁ = 10 A and I₂ = Find V, and V, using y parameters. 3 Ω 3Ω ww 3 Ω www + I V…

A: Transforming the ∆ subnetwork to Y gives the circuit in Fig (a).

Q: In the bridge circuit, I = 10 A and I Find V, and V, using y parameters. 3Ω ww 3 Ω 3 Ω ww + 4₁ V₁ 1Ω…

A:

Q: 2/ Find the transmission parameters for the two port network 54₁ 1₂ 1₁ 2002 www ww 30 Ω

A: Given data, Circuit diagram is given as,

Q: Consider the circuit in Fig. 16.12(a). Find the value of the voltage across the capacitor assuming…

A: here only one independent source so we can't apply the superposition theorem. According to…

Q: Determine the current supplied by each voltage source (8 V,12 V). using superposition theorem in…

A:

Q: (c) x[n]-()"u[n]+()^u[-n-1]

A: Given function, xn=12nun+13nu-n-1

Q: Findi- fouriar series Using 1 Plot the amplitude spectrum Determine the total Power 3 Find the value…

A: Fourier series:

Q: A- What is the difference between network layer delivery and transport layer delivery?

A: The network layer offers a common foundation that makes it possible to understand the intricate…

Q: specifications. Determine and comment on the computational and storage requirements.

A: we will compute the required computational and storage requirements with the help of detailed block…

Q: Q5/ For the below system -1 0 21 [x1 ГО 4-6-8- = 3 1 02+0 u 1 1 y = [1 0 0] X₂ [x3. A-Obtain the…

A: Transfer function: It gives the information of the system input and output. With the help of the…

Q: Find the Thévenin equivalent with respect to the terminals a, b for the circuit in Fig. P4.67.…

A: Thevenin equivalent circuit: Any linear bilateral network can be represented as a voltage source and…

Q: The nature of the graph between the speed and field current of DC shunt motor is O Linear O Straight…

A: In this question we will find relation between speed and field current of dc shunt motor...

Q: Question 3 A C o • 100 Ω A RL Figure 22 For the circuit in Figure 22, the Thevenin equivalent…

A:

Q: Apply Norton theorem to calculate the current in 62 resistance for the circuit in figure 3 2001 55…

A: According to the question, the given circuit is  To find Norton's current we will short-circuit the…

Q: For the circuit shown below, in order to find the value of Vo

A:

Q: A 5V voltage source is connected at port 1 and a 500 resistor is connected at port 2. Find the port…

A: The given circuit is shown below. We need to determine the port currents I1 and I2.

Q: Vi o Solve for VCB and VCE. 10 με F 47 ΚΩ B 10 ΚΩ −2V C - '2.4 ΚΩ ΦΕ 18 V 10 μF + Vc β=120 1.1 ΚΩ o…

A:

Q: Q2: Consider a length of Teflon-filled, copper K-band rectangular waveguide having dimensions a =…

A: GIVEN: dimensions of a waveguide              a=1.07              b=0.43 FIND: cut off frequency of…

Q: 1. x[n] contains 128-point samples obtained through sampling continuous-time signal x (t) with…

A: Given :Nn-point DFT = 128K = 32  ;  Ts = 0.1 secω = ?    ;  Ω = ?

Q: The intrinsic stand-off ratio for a UJT is 0.65. If the interbase resistance is 10 kΩ ,find the…

A: UJT is the uni-junction transistor it is the three terminal device that are used to gate pulse,…

Q: Q4-a: A 2nd order recursive system is described by the LCCDE y(n)=0.75y(n-1)-0.125y(n-2)+x(n)-x(n-1)…

A:

Q: Q4. A 200KVA single phase transformer with a voltage ratio 6350/660 V has the following winding…

A: As per Bartleby policy we can answer only three subparts. So I am solving first three for you.…

Q: An instrumentation amplifier is used when the application signal is very low. For the circuit shown…

A: Since there are 2 different questions, as per the guidelines, the following section (d) will be…

Q: 1-A light ray moving through CR39 at angle 49° angle exits into another medium at angle of 41°. What…

A: We are authorized to answer only first question at a time since you have not mentioned which…

Q: (b) Figure 1(b) shows a type of oscillator. Given T=3ms and the duty cycle is 50%. i) Name this…

A: Given: Consider the following figure shows a type of oscillator. Given T=3ms and the duty cycle is…

Q: Q1) The signal x(t)= 5 cos (40nt) is to be sampled for digital transmission with bit rate 400bps…

A: Given data, Signal x(t)=5cos40πt Bit rate Rb=400bps

Q: Problem 7: Consider the following circuit of three resistors (R₁, R2, and R₂), with batteries that…

A: (a) The circuit is shown below:  Applying K.V.L in the top loop,…

Q: 7. 3.1 Evaluation only. Created with Aspose, words 2003-2001 Aspose Pty Ltd. Vcc ASSIGNMENT TWO…

A:

Q: Apply Norton theorem to calculate the current in 6 Q2 resistance for the circuit in figure 3 2001 55…

A: In this questions we need to calculate the current through 6ohm resistor by Norton theorem.

Q: 6. Three equal capacitors of 3000μF are connected in series, then the equivalent capacitance Ceq.is…

A: Given, Three equal capacitors are connected in series. Capacitance of each capacitor, C=3000 μF

Q: 5. Let R(s) be a unit step function, C(s) be the output function, and G (s) = the output response,…

A:

Q: Q4] find the current of the resistance 300 if the value of the source is:V1= 2.6sin(100πt- 58) volt

A: The circuit can be draw

Q: Determine the current supplied by each voltage source (8 V,12 V). using superposition theorem in…

A: Given circuit, To determine the current supplied by each voltage source using superposition.

Q: 5. The positive sequence network, negative sequence network and zero sequence network are shown in…

A: It is given that: Zf=0.05

Q: Apply Norton theorem to calculate the current in 6 2 resistance for the circuit in figure 3 2000 + 5…

A: In this questions we need to calculate the current through 6ohm resistance by Norton theorem.…

Q: 5.6 ΚΩ IR www 8 mA 2.2 ΚΩ 16 V Fig-2- Find (IR) through resistor R = 2 k ohm.using Norton's theorem…

A: Norton’s theorem- Norton’s theorem states that any two output terminals of an active linear network…

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.