Find ig. Express your answer with the appropriate units. for Part A for Part Vndo for Part redo for Part A reset for Part A keyboard shortcuts for Part A help for Part A Value Units Submit Part B Request Answer Find the power dissipated in each resistor.

Q: 13. What are commonly used to perform two functions in a circuit? a. resistors b. rheostats c.…

A: Elements that perform two function in a circuit.

Q: Figure shows a chopper. The device S1 is the main switching device. S2 is the auxiliary commutation…

A: Given- Load current- Io=20 A, voltage V=200 V, Capacitance C=2μF, L=200 mH, To Find- The peak…

Q: A 1-m length of tungsten wire draws 5 A when connected across a battery. The wire is then cut into…

A: The tungsten wire will have resistance, the above circuit can be thought of as if a battery is…

Q: If you tested the system with a scan tool and you observed a diagnostic trouble codes DTC P0503 what…

A: The code P0503 means that the engine control mode has received a faulty signal voltage from the…

Q: If the voltage on pin A3 is 0.806V, what value will analogRead(A3) return from the ADC?

A: Take reference voltage Vref=5V and 10-bit ADC. By using 10bits we can able to represent data  in…

Q: Solve the following. Show complete solution, resistor combination and circuit transformation. Box…

A: In this question we need to find the total resistance and total current of the given circuit.

Q: Find IR2 in the following circuit: V = 37V, R₁ = 500, R₂ = 890, and R3 = 850. R1 R2 ww R3 IR2 =…

A:

Q: Using nodal analysis find the voltages across the resistors Rl and R2 as shown in Figure Q1(b)(ii).…

A:

Q: 79. Which of the following formulas can be used with Ohm's law to determine the amount of voltage…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: What can you determine about the circuit being tested based on what is displayed on the DMM?

A: Circuit shows three lamps, dome lamp, Lamp A and Lamp B are  connected in parallel and supplied…

Q: Given: VS1 = 18 volts | R1 = 6 kohm | R2 = 7 kohm | R3 = 3 kohm | R4 = 7 kohm What is VR2? The…

A:

Q: write a list at least 10 ideas for graduation project in renewable energy and 10 ideas in power.…

A: Producing electricity from fossil fuels with no greenhouse gas emissions while lowering some forms…

Q: etermine the LED “on” current for the circuit above. Assume the logic “on” voltage is 5 volts, VLED…

A: LED refers to Light emitting diode, they are used in different types of semiconductor devices, they…

Q: Figure 1 Figure 2 shows a multi-range scale that is used to measure small currents. When the…

A: Electrical devices are used for measuring electrical parameters. Current, voltage and power are…

Q: Q2. The purpose of ports declaration is * O to connect to internal signals O for connections to…

A: Port are declared to communicate with external devices

Q: Course: switchgear and protection I want answers very quickly please solve all parts and give me…

A: Solution: (A) Recovery voltage: The system voltage that appears across circuit breaker contacts…

Q: Question A differential protection scheme is shown below 400/1 80 A fooo I, 00000 F I₂ The…

A: Given- A differential protection scheme as shown. To Find- The percentage bias.

Q: For measuring a voltage of 230V, a five year old digital voltmeter is used and it shows a reading of…

A: If the meter has high precision, then the value should be accurate.

Q: 5. How much charge is represented by 4,600 electrons?

A: This question belongs to Circuit theory. It is based on the presence of charge on electron.

Q: For measuring a voltage of 230V. a five year old digital voltmeter is used and it shows a reading of…

A: For Measureing a voltage of 230V Five year old DVM reading 232.5V Then it's means?

Q: How many layers in the thyrestor? O a. Three layers. O b. Something else. Four ers

A:

Q: T The match will at 6pm. * kick off kick in get along go on kick about Fertile soil may be by…

A: 1) Option a- kick off  2)  Option e- Get along

Q: 1. Find Req for the given circuit. Req

A: The given circuit isWe need to determine the equivalent resistance, Req for the given circuit.

Q: V2 No R2 FRI V3 Is手R キRo No V. Rs 幸&

A:

Q: Green White 9. Red 2 Blue Gold -1 Orange 3 -2 Violet 7 Silver Find the value of an…

A:

Q: 18 R2 1K 5V D1 R1 1K Determine the current at LED, D2. (assume LED forward voltage is 2.1 volts) *

A:

Q: The figure open? to a battery. What is the total current drawn from the battery when the switch is…

A: In this question,  We need to determine the total current in the given circuit.  We know current I =…

Q: A fully-charged power bank with a full capacity of 100,000 mAH is used to supply a DC lamp of 12…

A:

Q: clearly label thorughout and circle answer, please show the answer providing a proof

A: Missing information: Question part _a

Q: Find i (00). Express your answer to three significant figures and include the appropriate units.…

A: The given circuit isWe need to findE. io(∞).F. iL(∞).H. vL(0−).I. vL(0+).

Q: Question. Design an inverting adder so that the output v, is related to the inputs v1, V2, V3, and…

A: Here,RF=100kΩk1=8k2=10Since op-amp is ideal∴ virtual ground circuit is validSo by V.G.C. =VI=VNI…

Q: What is VR2

A:

Q: Find Vo, l1 and l2. Write your answer with unit with space in between. Round off to 2 decimal…

A:

Q: Determine the thermal coefficient of resistance of copper at 50°C, then use this value to determine…

A:

Q: The current in the circuit in the followin figure is known to be i = B₁e 2000€ cos1500t + B₂e-2000t…

A: Given ,i=B1e-2000tcos1500t +B2e-2000tsin1500t for t>o C=80nF Initial voltage across…

Q: Can you explain part (b), how did you write the solution

A: It was answered using fourier transform properties.  Property used here is frequency shifting.

Q: Draw the resistor schematic symbol. What is the reason of the materials resistance in the circuit?…

A: In these question we have to give resistance symbol ,reason behind resistance and it's SI unit.

Q: VS1 A R1 R2 Given: VS1 = 12 volts | R1 = 7 kohm | R2 = 5 kohm | R3 = 6 kohm | R4 = 6 kohm What is…

A:

Q: Please answer it fast and complete! Note: Use 4 decimal places. The last answers are the ones to be…

A:

Q: What is the current value of i1 in the circuit given below?

A:

Q: please redesign this please. AND Gate. same switches, power supply but different layout. thank you

A: The logic circuit is given as

Q: In this lab, you will be using resistors of various nominal values. What are the 5-band colour codes…

A: Given resistor values are: 100 Ohm220 Ohm 390 Ohm 560 Ohm 1000 Ohm

Q: In which arm of Wheatstone bridge the variable resistor is connected for initial calibration? O a.…

A: we need to answer which arm of Wheatstone bridge the variable resistor is connected for initial…

Wheatstone Bridge Method

A Wheatstone bridge is a circuit used to measure unknown resistance by measuring the ratios of the two branches of the circuit such that each branch has two resistance and out of four resistance one is unknown. The two branches are joined in between with the help of galvanometer which is used to determine the direction of the current. The main advantage of this circuit is that it can provide the most accurate measurement (different from a simple voltage separator).