Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. 5 1 L=h, R = 10, C= = f, E(t) 600 V, q(0) = 0 C, i(0) = 0 A 3 30 q(t) = -20e (cos(3t) + sin(3t)) +20 i(t) = 120e sin (3t) C Find the maximum charge on the capacitor. (Round your answer to three decimal places.) 33.333 X с

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?

An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.

The figure below shows a simple RC circuit with a 3.30-μF capacitor, a 4.40-M resistor, a 9.00-V emf, and a switch. What are the following exactly 9.00 s after the switch is closed? (a) the charge on the capacitor 13.7204 UC (b) the current in the resistor 0.0110522 x Your response is off by a multiple of ten. HA (c) the rate at which the capacitor is storing energy μW (d) the rate at which the battery is delivering energy μW

Shown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 11.80 Volts and is running at a frequency of f = 147000 Hz. The resistor has a resistance of R = 3910 Ω, the capacitor has a capacitance of C = 4.01e-10 Farads, and the inductor has an inductance of L = 5.97e-03 Henries.Write the FORMULA for the total impedance of the circuit Ztot =        Write the FORMULA for the phase of the total impedance of the circuit ?Ztot =        Determine the numerical value of Ztot =  ΩDetermine the numerical value of ?Ztot =  degreesDetermine the current through the circuit: I(PEAK) =  Amps I(RMS) =  Amps Determine the voltage across the inductor: VL(PEAK) =  Volts VL(RMS) =  Volts Determine the voltage across the capacitor: VC(PEAK) =  Volts VC(RMS) =  Volts If a second circuit were connected in parallel with the resistor, this circuit would be considered as: a high-pass filtera flux capacitor    a radio tunera phase…

Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. 5 L= -h, h, R = 10 , C = f, E(t) = 350 V, q(0) = 0 C, i(0) = 0 A 7 q(t) i(t) = = 1 70 e C₁cos 7t + C₂sin 7t -7. +5 -7e-7t. -7C₁sin 7t+7C₂cos 7t Read It X C A Find the maximum charge on the capacitor. (Round your answer to three decimal places.) 5.216 C Need Help?

Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. 5 - h, R = 10 , C = q(t) i(t) = L = 1 -f, E(t) = 1400 V, q(0) = 0 C, i(0) = 0 A 70 -20e-7t[cos (7)t + sin(7)t]+20) (280e-7tsin(7)t) A C Find the maximum charge on the capacitor. (Round your answer to three decimal places.) 20.865 X C

Use nodal analysis to determine current in the capacitor in the figure below. Choose the right answer.

The current through a 50 mH inductor is given below. Use Ohm’s Law to find the voltage. Convert to polar form, find the impedance and complete the math, then convert back to the waveform at i1 = 7.5sin(2500t – 20°) mA and i2 = 5.9sin(200t + 40°) mA