Find out the average current. The graph represents a piecewise function of current, \( i(t) \), over time, \( t \), measured in seconds. The current values are measured in amperes.### Description of the Graph:- **Time Interval 0 to 1 seconds:** - Current \( i(t) \) is 0 amperes.- **Time Interval 1 to 3 seconds:** - Current \( i(t) \) is 1.5 amperes.- **Time Interval 3 to 5 seconds:** - Current \( i(t) \) drops to -2.0 amperes.- **Time Interval 5 to 6 seconds:** - Current \( i(t) \) returns to 0 amperes.- **Time Interval 6 to 7 seconds:** - Current \( i(t) \) is 1.0 ampere.- **Time Interval 7 to 10 seconds:** - Current \( i(t) \) returns to 0 amperes.The graph depicts how current varies over a period of 10 seconds, demonstrating changes in current direction and magnitude.

The average current (Iav) can be computed in the following way: Iav=17∫07itdt--->(1) The integral…

Answered: Find out the average current.

Engineering

Electrical Engineering

Find out the average current.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 6. Discuss the difference between direct current and alternating current?

A: Current is flow of electrical charge These are of two type Dc current Ac current

Q: f. If the upper sphere fell down on ground by accident, and its shape became irregular with having…

A: Any charged particle produces an electric field. This electric field is directed from the positive…

Q: Choose the doping material that will cause silicon to become a p-type semiconductor. a. Se b. B c.…

Q: what is a negative temperature coefficient?

A: there are two type of temperature coefficient which is applicable to the resistors 1. positive…

Q: An energy meter connected to an immersion heater (resistive) operating on an AC 230 V, 50 Hz , AC…

A: Given- AC 230 V, 50 Hz, 2.3 units kWh single phase source, Time t=1 hour, Peak square wave source…

Q: What is the difference between alternating current (AC) and direct current (DC)?

A: Electricity is essential in modern civilization, powering a wide range of gadgets and processes. Its…

Q: What is the distance between adjacent minimum and maximum current in degrees?

A: We need to find out angle between adjacent maximum and minimum .

Q: Question 26 a) A sinewave is having a frequency of 60 Hz and instantaneous voltage of 150 Volts at…

Q: Q2 (a) Explain the generation of single phase alternating voltage. Illustrate with a diagram.

A: Introduction: Single phase AC (Alternating current) supply can be generated with single phase AC…

Q: Find the maximum value of a sinusoidal voltage with an effective value of 110 Volts.

Q: iii. Induced emf in the coil if the current fall from 3A to 1A a. 420V b. 620V c. 0.62V d. 0.42V

A: Put the given inductor value L and change in time

Q: 3. A 120-volt AC voltage is applied across a 20-ohm resistive load. Find values of current, max…

A: This question belongs to circuit theory . It is based on the concept of rms and average value for…

Q: For a system if the value of peak overshoot is 22 %, then the value of damping ratio Oi is

A: Peak over shoot pos = 22% = 0.22 Damping ratio Zeta

Q: 2-10 a. Draw the waveshape of a sinusoidal volt- age having a peak value of 200 V and a frequency of…

A: It is asked to draw the sinusoidal voltage waveform and to find its value at different times

Q: List three applications of electrical transformers.

A: Brief description : Transformers works based on the principle called electromagnetic induction and…

Q: Write down the Construction of an alternator with the help of diagram and write its Principle of…

A: Alternator is derived from ' alternating ' . Alternator is an electric generator which converts…

Q: a) A sinewave is having a frequency of 100 Hz and instantaneous value of 200 Volts at 1.1 milli…

Q: When will the VAR - hour meter disc rotate in one direction for a lagging current and in the…

A: In this question we need to choose a correct option

Q: sinewave is having a frequency of 50 Hz and taneous voltage of 200 Volts at 1.2 milli ds. Find:…

Q: h of the following load is Inductive in nature tor hontor

A: Water heater is a resistive load and uses heat produced by resistors to heat water.

Q: Can V curve be plotted for an alternator. If yes then what is the difference between V curve of an…

Q: 5. A welder machine operates automatically as follows : 30A current in 10 seconds, 20A in 10 sec.,…

A: In this question we will find RMS value of given waveform....

