Find 2₁, 22, and 23

Q: QUESTION 2 10 cos 2t V + R www C io + 6 sin 21 V For the circuit shown above, what is the amplitude…

A:

Q: A three-phase 1MW AC-DC converter is to be connected to a 2.4kVLL/60Hz AC bus that presents a 200uH…

A: It is given that:- P3ϕ = 1 MW VLL = 2.4 KV L =  200 μH/phase f = 60 Hz

Q: A three-phase 1MW AC-DC converter is to be connected to a 2.4kVLL/60Hz AC bus that presents a 200uH…

A: Given data: Three phase system Power of the three phase AC-DC converter, P=1 MW=1×106 W Line to Line…

Q: A PCM communication system has 4 codewords: 00, 01, 10, 11; the first two are for positive voltages,…

A: Given,The 4 codewords of the system are:00, 01, 10, 11The gap between codewords is 1 Volt.At t=0,…

Q: 12. An AM radio receives no station above 900 kHz. What is the likely problem? a) b) No input to the…

A: Solution of question (12): Given statement is "an AM radio receives no station above 900 kHz". Four…

Q: k 21 -1₁- -√3- 23 kat क Y ₂ Z2 I. Considering the circuit given above: Given: Z₁: R-L with R = 23…

A:

Q: 16. A signal given by m(t) = 3cos(207x10³t) frequency modulates a 1MHz carrier signal to produce a…

A: We need to find out modulation index and time domain expression and bandwidth for frequency…

Q: |2. If p(t) = cos @¸t and the spectrum of r(t) is given as R(jo) = S(jo-«) + ½ S(jo+w), (1) Find the…

A: Given: pt=cosω0t and Rjω=Sjω-ω0+Sjω+ω02.

Q: A 4-pole, 3-phase, 50 Hz induction motor runs at 1440 rev/min at full load. Calculate (a) the…

A: As per your question, it is asked why did we divide by 60 and where does the formula come in the…

Q: dy(x) 1. A causal LTI system is described by the following differential equation: 4- dt (1)…

A: Given: Difference equation, 4dy(t)dt+2y(t)=x(t), To find: a) Impulse response h(t), b) Based on…

Q: 3. Find the complex exponential Fourier series for the following signals. the magnitude and phase…

A: We need to find out Fourier series coefficient for given signal .

Q: Q2 Having the difference equation for a 1st order system as y(k)=0.6y (k-1)+0.4 u(k-1) and assuming…

A:

Q: DC power supply converts AC signal into DC signal. A complete DC power supply block diagram has the…

A: Transformer: A transformer changes the AC mains (line) voltage to a required value and it is used…

Q: A power spectral density has a roughly Gaussian shape for which the mean is at 10000Hz and the…

A: According to the question, Gaussian shaped power spectral density has mean at 10000 Hz. The standard…

Q: Find the value of K for the system given below that will place the closed-loop poles as shown.

A: The value of K can be calculated by calculating the closed loop transfer function and then solve for…

Q: 2/0° A www RΩ jΒΩ mm + V Χ -jΑΩ (1) 3/45° Α Α For the circuit shown above, what is the magnitude of…

A: KCL stands for Kirchhoff's Current Law. Node is a point of connection  between two branch element.…

Q: draw a circuit digram of impulse voltage measurement ??

A: Introduction: The term "impulse voltage" refers to a voltage wave that rapidly rises to a maximum…

Q: Question 9 Consider the ODE - 2x (1) + 6x (1) -4u (t) = 0 as well as a consequent output equation…

A:

Q: F = A'BC + A'C + A'C'D + BD'E' + A'C'E' Simplify the function F using a. K-Map b. Quin-McClosky…

A:

Q: What peak-to-peak value of ac sine wave would do the same work as 50 Vdc? Oscilloscope can display…

A:

Q: A LAB Β Determine the impedance of the network at the terminals A–B. -j2 Ω ΠΩ 4Ω Μ 12 Ω 202 ΣΩ

A:

Q: The voltage across and the current through a load are expressed as follows v(t)=-170 sin (377 t-V…

A: We need to find out the power for given current and voltage .

Q: 6. For the circuit given below, a) Write Nodal equations and determine Nodal Voltages V₁ and V₂. b)…

A: Given: To find: a) Nodal equations for and node voltages. b) Current through all resistors.

