F = 2 ( 0 ₁ 1 ₂ 3 ₂ 4 ₂ 8,9,15) 2 16 to 1 Mux

Q: For the circuit shown in figure (3), determine the current and voltage for the resistor R3 using the…

A: We need to find out current and voltage for given circuit

Q: Maximum dimension of antenna is 0.5m and operating frequency is 9 GHz, thus the the following…

A:

Q: Q.2 Choose the correct answer 1- A collision avoidance system uses. to detect a vehicle or another…

A: Choose the correct answer of the following questions : 1- A collision avoidance system uses…

Q: c) Draw the block diagram of delta modulation with a brief explanation of this modulation techniques

A: Delta modulation is a Differential Pulse Code modulation (DPCM) technique in which the difference…

Q: Compared between three_ phase induction generator and synchronous them at impedance field and EMF…

A:

Q: a) Draw clearly the block diagrams of the coherent and non- coherent detectors that can be used to…

A: a.  coherent detection the same network signal (used to generate a DSBSC signal) is used to receive…

Q: The gray code has the property of when going from any number to the next only one bit is flip O none…

A: We need to select correct property of gray code .

Q: Exercise: Find the closed-loop transfer function for the following block diagram: R(s) E(S) Y(s)…

A: Given block diagram:

Q: Q19/ Point charges of 4x10-5 C and 6 x10-6 Care located at points A(1,3,4) and B(4,0,4),…

A:

Q: A GSM1800 cell tower antenna is transmitting 20W of power in the Frequency range of 1840 to 1845MHz.…

A:

Q: 0404040 0000 K x(1) f(1

A: We need to find out transfer function for given system

Q: A 6 KVA, 100 V/500 V, single-phase transformer has a secondary terminal voltage of 487.5 V when…

A:

Q: I Find the current value for the resistance (4 ohm) using mesh (loop) method or nodal method. All…

A: The mesh equation can be obtained by applying kirchhoff's voltage law to the meshes and then by…

Q: b. Design a circuit using operational amplifier to implement the following: d = [x₁ x1 dt - 0.5 x2-…

A:

Q: In a 4-bit magnitude comparator with first input A= 1101 and second input B=1110, the output

A:

Q: A J-K flip-flop with J = 1 and K = 1 has a 20 kHz clock input. The Q output is Constantly HIGH O…

A: We know that flip flop gives the output at the edge i.e flip flops are edge triggered. They may be…

Q: [Ex] Consider R(3) + 1 the following control system + 1 K 0 / ² + →>> f 1) Find the steady state…

A:

Q: Using superposition theorem find the output voltage Vo for the circuit below. All resistances in…

A: Given circuit :

Q: we might have a picnic tomorrow.it depends ....... The weather.

A: ans:(b) on

Q: the extension of python module is

A: ans:(c) .py

Q: the simplest way Determine the y parameters for the two-port shown in Fig. 19.17. JAS ditip 21 4Ω…

A:

Q: -2π -TT ↑f(t) sint TC 2TT t

A:

Q: 73 I If a microprocessor can perform 4 million. instructions per second, how mary nanoseconds are…

A:

Q: Displacement current is taken to be negligible (compared to the conduction current) if ...........…

A: In this questions, we need to calculate when conduction current will dominate displacement current.…

Q: E6.24 Consider the system represented in state variable form x = Ax + Bu y = Cx + Du, where 0 1 0 […

A:

Q: a. The AC system used instead of DC system in power transmission in o possible to: 1) Reduce the…

A:

Q: AJ-K flip-flop with J = 1 and K = 1 has a 20 kHz clock input. The Q output is Constantly HIGH…

A: We need to select correct option for j k flip flop output

Q: A fluid system has two sensors, a pressure sensor and a flow sensor. The pressure sensor has two…

A: There are two sensors in the Given Fluid system: a. Pressure Sensor. b. Flow Sensor. The pressure…

Q: In this parallel-plate capacitor, the distance d between the plates is 3cm, the radius of the plates…

A: Given, Distance between the plates, d=3 cm Radius of plates, r=2 cm Relative permittivity, εr=1…

Q: In the transverse electromagnetic ......,TEM mode Ez = 0, Hz #0 O Ez # 0, Hz = 0 O Ez = 0, Hz =0 O…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: For the circuit shown. Find R₁, R₂, R3 so that Z₁=2.5K₁2² 2₁2= Z₂₁1 = 1.25 K Z22= 3.125 K R₁ R₂ AM…

A: Given data :             Z11=2.5kΩZ12=Z21=1.25kΩZ22=3.125kΩ

Q: Q5 Using superposition theorem find the output voltage Vo for the circuit below. All resistances in…

A: When there is more than one source is available in the circuit, then we can use superposition…

Q: A 50 Hz, 1-phase transformer has a turn ratio of 6. The resistances are 0.9 ohm and 0.03 ohm and…

A:

Q: Home work: Q1] Two resistors must be selected so that the current in one is four times the current…

A: We need to find out value of resistance.

Q: Using superposition theorem find the output voltage Vo for the circuit below. All resistances in…

A: Given circuit:-

Q: c) Draw the block diagram of delta modulation with a brief explanation of this modulation techniques

A: Delta modulation technique: Delta modulation is a method that is mostly used to transmit speech…

Q: A silicon diode has reverse saturation current of 2.5 μA at 300 k . Find forward voltage for a…

A: Given data : reverse saturation current is=2.5mA For silicon diode VT=25.9mV Absolute temperature…

Q: The progressive phase shift k =180, the direction of the main beam eo for a uniform linear array…

A: Given: progressive phase shift k = 180°  To find the Direction of main beam θo for an uniform linear…

Q: 4. In smith chart, moving in the clockwise direction means moving. a) From load to generator b) From…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 3. By means of full adder block diagram, design a Logic circuit which subtracts two numbers using…

A:

Q: There are different states in a 4-bit Johnson counter 8 none of the mentioned 4 O 3 O

A: In this questions we need to find the no. Of possible different state in 4 bit Johnson counter.

Q: 4- What is form factor and peak factor? 5- When do we get maximum energy from a set of capacitors?…

A: We have to define form factor and peak factor.

Q: Problem 4: Find Zth, (Z-Thevenin) for the following circuit j20 12 1052 wwww 50/30° V >10 Ω

A: Given circuit:

Q: the initial content of a 3- bit ripple down counter is 000. After the first clock gger, the counter…

A:

Q: List the reasons why the modulation is desired in a wireless communication system considering the…

A: Modulation is a technique that is used in carrier wave to transmit some information at low…

Q: 1- Determine the values of x, and y (5x+j10)(2-jy) = 90-170 2- At steady state, what is the current…

A:

Q: b) For the Circuit shown the switch has been in position for along time, at t-o the switch is moved…

A: This question belongs to circuit theory . It is based on the concept of transient and steady state…

Q: Q11/ Operational amplifier with a bandwidth of 3.5MHz has input resistance 3k0. The noise voltage at…

A: To find the noise voltage at the input of the amplifier operated at 25° C  Bandwidth, B = 3.5 MHz…

Q: Find the Thevenin equivalent circuit for the network below of variable resistance. Then find the…

A: Thevenin's theorem states that any network containing linear and bidirectional elements and…

Q: Question 10. State-space (a) Write the state equations for the system below, using the indicated…

A:

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.