Q: How would you describ the flow of Alternating Circuit (AC) and Direct Current?

A: In direct current (DC), the electric charge (current) only flows in one direction and it is…

Q: Q#5 Draw for a full-wave fully-controlled bridge Rectifier with highly inductive load. i- Circuit…

A: In the given questions we need to design the circuit of signals phase full wave rectifier and it's…

Q: what is a difference between AC AND DC load line

A: Load line- Load line is a line which is drawn in a plot between current and voltage. It denotes the…

Q: list down all the AC and DC sources of power. Explain each source briefly.

A: AC and DC sources of power

Q: 1. A 6 ampere supply has a frequency of 25 Hz. Find the instantaneous value of current a. at 0.00530…

Q: b) Determine the instantaneous equation for the voltage waveform shown in figure, if Vp=100 Volts,…

Q: Describe the characteristic and operation of the meter movement in measuring alternating-current.…

A: The meter movement in an alternating current (AC) meter is a device that is used to measure AC…

Q: A wire carries a triangular wave current with a maximum value of 10 amperes. What is the RMS of the…

A: A wire carries a triangular wave current with a maximum value of 10 amperes. What is the RMS of the…

Q: Tell whether the ac resistance is higher than the dc or not.

A: The AC current follows the skin effect which means the current flows only from the outer side or the…

Q: a) A sinewave is having a frequency of 50 Hz and instantaneous value of 250 Volts at 1.1 milli…

Q: How is inductive reactance in alternating current circuits?

Q: The meter constant of a single phase 230 V, induction energy meter is 800 rev/ kWh. What will be the…

A: Given: For a single phase energy meter V=230 VI=20 Acosϕ=0.7 lagMeter constant=800 rev/kWh

Q: 7. What is the effective value of an AC sine wave current having a maximum value of 4 A peak? 8.…

Question

Find out the average current.

The graph represents a piecewise function of current, \( i(t) \), over time, \( t \), measured in seconds. The current values are measured in amperes.

### Description of the Graph:

- **Time Interval 0 to 1 seconds:**
- Current \( i(t) \) is 0 amperes.

- **Time Interval 1 to 3 seconds:**
- Current \( i(t) \) is 1.5 amperes.

- **Time Interval 3 to 5 seconds:**
- Current \( i(t) \) drops to -2.0 amperes.

- **Time Interval 5 to 6 seconds:**
- Current \( i(t) \) returns to 0 amperes.

- **Time Interval 6 to 7 seconds:**
- Current \( i(t) \) is 1.0 ampere.

- **Time Interval 7 to 10 seconds:**
- Current \( i(t) \) returns to 0 amperes.

The graph depicts how current varies over a period of 10 seconds, demonstrating changes in current direction and magnitude.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

a) A sinewave is having a frequency of 60 Hz and instantaneous voltage of 100 Volts at 1.5 milli seconds. Find: i) The maximum value of sinusoidal voltage waveform ii) The value of voltage at 2.1 milli seconds. b) An alternating voltage is given by v=300 sin(120TTT +0.25) volts. Find: (i) Peak Value of Voltage (ii) r.m.s Value of voltage (iii) Phase angle in degrees with respect to 300sin(120Ttt). (iv) The instantaneous value of voltage when t=0 (v) Draw the sine wave of 300sin(120tt).
In DC machines, used to collect and supply current to the external load circuit.
Short note on PV operated lightning and water pump
Why is it that alternating current is most advantageous for providing huge power over the direct current. Give brief explanation.
electrical machines Explain how the experiment is done by drawing the connection diagram of the alternator idle test.
Describe the difference between AC (alternating current) and DC (direct current). Use illustrations.
Draw a graph of current against time for two complete cycles of alternating current of peak value2 A and frequency 10 Hz. Label the axes and indicate correct scale of values on them.(Hin: youhave to calculate the time for one cycle in order to mark the x-axis)
A - Explain the symbols, operating principles and usage areas of the diodes given below. (Zener diode: photo diode: led diode: opto coupler) B- Draw the voltage trigger circuit and explain its operation. Explain how there is a difference between the voltage quadrant and the tripler
What is the market for electricity?