Explain the function of a programmer-defined break point.

Does the amount of time it takes to move between contexts have any effect on how long it takes for an interrupt to be processed?

Determine the type of System interrupt. When the following Java code is run: int x = 1; int y = 17; int z = y/--x; not able to determine user trap/exception

Exactly what does it mean when you talk about a "interrupt service routine"?

What does it indicate if the time required to switch contexts depends on the duration of an interrupt?

Q2. [Structural Verilog] Design a 2-bit subtractor unit. Inputs are A and B, and output is S, 2-bits each. As a sub-module you can call the Full Adder module (E Assume this is given to you as library) which takes in 3 inputs (X, Y and Z) and produces 2 outputs (F, C). Write structural HDL

Briefly explain just-in-time compilation

Example: The Problem Input File Using C programming language write a program that simulates a variant of the Tiny Machine Architecture. In this implementation memory (RAM) is split into Instruction Memory (IM) and Data Memory (DM). Your code must implement the basic instruction set architecture (ISA) of the Tiny Machine Architecture: //IN 5 //OUT 7 //STORE O //IN 5 //OUT 7 //STORE 1 //LOAD O //SUB 1 55 67 30 55 67 1 LOAD 2- ADD 3> STORE 4> SUB 5> IN 6> OUT 7> END 8> JMP 9> SKIPZ 31 10 41 30 //STORE O 67 //OUT 7 11 /LOAD 1 //OUT 7 //END 67 70 Output Specifications Each piece of the architecture must be accurately represented in your code (Instruction Register, Program Counter, Memory Address Registers, Instruction Memory, Data Memory, Memory Data Registers, and Accumulator). Data Memory will be represented by an integer array. Your Program Counter will begin pointing to the first instruction of the program. Your simulator should provide output according to the input file. Along with…

If you want to hook and chain a FIQ interrupt method, the method's execution has to start at the supplied offset in the Interrupt Vector Table.

Based on the Tinkercad circuit accessible from the link below, complete the following activities:https://www.tinkercad.com/things/c1qtxCkOuBW   Code is, // C++ code// const byte LED_PIN = 13;const byte METER_PIN = A4; void setup(){  pinMode(LED_PIN, OUTPUT);  pinMode(METER_PIN, INPUT);        Serial.begin(9600);    startTimer();} void loop(){ }   void startTimer(){  noInterrupts();        interrupts();} ISR(TIMER1_COMPA_vect){   digitalWrite(LED_PIN, digitalRead(LED_PIN) ^ 1);}   1. Complete the code in a way that LED blinks every 2 seconds.2. Change the startTimer method to accept a double value called timerFrequency, which representsthe frequency of the timer. Change the startTimer function so that it uses the value of this parameterto calculate and set the correct values for the OCRx and TCCRx registers.3. Use the potentiometer sensor connect to pin A4 to enable users to configure the timer frequency. Plsease share the final code only.