Q: A 3-phase 4-pole alternator has 48 stator slots carrying the 3-phase distributed winding. Each coil…

A: Given- 3-phase, 4-pole alternator, 48 stator slots, 3-phase distributed winding, To Find- The…

Q: A circuit element has an impedance of 28 Z-58° mo when the frequency is 276 Hz. What is the…

A:

Q: Op-amp power gain The power gain G of an amplifier is defined to be the power delivered to the load…

A: Given, The power gain G of an amplifier is defined to be the power delivered to the load RL divided…

Q: please create a Comment on the Results as shown in the  Picture of Output Characteristic Curve of…

A:

Q: iv. V. The atom that has acquired the extra electron is called a: a) Silicon atom b) Germanium atom…

A:

Q: 2 ohm ww 1 ohm 3 ohm ? Calculate the total current in the circuit 4 ohm ww 5 ohm 120 V

A: Given data, Circuit diagram is given as,

Q: Question 4 A circuit element has an impedance of 21 244° m2 when the frequency is 139 Hz. What is…

A: Given, Impedance of an circuit element, Z = 21∠44° m ohm. Frequency (f) = 139 Hz We need to…

Q: A 0.4 amp solar light in a city park will be installed 328 feet away from the solar PV power source.…

A:

Q: Express the following phasors as single cosine function in the time domain if the frequency f is…

A: The required representation can be obtained by converting the given signal into polar form and then…

Q: Suppose a PMOS transistor must conduct a cur- rent ID = 0.5 A with VSD ≤ 0.1 V when it is on. What…

A: Given data,  ID=0.5 AVDS≤0.1 VVG=0 VVS=10 VVTP=-2 V

Q: Question 2 What is the amplitude of the following sinusoidal voltage signal v(t) = 121 cos (102t +…

A: We need to find out the magnitude of given waveform.

Q: Question 17 A circuit element has an impedance of 26 Z-25° m2 when the frequency is 180 Hz. What is…

A:

Q: 7.1) Determine the Q point of the transistor circuit shown in Figure(i). Also draw the DC load line.…

A: The required parameters can be obtained by using DC analysis of the amplifier circuit.

Q: 4. Using the definition, obtain Fourier transforms of the following signals (a > 0) (a) x(t) =…

A:

Q: Using the impedance method, find vo(t). 602 M 20 cos ( 4t-15° ) 10mF 5H + vo (t) -

A:

Q: 1. Calculate the torque in pound-feet developed by a dc motor, given the following particulars: pole…

A:

Q: 4- Discuss how the voltage gain of the tuned amplifier can be increased. 5- What resistance is…

A: "Since you have asked multiple questions, we will solve the first  question for you. If you want any…

Q: Q1. For the system shown in Figure Q1, draw an impedance diagram in per unit, by choosing 100 kVA to…

A:

Q: Question # 1: Implement the compensators shown below. Choose a passive realization if possible. (s +…

A: The given transfer functions of the compensators/controllers are shown below. (i) Gcs=s+0.1s+5s.…

Q: Consider the following digital logic function F(A, B, C, D,E): F = A'BC + A'C + A'C'D + BD'E' +…

A:

Q: Find v(t) in volts, one time constant after time to: Is = 3.9 A, R₁=478 , R₂-966, C₁-202 mF, C₂-266…

A: Given: Is=3.9 A, R1=478 Ω, C1=202 mF, C2=266 mF To find: V(t) in volts after one time constant from…

Q: 15. A modulated signal is given by s(t)=[10+ 8 cos(2 × 10³t) + 6cos(47 × 10³t) cos(2π × 105t) a)…

A:

Q: 2. Let y(t)- t for 0 <t<0.25 and assume y(t) has period T-0.25. (a) Find the Fourier series…

A:

Q: RC Circu Each circuit below consists of a battery, a capacitor and uncharged. Determine the voltage…

A:

Q: 7. If the carrier is reduced in amplitude the resulting signal is referred to as: a) independent…

A: This problem is related to communication system. The DSB-SC is also known as explained in next step.

Q: 2. Bulbs A to E have equal value of resistances, which bulb will produce the brightest light. Defend…

A: We need to find out the brightest bulb ,  We will find out current through each bulb for brightness…

Q: Q2: Draw the root locus for the system shown in Fig.: R+ k(s+2) S+3 s(s+1)

A: